Air at 30°c dry bulb temperature and 60% relative humidity is passed through a cooling coil at the rate of 250 m3/min. The air leaves the cooling coil at 14°c dry bulb temperature. If the bypass factor of the cooling coil is 0.1, find the surface temperature of the cooling coil in degree Celsius Options: 21.4 7.5 18 12.2 1:18PM

Air at 30°c dry bulb temperature and 60% relative humidity is passed through a cooling coil at the rate of 250 m3/min. The air leaves the cooling coil at 14°c dry bulb temperature. If the bypass factor of the cooling coil is 0.1, find the surface temperature of the cooling coil in degree Celsius Options: 21.4 7.5 18 12.2 1:18PM

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

P=19 Moist air goes into air-conditioning unit at a degree-30 C and 70% relative humidity, and it is cooled to 20-degree C and 20% relative humidity at a constant pressure of 1.01325 bar. The mass flow rate of dry air is mda=63 kg/s The unit applies refrigerant R-134a as the cooling fluid that enters inside the tubes of the cooling coil at 3.6 bar with a quality of 0.2 and leaves as a saturated vapor at the same pressure of 3.6 bar. Use the psychometric chart to determine: a) Mass flow rate of condensed water in kg/s b) The heat transfer rate from the air to the cooling coil in kW (Use the psychometric chart) c) The mass flow rate of R-134a that is needed in kg/s
I need help. Please answer this ASAP. Thank you!
14-121 A laboratory has a volume of 700 m' and must have one complete air change per minute when being used. Outside atmospheric air at 100 kPa, 30°C dry bulb, and 60 percent rela- tive humidity is ducted into the laboratory air-conditioning equipment and conditioned to 20°C dry bulb and 12°C wet bulb, the required state for air supplied to the laboratory. (a) Sketch the system hardware and the psychrometric diagram for the process. (b) What outside atmospheric air mass flow rate is required for the air change, in kg/h? (c) Determine the mass flow rate of water condensed from the atmospheric air, in kg/min. (d) The cooling fluid in the air-conditioning system is chilled water, which has a 15°C temperature rise during the heat exchange process. Determine the chilled water mass flow rate, in kg/min.
8. The foilowing observations were made during the trial of a boiler plant consisting of a battery of 6 lancashire boilers and an economiser: Calorific value of coal per kg= 30MJ/kg; Mass of feed water per kg of dry coal 9.1 kg; Equivalent evaporation from and at 100" C per kg of dry coal = 9.6 kg; Temperature of feed water to economiser 12" C: Temperature of feed water to boiler 105° C; Air temperature 13° C ; Temperature of flue gases entering economiser 370° C; Mass of flue gases entering economiser 18.2 kgkg of coal; Mean specific heat of flue gases = 1.005 kJ/kg K. %3D Find : 1. the cfficiency of the boiler alone; 2. the efficiency of the economiser alone ; and 3. the [Ans. 72.22% ; 54.43%; 84.1%l efficiency of the whole boiler plant.
Humid air at 40°C and 20% relative humidity enters an adiabatic spray chamber at a rate of 100 m³/hr. The air is adiabatically humidified to 50% relative humidity. Use humidity charts to find the following: • Outlet temperature of the humidified air • Rate of water evaporation in the spray chamber Water In (Liq) Cool Air T= ? Out h, = 50% V = 100 m3/hr Hot Air In T= 40°C h, = 20% Water Out (Liq)
Steam CERE KJ -Valve Control volume boundary Turbine Initially evacuated tank In case of emergencies, a turbine is connected to an active steam pipe line using a valve. When the valve is opened, steam from the pipe line, which is initially at 550°C and 10 MPa, flows through the turbine into a 0.64 m³ tank, which is initially evacuated. The valve is closed when the pressure inside the tank is 1.6 MPa and the temperature in the tank is 300°C. If the entire process is completed adiabatically, what is the amount of work generated from the turbine?
S3
Air enters a humidifier at 34.25°C and 30% RH. If the air leaves the humidifier at 70% RH. Determine: The exit dry-bulb temperature of the air in °C.
Moist air at 35 °C dry-bulb temperature and 50% relative humidity enters a cooling coil at 300 m³/min and is processed to final saturation condition at 12 °C. Draw the process on the psychometric chart and find the required cooling load in kW. Assume the enthalpy of the removed water is hw = 42kJ / kg
Hand by written answer. can you pls answer this and i will upvote your answers