An airplane is climbing 90m/s, propeller-driven and with brake horsepower of 2250 kW. Given also the weight is equal to 160kN, wing area equal to 40m², propulsive efficiency of 87% and drag equation as: Cp = 0.014 + 0.05C,² Find the:

An airplane is climbing 90m/s, propeller-driven and with brake horsepower of 2250 kW. Given also the weight is equal to 160kN, wing area equal to 40m², propulsive efficiency of 87% and drag equation as: Cp = 0.014 + 0.05C,² Find the:

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Aerodynamic Model: - Circular Disk Inside Dia= 40 mm Outside Dia= 80 mm • Angle of Attack= 15 Degree • Lift Force= 0.38 N • Drag Force=0.40 N • Wind Velocity= 20 m/sec Air Temperature= 30 °C (Note: Take Air Density at 30 °C) Required: - Find Lift and Drag Coefficient at 15 Degree Attack Angle.
5.25 A finite wing of area 1.5 ft² and aspect ratio of 6 is tested in a subsonic wind tunnel at a velocity of 130 ft/s at standard sea-level conditions. At an angle of attack of -1°, the measured lift and drag are 0 and 0.181 lb. respectively. At an angle of attack of 2°. the lift and drag are measured as 5.0 and 0.23 lb, respectively. Calculate the span efficiency factor and the infinite-wing lift slope.
/Aircraft Cessna Cj-1 in climb stage, Climbing with anglé of attack equal to 8°. Cj-1 has the following data Weight =2038.75 kg Wing area = 50 m2 CDo = 0.018 aspect ratio =7 Aircraft speed in elimbing 25m/s e = 0.75 p at 300, m = 0.909 And the variation of angle of attack with lift coefficient 1.3 shown in figure. 1.6 14 Calculate . 12 I. the thrust and power required for climbing to high C 10- 3000 m II. Climbing rate 04 8 30 Angle of ata
Assume that the Flettner rotor ship of Fig. has a waterresistance coefficient of 0.005. How fast will the shipsail in seawater at 20°C in a 20-ft/s wind if the keel alignsitself with the resultant force on the rotors? [Hint: This is aproblem in relative velocities.]
A delivery vehicle carries a long sign on top, as in Fig.. If the sign is very thin and the vehicle moves at65 mi/h, (a) estimate the force on the sign with no crosswindand (b) discuss the effect of a crosswind.
A ship is 125 m long and has a wetted area of 3500 m2.Its propellers can deliver a maximum power of 1.1 MWto seawater at 20°C. If all drag is due to friction, estimatethe maximum ship speed, in kn.
Suppose a reactor producing exhaust gas that is being transferred to the next building by a 6 mm diameter and 20 m long uninsulated pipe for testing. The exhaust gas enters the pipe at 200 °C with a low rate of 0.003 kg/s. You can assume that the pipe is thin. It’s spring outside and wind is blowing at 5 m/s, while the outside temperature is 15 °C (59 °F). Properties of gas (assume, air) inside of the pipe (assume, Tm = 380 K, 1 atm): cp = 1012 J/kg⋅K, k = 0.0323 W/m⋅K, μ = 221.6 × 10-7 N⋅s/m2, Pr = 0.694; Properties of air outside: Air (assume, Tavg = 340 K, 1 atm): k = 0.0253 W/m⋅K, α = k/ρcp = 2.99x10‒5 m2/s, ν = 14.82 × 10-6 m2/s, Pr = 0.710, β = 1/Tavg Find ReD and GrD outside of the pipe and determine whether it is free or forced convection Estimate heat transfer coefficient for outside air Is it a fully-developed flow inside of the pipe? Or, it is not relevant here. Estimate heat transfer co-efficient for the inside air Find overall heat transfer coefficient Find…
Folsim calculates the aerodynamic forces using the ideal flow model that neglects viscous and compressibility effects. Is this suitable for low Re simulations.
Ign, McGraw-Hill, this chapter) and by New York, 1999, for more information. EXAMPLE 6.18 Estimate the landing ground roll distance at sea level for the CJ-1. No thrust reversal = 0. The spoilers increase the zero-lift, used; however, spoilers are employed such that L drag coefficient by 10 percent. The fuel tanks are essentially empty, so neglect the wejehr of any fuel carried by the airplane. The maximum lift coefficient, with flaps fully em ployed at touchdown, is 2.5.
QH03: Aerodynamic Model: - Circular Disk Page 1 o Inside Dia = 40 mm Outside Dia = 80 mm • Angle of Attack= 15 Degree • Lift Force= 0.38 N • Drag Force=0.40 N • Wind Velocity= 20 m/sec • Air Temperature= 30 C (Note: Take Air Density at 30 C) Required: - Find Lift and Drag Coefficient at 15 Degree Attack Angle.
A power plant continuously releases from a 70-m stack a plume into the ambient atmosphere of temperature 298 k. The stack has a diameter 5m, the exit velocity is 25 m s^-1, and the exit temperature is 398 K. For neutral conditions and a 20 km h^-1 wind, how high above the stack is the plume 200 m downwind? (If you could please explain for you steps when you do it, that would be awesome. :) )
1. Consider an light plane aircraft with a characteristic of:Wing area = 181 ft2Aspect ratio = 6.2Oswald efficiency = 0.91Weight = 3000lb Zero lift drag coefficient = 0.027Powerplant = single piston engine of 345 hp maximum at sea level Propeller efficiency = 0.83Calculate the:a) Power required at sea level at 100ft/sb) Power required at 12,000ft altitude at 100ft/sc) Minimum power required d) Power available at 100m/s From the aircraft characteristic above, and maximum rate of climb at sea level of 550ft/min Calculate the:a) rate of climb at 12,000ft altitude b) time to climb at 12,000ft altitude c) power excess at 12,000ft altitude