Answered: An access point's radios support two RF…

Engineering

Computer Science

An access point's radios support two RF bands with six spatial streams each. This access point has how many antennas?

Systems Architecture

7th Edition

ISBN:9781305080195

Author:Stephen D. Burd

Publisher:Stephen D. Burd

Chapter8: Data And Network Communication Technology

Section: Chapter Questions

Problem 27VE

See similar textbooks

Related questions

Q: What mode and tunnel mode? is the difference between

A: The difference is an given below :

Q: Data communication In a system with a bit rate of 3Mbps ,it is desired to send 3 bits at once…

A: In this question we have to solve for the given data. Calculate the levels, baud rate and bandwidth…

Q: Explain the ARP procedure that occurs when a frame is sent.

A: ARP (Address Resolution Protocol ) is a network protocol used to distinguish a device's hardware…

Q: Prim's MST uses a weighted network.

A: Prim's algorithm gives connected component as well as it works only on connected graph.

Q: ser printer can print 60 lines of 75 characters per page. The average character occupies a box 2 mm…

A: Answer:- Each line has C = 80 charactersEach page contains L = 50 linesTherefore the number of…

Q: The electrical connection is considered to have a parallel interface when it can transmit eight or…

A: Parallel Interface: A multiline channel which can be able to send multiple bits of data…

Q: If eight or more bits of information may be sent across the electrical connection concurrently, we…

A: Here is your solution -

Q: A flash memory of 16 Gbyte is used to store PCM voice data. Suppose that a CT voice signal is…

A: How many minutes of the voice signal can be stored (as PCM data) in this memory? For 12-bit, we…

Q: When an electrical connection can send and receive eight or more bits of data concurrently, it is…

A: In computing, data is transferred between different components of a system using various types of…

Q: If the signal at the end of a 6km cable has a power value of 2, if you knew that this cable loses…

A: Given length=6km loss=0.5dB/km

Q: When the mobile is moving in the direction of signal source with speed = 120 km/hour and the carrier…

A: The bandwidth of the signla u1c1 is 20khz

Q: omputer Science how to connect a computer network in a building to another building in another city…

A: A WAN covers an enormous topographical region. Most WANs are produced using a few LANs associated…

Q: In a typical mobile phone system with hexagonal cells, it is forbidden to reuse a frequency band in…

A: Consider that a typical mobile system is designed with hexagon cells and it is available with 840…

Q: Еxample: A telephone line has a bandwidth of 3000. The signal-to-noise ratio is usually 3162. For…

A: The formula for channel capacity is c=wlog2(1+s/n) s/n is signal to noise ratio and w is the…

Q: The Modem is the most well-known kind of Data Communication Equipment. It modulates an analog…

A: Introduction: A modem is a physical device that translates digital data into a transmission medium…

Q: On the textbox below, write your stand on the given facts and question: Facts: There are two…

A: Solving a complex circuit involves lots of analysis to determine whether the circuit is series or…

Q: The horizontal sweep oscillator frequency, vertical sweep circuit frequency and the spectrum…

A: A sweep generator is a piece of electronic test equipment similar to, and sometimes included on, a…

Q: Q1/The impedance of the basic A.C bridge are given as follows: Zz = 2504 75° (inductive impedance),…

A: Lets see the solution in the next steps

Q: An image is 1690 × 900 pixels with 3 bytes/pixel. Assume the image is uncompressed. How long does it…

A: Compute required data transmission time: The size of the image is 1690* 900 pixels with 3…

Q: A radio for each of the two RF bands that are supported by an access point's radios has a total of…

A: Given: 2 RF bands and each band has 6 spatial streams of the radio.

