Air is used as a working substance in a given internal combustion engine, which is supplied with heat at a constant volume. Based on the data, calculate the Pressure and temperature of the ending of isentropic expansion.

Air is used as a working substance in a given internal combustion engine, which is supplied with heat at a constant volume. Based on the data, calculate the Pressure and temperature of the ending of isentropic expansion.

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter1: Basic Modes Of Heat Transfer

Section: Chapter Questions

Problem 1.74P: A manufacturer in the United States wants to sell a refrigeration system to a customer in Germany....

See similar textbooks

Similar questions

The 7-kg sphere is projected horizontally with a velocity of 14 m/s against the 40-kg carriage which is backed up by the spring with stiffness of 1390 N/m. The carriage is initially at rest with the spring uncompressed. If the coefficient of restitution is 0.69, calculate the rebound velocity v', the rebound angle 8, and the maximum travel o of the carriage after impact. 7 kg Answers: 14 m/s k= 1390 N/m. 55⁰ 40 kg
Q2- Determine: A small solid at temperature of 85 °C is to be cooled in a cooling chamber maintained at 10 °C. 1- The time required for the temperature of the solid to reach 13 °C if the proportionality constant is a = 0.002/m² with a contacting surface area A = 0.2 m². 2- The temperature of the ball after 30 s. 3- The final temperature of the ball. Bulk environmental temperature = T₁ AZ Surface area, A- Solid T(t) Initial solid temperature, To
6kg 403g - 3 kg 779 g =
Half a liter of liquid is being heated in a closed container to prepare food. Initial temp is 25C and desired temperature is 85C. How much energy is needed to raise the temperature of this amount of water as described? Specific heat of water is given as 4.18 kJ/(kg.K)
The laptop consumed a total of 20 kW per month. This is equivalent to how many BTU/hr?
700 600 500 400 S 300 200 100 0.05 0.1 0.15 0.2 e S (MPa)
1.22 m 1. To avoid overheating, natural convection analysis is to be considered. If the minimum allowable heat transfer due to natural convection is 30 W, find the maximum angle at which the TV can hang off the wall (0 < 0 < 60). Some temperatures were collected; Back panel surface: 45 °C, ambient: 32 °C. A typical 55-inch TV screen measures (122 cm x 69 cm). Note: A typical screen uses a portion of the incoming energy to light up the LED panel, while the rest is dissipated as natural heat convection. 0.69 m
A liquid reactant solution is pumped through a pre-heater before entering a reaction vessel. The solution enters the pre-heater at 25 °C and must enter the reactor at 45 °C. The flow of the reactant solution is 1500 mL per minute. The density of the reactant solution is 0.91 g-cm3 and the heat capacity is 1.75 Jg1.K1. ASsume there is no heat loss in the pre-heater or between the pre-heater and the reactor. a. Draw a schematic of the pre-heater, detailing all mass and energy flows. b. Clearly define a system boundary. c. Write the general energy balance, and a simplified energy balance stating all assumptions that apply to this problem. d. What is the minimum power rating required for the pre-heater?
In a Heat engine, when T1 = 200 ° C and T2 = 0 ° C its efficiency is ni and when T1 = 0 ° C and T2 = -200 ° C. its efficiency is n2, then what is n1 / n2? A. 0.638 B. 0.733 C. Cannot be calculated D. 0.577
The answer should be the one on the second picture. Please show detailed solution for the answer.
The standard atmosphere in meters of gasoline (Y = 6660 N/m3) is nearest take Patm= 101300 N/m2 * O 24.9 m O 15.2 m O 18.3 m O 21.2 m A cubic meter of a liquid has a weight of 9800 N at a location where g = 9.79 m/s2. What is its weight at a location where g 9.83 m/s2? * O 9780 N O 9840 N O 9820 N O 9800 N The pressure at a point where the gage pressure is 70 cm of water is nearest take Patm =100 KPa. * O 169 kPa O 69 kPa O 107 kPa O 30 kPa Calculate the weight of a body that occupies 200 m3 if its specific volume is 10 m3/kg. * O 132 N O 196 N O 20 N O 921 N 10-kg body falls from rest, with negligible interaction with its Surroundings (no friction). Determine its velocity after it falls 5 m. * O 9.9 m/s 19.8 m/s O 12.8 m/s O 15.2 m/s D
An air-cooled condenser has an expected U value of 30 W/m2∙K based on the airside. The condenser is to transfer 60 kW with an airflow rate of 15 kg/s entering at 35°C. If the condensing temperature is to be 48°C, what is the required airside area in m2? Round your answer to 2 decimal places. heat transfer