According to fuller equation, to draw the maximum density line for aggregate gradation shown below , what is the percent passing corresponding 4.75 mm sieve size ?

Q: Below is a sieve analysis for a fine aggregate. a. Complete the sieve analysis to get percent…

A:

Q: Table below shows the result of sieve analysis test on a sample of fine aggregate. What is the…

A: The Fineness Modulus (FM) of an aggregate is given by the sum of the cumulative percent retained on…

Q: bucket and rodded with a tamping rod to determine its unit weight. The following data are obtained:…

A: V=0.3 ft3

Q: The grading of three aggregates is given below. a) Calculate the percent passing for a combined…

A: Given: Results of gradation tests on three aggregate A,B and C is shown below Sieve size…

Q: 20. Calculate the solid volume and percent of voids of an aggregate that has a density of 1581 kg/m³…

A:

Q: only as specified by the instruct 5.10 Samples of coarse aggregate from a stockpile are brought to…

A:

Q: Coarse aggregate is placed in a rigid bucket and rodded with a tamping rod to determine its unit…

A: Given that,   The volume of rigid bucket= 0.2 ft3      Weight of empty bucket= 18.2 lb  Weight of…

Q: A sample of coarse aggregate is placed in a bucket of know volume (0.5 ft^3) and rodded with a…

A: Volume of bucket = 0.5 ft3Empty weight of the bucket = 20.3 lb

Q: 5.10 Samples of coarse aggregate from a stockpile are brought to the laboratory for determination of…

A: Given:- The following weights are found from the sample of coarse aggregates:- Mass of moist…

Q: The mean rainfall over a catchment is presented in 20-min time intervals. If th what are the runoff…

A:

Q: 5.43 What is alkali-silica reactivity? What kinds of problems are caused by ASR? Mention two ways to…

A: Alkali Silica Reactivity Alkali-silica reactivity (ASR) is a chemical reaction that occurs between…

Q: Table shows the grain size distributions of aggregates A, and B. Answer the following questions and…

A: Given: The grain size distributions of aggregates are shown below,

Quantity takeoff

Quantity takeoffs (QTO) are precise estimates of the materials and labor costs required to finish a construction project. During the pre-construction phase, an estimator prepares them, breaking down the project into smaller, more manageable parts that are easier to evaluate. These measurements are used to prepare a construction scope bid. Estimators examine the drawings, specifications, and models to figure out different quantities and their costs. Since, the components, their quantity, and price are all included in the model, quantity take-off can be done automatically using Building Information Modelling (BIM). The time taken for completing a construction project can be reduced by the use of quantity takeoff. These takeoffs are also called material takeoffs and construction takeoffs.