Q: optic cable

A: Given :- A fiber optic cable has a loss of 16 dB per kilometer and a cable length is 2,000 feet…

Q: Suppose a signal travels through a transmission medium and its power is reduced to one-half. What…

Q: An image is 1600 × 1200 pixels with 3 bytes/pixel. Assume the image is uncompressed. How long does…

A: Pixel is small unit of a digital image. It represents in 2-D grid. A lot of pixels together can make…

Q: We would like to design a bandpass filter in a DSP system which attenuates a signal outside the…

A: (a). This is because the maximum bandwidth for any input signal is 5000 Hz, and the Nyquist theorem…

Q: A flooded frame's destination address is frequently unclear

A: An ARP request is used to determine the target host's MAC address on an Ethernet LAN. A switch will…

Q: An analog signal in sine form is intended to be transmitted to the receiver by pulse code…

A: Given, peak to peak amplitude = xxx volts. Frequency of signal = xxx Hz Medium Height = xxx level…

Q: Now suppose you have a composite signal (composed of many frequencies). If the frequencies range…

Q: Consider a communication channel with bandwidth B = 8000 Hz. Suppose the channel has a…

Q: A digital radio communication system receives a signal with signal power S of 3 µW, and noise level…

A: Given signal power S = 3 µW noise level N = 200 nW

Q: Show that if an = 5n3 - 14n2 + 7n - 3, then an = Θ(n3). (big theta notation)

A: Introduction: It is defined as having the tightest bound, and the tightest bound is the best of all…

Question

An access point's radios support two RF bands with six spatial streams each.
This access point has how many antennas?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, computer-science and related others by exploring similar questions and additional content below.

Similar questions

A radio has six spatial streams for each of the two RF bands supported by an access point's radios. What is the total number of antennas present in this access point?
When a light ray passes from a layer with index n1 1.5 to an adjacent layer with index n2, the ray deviates 10 from its initial direction as shown below. If the angle of incidence is 01 30, then determine the value of the index n2. 12 713 O 02 = 1.48 02 1.17 O n2 = 1.05 n2 = 1.26 n2 = 1.37
My id last two digit =32 so x1x2=32 Subject:Datacommunication
In a typical mobile phone system with hexagonal cells, it is forbidden to reuse a frequency band in an adjacent cell. If 840 frequencies are available, how many can be used in a given cell?
A fiber optic cable has a loss of 16 dB per kilometer. What would be its attenuation if the cable is 2,000 feet long?
In the world of data communication, the most well-known kind of equipment is the modem A carrier signal is modulated and demodulated in order to decipher the digital information that has been transmitted. It is necessary to generate a signal that can easily be transmitted and decoded in order to reproduce the original digital data in this manner. Explain briefly how the modem achieves these goals.
A flash memory of 16 Gbyte is used to store PCM voice data. Suppose that a CT voice signal is sampled at 20 kHz, and each sample is encoded into an 12-bit. How many minutes of the voice signal can be stored (as PCM data) in this memory? If the sampling frequency is doubled, what its impact on storing time? Analyze mathematically
Here, we define a guard band and discuss its function.
A television reciever used for receiving TV signals from a satellite. The specifications of the reciever are given below. Calculate the carrier to noise ratio at the input of the reciever detector. Item Orbit Up-link freq. Down-link freq. EIRP Antenna Туре Noise temperature Feedline gain (Losses) LNA Noise temperature Gain Reciever noise temperature IF bandwidth Parameter value Geostationary 6 GHz 4 GHz 36 dBW 10m diameter parabolic dish 32K 0.98 (ratio) 40K 50 dB 2610 K 30 MHz
Q1/The impedance of the basic A.C bridge are given as follows: Zz= 250275° (inductive impedance), Zz =2002, Z3 = 50045° (inductive impedance), Z4 = unknown ?
A digital radio communication system receives a signal with signal power Sof 3 µW, and noise level of 200 nW, on a radio channel with upper cut-offfrequency of 2.42 GHz, and a lower cut-of frequency of 2.40GHz. . What is the signal to noise ratio in decibel?
Consider a communication channel with bandwidth B = 8000 Hz. Suppose the channel has a signal-to-noise ratio S/N = 541. What is the maximum data rate of this channel? ? What is the minimum number of signal levels needed to achieve a data rate of 64000 bps?