ad ger( pot it cen cavr hollow

Q: ____________ is a gummy, milky juice exuded througha cut made in the unripe pod of the opium poppy.

A: Opium is a gummy, milky juice exuded through a cut made in the unripe pod of the opium poppy.

Q: describe the five types of reservoirs and draw pressure-temperature phase diagram of each fluid

A: Types of Reservoirs : Single phase gas reservoir: It primary consist of recovery mechanism of…

Q: If water has a pressure of 35 kPa absolute, at what approximate temperature will it boil?

A: This question is possible to solve with the help of steam table

Q: How do oil flow through and out of the formations in the Marmul or fahud Oil field? What techniques…

A: How do oil flow through and out of the formations in the Marmul or fahud Oil field? What techniques…

Q: Describe the Relative Pressure and Relative Specific Volume

A: Relative pressure as the term states ,is a pressure measured relative to atmospheric pressure at sea…

Q: In ITS-90, which temperature scale is considered in four ranges?

A: Out of four temperature scales, Kelvin (K) is considered for ITS-90. ITS stands for the…

Q: Write short note on the Difference between the PVT diagram of water and other liquids

A: Solution: To Determine: The difference between the Phase diagrams of water and other liquid.

Q: Who invented the hand boiler

A: A hand boiler is a glass toy filled with ethyl alcohol. The boiler is made out of a twisting…

Q: 8. Write down the different zones in cupola furnace.

A:

Q: what are functions internal floating roof storage tank?

A: Functions of a internal storage tank is as follows: Since the flexible floating roof deck can float…

Q: 3. What the horizontal tail is used for? AL,

A:

Q: The answers for this exercice is not correct

A: Given the weights of squirrels and angles.  Required: Tension in the cables and alpha.

Q: Q2) briefly explain using appropriate sketches three methods used for removing moisture from…

A: Three method used for removing moisture from compressed air are: 1. Aftercooler 2. Storage tank…

Q: What is an impact when a float moves up into the tapered vertical tube of rotameter? O a. The…

A: Rotameter is a device used for the purpose of flow measurement. In this device a float is used to…

Q: Describe the Mass and Volume Flow Rates?

A: Mass flow rate is the mass of fluid crossing a cross-section area per unit time. If a density of the…

Q: 1. (- If you shoot, using a 0.45 caliber pistol, a SolaneTM LPG tank, will it explode Moreover, why…

A: 1. Shooting a fuel tank with a 0.45 calibre handgun will not cause it to explode. If it is a…

Q: Reheat cycle then solve for it

A: given; Reheat cycle then solve for it

Q: _is the temperature at which an oil substance gives off vapor continuously, when a flame is applied.…

A: TEMPERATURE  Temperature is the degree or intensity of heat contained in a substance or system, as…

Q: Which of the following gates can be considered as another variant of the edge gate, in which the wid…

A: Injections Molding Injections Molding is a process for the production of large volumes of…

Q: Pls. Answer thank you! A double acting steam engine with a cylinder diameter of 19 cm and a stroke…

A: Given data  cylinder diameter =19 cm  stroke =30 cm  cut-off =0.35

Q: What is the boiling point Temperature of water?

A: the boiling point of water is 100 o c

Q: 113 About industrial piping UNDER WHAT CONDITIONS SHOULD FLOW VELOCITIES BE LIMITED?

A: The objective of the question is to understand the conditions under which flow velocities in…

Q: 5. Why does pressure increase when the piston rod is fully extended or retracted? *****

A: Piston rod-In large two-stroke engines, piston rods are frequently utilised. The cross head and the…

Q: How is the air exhausted at the back of the piston when the piston retracts?

A: By employing a single acting air cylinder in the application rather than a more traditional…

Q: A pressure vessel contains a gas at 1200 psi. Express the pressure in pascals,

A: GIVEN = PRESSURE IS GIVEN IN PSI [POUND PER SQUARE INCH ] THAT IS 1200 PSI TO FIND =PRESSURE IN…

Q: A 30-ton, 4-m-diameter hemispherical dome on a level surface is filled with water. Someone claims…

A: Given data: Mass of dome, m= 30 tons Radius of dome, R = 2 m The free body diagram of the dome and…

Q: Name the three modern types of steelmaking furnaces.

A: there are many types of modern steel making furnaces. the three types are given below:

Q: 4m colaulate the megaitude ie sraction A in kN B.

A:

Q: Give all the parts of a simple vertical fire tube boiler

A:

Q: Det. the heswltant of Hhe 2 foor farces. C35 pls.) 4

A:

Q: 100 KH 20 KN/m B 2m C am RI

A:

Q: Fnd pressure at A? 100 m 500 m

A: Applying Pascal's  law:PA-1600*9.81*0.3+1000*9.81*.3-3000*9.81*0.1=PBPB is atmospheric…

Q: Define fluied

A: A fluid is that state of matter which includes both gases and liquids.

Q: Hello good Afternoon Sir, Permission, i have a question in my homework. The following bellow is…

A:

Q: id you get the specific heat of water?

A: Specific heat of water

Q: 20N 30N 40M (amaJ t supvt relons chis heth shaar Ane Jug )Sladeh bending mat dugra

A:

Q: The excess molten metal rises in the - hole after completely filling the mold cavity O a. Gates O b.…

A: In casting, the mold consists of the part name riser, which is responsible for the liquid…

Q: Explain how the hyperbaric chamber helps to cure the bends

A: A hyperbaric chamber helps to cure the bends by the mean of a high-pressure chamber, by which a…

Fluid Kinematics

The branch of science that deals with objects which are either in motion or stationary are studied under the branch of classical mechanics. Fluid mechanics is a subcategory of classical mechanics that deals with the behavior of fluids at rest (fluid statics) or in motion (posing some velocity). In fluid kinematics, studies focus on the associated motion of fluid particles or groups of particles, and its associated parameters like displacements, velocity, and acceleration without concerning about the forces that caused the motion. All the laws of classical mechanics are applied in the study of fluid kinematics.