amount. Example 10.4 A direct-FM transmitter has a varactor modulator with k+ = 2 kHz/V and a maximum deviation of 300 Hz. This modulator is followed by a buffer and three stages of frequency multiplication: a tripler, a doubler, and another tripler, followed by a driver and power amplifier. 1) Draw a block diagram of this transmitter. 2) Will this transmitter be capable of 5 kHz deviation at the output? 3) What should the oscillator frequency be if the transmitter is to operate at a carrier frequency of 150 MHz? 4) What audio voltage will be required at the modulator input to obtain full deviation?

amount. Example 10.4 A direct-FM transmitter has a varactor modulator with k+ = 2 kHz/V and a maximum deviation of 300 Hz. This modulator is followed by a buffer and three stages of frequency multiplication: a tripler, a doubler, and another tripler, followed by a driver and power amplifier. 1) Draw a block diagram of this transmitter. 2) Will this transmitter be capable of 5 kHz deviation at the output? 3) What should the oscillator frequency be if the transmitter is to operate at a carrier frequency of 150 MHz? 4) What audio voltage will be required at the modulator input to obtain full deviation?

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Good day! Question: What is the importance of Modulator and Demodulator (functions) in FM.
Subject: Circuits INote:Support the problems with circuit diagram and label the pertinent parts and also complete solution so that i can learn too
None
Given an input ac-voltage, v = 120 sin120πt, if the SCR Vbr is 100V, What is the fire delay angle? a. 35 degrees b. 56 degrees c. 67 degrees d. 83 degrees
In an AM signal with peak amplitude of 400 volts and a peak modulating voltage of 100 volts, what is the modulation factor? a.0.33 b.0.6 c.0.5 d.0.55
The modulation index of the PM signal is 2. If a modulating signal that has amplitude of 50 mV at a frequency of 3 kHz phase modulates a 90 kHz carrier signal, what would be the new modulation index of the signal? Assume that the amplitude of the modulating signal is increased by 50%.
Q. Suppose that you have an angle modulaton system with an input signal £01) s wiangle wave of fundamental frequency 5 kiz and its most power is concentrated in the frst third harmonics, the masimum and minimu voltage ae | and -1 espectively. where one period equation of theinput s o[BIl 0
Type your question here Determine the saving, in signal power, in the case of 50% modulated AM signal, if the carrier is suppressed before transmission.