Air conditioners not only cool air but dry it as well. A room in ahome measures 6.0 m * 10.0 m * 2.2 m. If the outdoortemperature is 30°C and the vapor pressure of water in the air is85% of the vapor pressure of water at this temperature, whatmass of water must be removed from the air each time thevolume of air in the room cycles through the air conditioner? Thevapor pressure for water at 30°C is 31.8 torr.

Q: In Breckenridge colorado, the physical atmospheric pressure is 520. torr. What is the boiling point…

A: Answer:Boiling point of water at 760 torr pressure is called as normal boiling point and as the…

Q: Which of the following statements is wrong The temperature below which the liquid state of a…

A: The wrong statements can be choosen as follows:

Q: The vapor pressure of and unknown liquid is 542 mmHg at 30.1°C and 153 mmHg at -19.8°C. What is the…

A:

Q: vapor pressure of water changes with perature, as shown here (C) P (torr) 21 187 22 198 23 21.1 24…

A:

Q: The vapor pressure of liquid bismuth has been measured to be 5.0 atm at atemperature of 1850°C. Does…

A: The pressure of a vapour which is in equilibrium with its corresponding condensed phase at a given…

Q: Why, in liquid state, is H2O a London Force and hydrogen bonding. I understand why it is hydrogen…

A: All three kinds of intermolecular forces (Hydrogen bonding, dipole-dipole interaction and London…

Q: In the phase diagram below 1 atm Phase II. Phaco I: ....* .. Phase II .... ...* .... ... .... ... O…

A: Phase diagram: The phase diagram represents the different phases of the substance and the pressure…

Q: For each pair, predict which one will have the higher value for vapor pressure when it is in the…

A: The pressure exerted by vapour of a  solution is called its vapour pressure.  We have to identify…

Q: References Use the References to access important values if needed for this question. The vapor…

A: The vapour pressure of a liquid is the measure of its tendency to change into the gaseous state.  As…

Q: AH of vaporization of water is 413.2 cal/g at the normal boing point. Since virus can survive at…

A: Normal boiling point is defined as the temperature of a substance when the external pressure is…

Q: 6a. Based on the plot below, what is the enthalpy of vaporization for the compound? a. 63.09 kJ/mol…

A: The question is based on chemical thermodynamics.We need to calculate enthalpy of vaporization.

Q: Gases produced by a chemical reaction can easily be collected over water. To determine the pressure…

A:

Q: Use the following vapor pressure data to answer the questions: A B Liquid C₂H16 CgHyNHz Vapor…

A:

Q: penow.com/ilm/takeAssignment/takeCovalentActivity.do?locator=assignment-take and 14 [References) For…

A: Boiling point is the temperature at which the vapour pressure of the liquid become equal to…

Q: The hypothetical compound X has molar mass 75.89 g/mol and vapor pressure of 596 mmHg at 22°C. 50.0…

A: The hypothetical compound X has molar mass 75.89 g/mol and vapor pressure of 596 mmHg at 22°C. 50.0…

Q: Question 5. Propose a synthetic route for the following transformation. + Any 1 or 2C, molecules FO…

A: The above question is based on organic reaction mechanism and we have to discuss about the product…

Q: Air conditioners dry the air while they cool the air. Suppose an air conditioner is used to cool a…

A: Given: Dimensions of room =7.06 m×10.94 m×2.67 m Temperature = 37 ∘C The vapor pressure of water =…

Q: The vapor pressure of ethanol is 400.0 mm Hg at 63.5oC (336.65K).  Its molar heat of vaporization is…

A:

Q: The vapor pressure of methanol (CH₃OH) at 25.0°C is 127.2 torr. A 4.35-g sample of methanol is…

A: Firstly find out how much methanol would vaporise to attain saturation vapour pressure by using…

Q: The main reason that distillation is a costly method forpurifying water is the high energy required…

A: Distillation is the process in which components of a mixture are separated on basis of different…

Q: As a vapor, methanol exists to an extent as a tetramer,(CH3OH)4, in which four CH3OH molecules are…

A: Concept introduction: Tetramer means four molecules are joined together. Hydrogen bonding is the…

Q: The normal boiling point of water is 100.0 °C and its molar enthalpy of vaporisation is 40.67…

