Help? After finishing running IEX on HPLC, youfound out that the detector on HPLC wasnot on during purification. Fractioncollector collected all the fractions asexpected.Describe assay or assays you would haveto do for generating a chromatogram foryour lab report? If there are still contaminating proteinswith your LDH after going throughaffinity and lon exchangechromatography.what would their physical characteristicsbe?

An extracted-ion chromatogram is generated by separating the ions of interest from a data file…

Answered: After finishing running IEX on HPLC,…

Basic Clinical Laboratory Techniques 6E

6th Edition

ISBN:9781133893943

Author:ESTRIDGE

Publisher:ESTRIDGE

Chapter2: Basic Hematology

Section2.13: Erythrocyte Sedimentation Rate

Problem 1CS

See similar textbooks

Similar questions

(a) You decide to purify the 5-HT 2A receptor. The protein has a predicted molecular Mass of 46.54 kDa and isoelectric point of 8.94. Will the 5-HT2A Receptor protein Bind to an anion exchange column if you are using a buffer containing 150m M NaCl, 50 mM carbonate buffer, pH6.0, and 10% glycerol? (b) After performing affinity chromatography purification, you run a SDS page gel showing The following: 250 150 100 75 50 37 25 . 15 10 Standards Sample | || | Explain why you see four bands in the sample lane? Label the band that corresponds to Your protein of interest. What do you think is going on here?
Discuss the principles and applications of Matrix-Assisted Laser Desorption/Ionization Time-of-Flight Mass Spectrometry in molecular diagnostics.
You are performing an enzyme reaction that works the same way as your wheat germ acid phosphatase (WGAP) assay. First, you dissolve 10.0 umol of product into 1.00 ml of buffer, and measure an absorbance of 0.500. Your cuvette has a 1.00 cm pathlength. Next, you perform the enzyme assay. Your enzyme solution has a concentration of 20.0 ug/ml. 1) Mix 0.250 ml substrate buffer with 0.250 ml enzyme 2) Incubate 20.0 min 3) Stop the assay with 0.500 ml NaOH 4) Read an absorbance of 0.200 *The units required for each answer in this problem are given. Answers to all three parts should be rounded to a maximum of three decimal places. Do not enter any letters. What is the extinction coefficient (ml/umol/cm) of the product? What is the catalytic activity (umol/min) measured in your assay? What is the specific activity (umol/min/ug) measured in your assay?
If a technician examined a Kirby-Bauer assay and found individualcolonies of the plated microbe growing within the zone of inhibitionfor a drug, what should her conclusion be?
A nurse reconstituted a vial of 750 mg Cefuroxime Sodium Powder for Injection with 6mL of sterile water for injection. The reconstituted solution was dark amber-colored solution. The package insert states that solution colors range from clear to yellow depending on concentration, diluent, and storage conditions. The nurse was then hesitant to give the patient the solution due to its unusual dark color. Five portions were taken from a batch of cefuroxime sodium. Prior to testing in the instrument, each part was subjected to one of the following conditions: Conditions Specifications Temperature Portion 1: 8°C ± 2°C Portion 2: 30°C ± 2°C Portion 3: 40°C ± 2°C Light Portion 4: Kept in the dark Portion 5: Exposed to direct sunlight 1. Which form of the product – the powder for injection, the reconstituted product, or both – will you subject to the following conditions? Why do you think these forms can best address the problem?
In RPR test, Why is it necessary to rotate the slide/card?
Would you expect the results from the MAC test to corroborate the results from the EMB test? Explain why or why not.
For the same chromatographic column and experimental conditions Rs when H = 3 cm = Rs when H = 5 cm Rs when H = 3 cm > Rs when H = 5 cm Rs when H = 3 cm < Rs when H = 5 cm The two quantities cannot be compared due to insufficient information.
The cell is usually placed after the monochromator, except in the case of using a multichannel detector. Why?
You want to set up a 1:10 dilution series, so that you can plate a 10-1, 10-2, and a 10-3dilution; however, you only have access to two9 ml dilution blanks. Explain how you could accomplish this task with only two blanks.
Discuss in chemical detail the mechanism of action (how it works) of IMAC. Compare and contrast gel filtration chromotography with IMAC. Discuss the pros and cons for each technique. Why would a scientist prefer one technique over another? In what situations would one technique be more viable than the other?
How could you utilize fluorescence quenching in the different analytical application? Please answer shorty at your own words. Answer should be to the point.

SEE MORE QUESTIONS

Recommended textbooks for you

Basic Clinical Laboratory Techniques 6E

Biology

ISBN:

9781133893943

Author:

ESTRIDGE

Publisher:

Cengage

Biomedical Instrumentation Systems

Chemistry

ISBN:

9781133478294

Author:

Chatterjee

Publisher:

Cengage

Complete Textbook Of Phlebotomy

Biology

ISBN:

9781337464314

Author:

Hoeltke

Publisher:

Cengage

Basic Clinical Laboratory Techniques 6E

Biology

ISBN:

9781133893943

Author:

ESTRIDGE

Publisher:

Cengage

Biomedical Instrumentation Systems

Chemistry

ISBN:

9781133478294

Author:

Chatterjee

Publisher:

Cengage

Complete Textbook Of Phlebotomy

Biology

ISBN:

9781337464314

Author:

Hoeltke

Publisher:

Cengage

Principles Of Radiographic Imaging: An Art And A …

Health & Nutrition

ISBN:

9781337711067

Author:

Richard R. Carlton, Arlene M. Adler, Vesna Balac

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS

After finishing running IEX on HPLC, you found out that the detector on HPLC was not on during purification. Fraction collector collected all the fractions as expected. Describe assay or assays you would have to do for generating a chromatogram for your lab report?