Adjustment resistance in rotor system will --------when three phase load decrease. remain constant not change decrease Increase What will happen if a stationary alternator (off) is connected to a live power system? It will decrease bus bar voltage It will get short circuited It is likely to run as a synchronous motor It will disturb generated e.m.f. of other paralleled alternators. Division: *

Adjustment resistance in rotor system will --------when three phase load decrease. remain constant not change decrease Increase What will happen if a stationary alternator (off) is connected to a live power system? It will decrease bus bar voltage It will get short circuited It is likely to run as a synchronous motor It will disturb generated e.m.f. of other paralleled alternators. Division: *

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

The reactance’s of the alternator during the periods of the subtransient, transient and steady state periods are following, Leakage reactance(XL)=0.16 ohm, Damper winding reactance(XD)= 0.28 ohm Field winding reactance(Xf)=0.41 ohm and Armature reactance (Xm)= 0.74 ohm. The value of the steady state reactance during the steady state condition is Steady state Reactance Answer
the frequency of the induction generator on the rot ratori 9- Explain how does a synchronous generator work. Support your answer with drawing. 10-Draw the synchronous generator phasor diagram forimir tead power factor
5. Two 50 MVA, 3-phase alternators operate in parallel. The settings of governors are such that the rise in speed from full-load to no-load is 2 % in one machine and 3 % in the other; the characteristics being straight lines in both cases. If each machine is fully loaded when the total load is 100 MW, what would be the load on each machine when the total load is 60 MW ? [26 MW; 34 MW]
Which of the given circuit breaker can success fully interrupt Lightning Surges? O a. Vacuum CB O b. Air blast CB O c. SF6 CB O d. Oil CB
10- A long shunt compound generator delivers a current of 10A at 200V and has a series field resistance and shunt field resistance of 1 ohm and 200 ohms respectively. Then series field current is a. 10A b. 9A c. 1A d. 2A
1. What are the reasons of drop of terminal voltage due to load in alternator? 2. Why synchronous impedance method does not provide the exact value of
A) Adding resistive loads in parallel to the output terminals of a series connected DC generator will the total load resistance. a) increase b) decrease c) either "a" or "b" d) neither "a" nor "b" B) Adding resistive loads in parallel to the output terminals of a series connected DC generator will the current through the field winding. a) increase b) decrease c) either "a" or "b" d) neither "a" nor "b"
12. Calculate the number of series turns per pole required on a compound generator to enable it to maintain the voltage constant at 460 V be- tween no load and full load of 100 kW. Without any series winding, it is found that the shunt current has to be 2 A on no load and 2-65 A on full load to maintain the voltage constant at 460 V. Number of turns per pole on the shunt winding = 2000_ If the series coils were wound with 8 turns per pole and had a total resistance of 0-01 2, what value of diverter resistance would be re- quired to give level compounding?
9.09 The flux density distribution in the air-gap of a certain generator is such that it contains a fundamental, a third harmonic, and a fifth harmonic. The flux per pole due to the fundamental distribution is 9 x 10-3 weber, that due to the third harmonic distribution is 0.9 x 10-3 weber, that due to the fifth harmonic distribution is 0.4 x 103 weber. There are four armature slots per phase per pole, the connection are made for three-phase wye. and the coil pitch is 12/15. The frequency is 60 cycles and the generator has 4 poles. (a) Calculate the emf/turn. (b) If there are six turns/coil and two coil sides/slot, calculate the emf per phase. (c) Calculate the emf between line terminals. Ans. 2.32V; 212V; 364V
How does the alternator end voltage change in resistive, inductive, capacitive loads? Please explain.
Draw a complete circuit diagram of 1 phase synchronous alternator including the field excitation circuit. Then, draw the phasor diagram of the generator a general leading power factor. Include the phase resistance in the diagram.
D2. When a generator's full-load output voltage is the same as its no-load output voltage it is said to be a) under-compounded b) flat-compounded c) over-compounded d) none of the above D3. The output of an overcompounded DC generator can be lowered by use of a a) rheostat connected in series with the series field b) rheostat connected in parallel with the series field c) rheostat connected in parallel with the shunt field d) none of the above D4. When might it be desirable to use an overcompounded generator? a) never b) always c) to compensate for line loss d) when you need a higher no-load voltage than your full-load voltage