Activity 2. Using method of sections, solve for the force acting on member BD of the truss shown. [Ans. BD=1340.78KN (C)]

Q: Problem 5.3 80 kN 50 kN E D 3 m A В 2 m 5 m m

A:

Q: 8 ft A -----. ---------- . _.- -. - ---- ----

A: The free body diagram of the truss is as follows. Calculate the angle θ.

Q: 1. A drawbridge is being raised by a cable EI and pin supported at A. The three joint loadings at B,…

A: A drawbridge is being raised by a cable El and pin supported at A. The three joint loadings at B, C…

Q: 6. A truss which consists of a single, equilateral triangle, is supported by a pin and roller as…

A: Given Data: The weight acting at B is P =520 lb. The free body diagram of Truss can be drawn as,…

Q: 2. For the given truss: (a) Draw the FBD of the truss. (b) Determine the supporting forces at A and…

A:

Q: 1) For the truss shown to the right. Determine: a) the support reactions at E and F, and 2) the…

A:

Q: The truss shown is supported by a pin at E and rocker at F. Which of the following is closest to the…

A: Given data  Given truss system

Q: 2:  The structure shown below is composed of cables AC and BC, and bar OC, which is pinned at Point…

A: Given Data: The force acting at point C is P = 1.5 kN. The coordinate of point C is (0,0,3). The…

Q: For the following truss structure (with members AB, BC, AD, DE, BE, CF and FG all of 60 cm length…

A:

Forming and Shaping

Metal forming is a category of metalworking process through which the material can be given the desired shape and size by subjecting it to plastic deformation, where the component undergoes bulk deformation process upon application of loads. Unlike the shearing and machining process, the material does not undergo up to a failure point as indicated in the stress-strain curve. Hence, the stresses induced during the forming process are greater than yield strength but less than the failure strength of the material. The process does not lead to the loss of material, so it can be said to be an economical process. During forming, the material is subjected to tensile forces, compressive forces, bending, and shearing loading conditions. The material should possess the property of ductility to undergo the forming process.