A: Given: The molar enthalpy of vaporization (Hvap∘) is 40.67 kJ/mol. The mass of steam is 39.3 g. The…

Q: 12.) which has lowest boiling point according to ta ble? Vapor pressure at 376mmHq) 23 Substonce ||…

A: Given Substance Vapor pressure at 25°C (in mmHg) I 23 II 650 III 92 IV 139 Which has…

Q: - For the following molecules: methyl ethyl ether, CH3OCH2CH3; carbon disulfide, CS2; and benzene,…

A: Intermolecular forces present in- methyl ethyl ether = London dispersion, dipole-dipole forces CS2…

Q: 0.4- 0.2- solid liquid gas 200 400 temperature (K) Use this diagram to answer the following…

A: Phase diagram: The phase diagram represents the different phases of the substance and the pressure…

Q: A student measured the vapor pressure of a liquid at various temperatures. She then prepared a graph…

A:

Q: The line structures of benzene (Tb = 80 C) and n-pentane (Tp = 36 C) are shown below. Which…

A: Given:

Q: In P2 1 AvapH 1 T2 T₁ R vap 1. Knowing that the AHP of water is 40.6 kJ/mol at its normal boiling…

A: Recall the given Clausius-Clapeyron equation                   lnP2P1=-∆vapHR1T2-1T1 Knowing the…

Q: Which of the following has the highest vapor pressure? PH3 SiH4 H2Se GeH4 HF

A: Vapor pressure depends on nature of liquid,  presence of a solute and temperature. Vapor pressure…

Q: The enthalpy of vaporization of Substance X is 23.0 Round your answer to 2 significant digits. 0 atm…

A: Enthalpy of vaporisation of substance X, ΔHvap = 23.0 kJ/mol…

Q: does LiF have a higher vapor pressure at 25oC than H2S?

A: FALSE - LiF will have higher vapor pressure at 25 degree C than H2S Note: LiF has strong electro…

Q: 2. During a phase change, what properties change? Mass Volume Temperature Heat

A: There are three phases of matter. The phase of matter can be interchanged by changing the…

Q: 1.5 moles of Nesfruta Dalandan are added to a container having 2 liters of water on a nice day at 25…

A: Given that -  Moles of Nesfruta Dalandan = 1.5 mol  Volume of water = 2 L =2000 mL Temperature =…

Q: dT (a) Determine the value of for cyclohexane at T = 353.89 K using the Clapeyron equation and…

A: (a) According to Clapeyron equation,                              dP/dT = ∆vapH / Tboil . ∆V…

Q: Consider the structures of dimethyl ether and ethanol. Which statements explain that the normal…

A: London dispersion forces are weak forces of attraction and hydrogen bonding strongest intermolecular…

Q: Use the observation in the first column to answer the question in the second column. oft observation…

A: Enthalpy of vaporization is the amount of heat required to convert liquid into gas. Vapour pressure…

Q: The vapor pressure of water changes with temperature, as shown here. T (°C) P (torr) 21 18.7 22 19.8…

A: Volume of water saturated H2 gas collected = 13.8 ml  Temperature = 25 °C = 298 K  Pressure = 715…

Q: What is the partial pressure, in mm Hg, of N2 collected over water at 25°C and an atmospheric…

A:

Q: 3. Using your knowledge of IMF's, rank the following in order of increasing expected vapor pressure.…

A: Given:Rank these compounds in increasing order of vapor pressure.Vapor pressure of a compound is…

Q: Water has AH,ap-41KJmol, vapor pressure at 373 is 101.3Kpa. what vapor pressure at 298K?

A:

Q: Given that the heat of fusion of water is -6.02 kJ>mol, the heatcapacity of H2O(l) is 75.2…

A: Data given :  The heat capacity of H2O (l)  = 75.2 J/mol⋅K = 0.0752 kJ/ mol.K The Heat capacity of…

Crystal Structures

Solids are present all around us. They have different properties and applications. Diamond and graphite are two well-known solids. Diamond is the hardest material in the world and is used in making jewelry. Graphite on the other hand is soft. The lead of your pencil is graphite. Why are they so different in appearance and properties despite the fact they are chemically the same? Both are allotropes of carbon. The answer lies in the structure, the way constituent particles are arranged in the solids.