ABCD rigid rod is supported as shown in the figure. 40 degrees increase in temperature in the case of; the stresses occurring in the bars and the vertical displacement of point A calculate

Q: A stepped bar is subjected to an axial tensile force of 40000 lb. Compute the increase in stress due…

A: Given:- D=12in d=4in r=0.4in F=40000lb

Q: A compression load of P = 55 kips is applied to a 3 in. by 3 in. square post, as shown. Determine…

A:

Q: The T-section short column shown in Figure 2 carries an eccentric load P of 100 kN at the position…

A:

Q: A rod of different materials is arranged as shown with the corresponding axial forces (see figure…

A:

Q: A clevis-type pipe hanger supports an 8-in.-diameter pipe, as shown in Figure. The hanger rod has a…

A: Given data: W=2000 lb Need to determine the normal stress in the hanger rod, shear stress in the…

Q: 5. The bracket shown in the figure is bolted with 5-20 mm dia bolts. It carries an P35 KN 150 250 mm…

A:

Q: The figure below shown that the three bars are supported a rigid beam ACE. ar CD is made of steel…

A: Given data, d= diameter of each bar =10 mm σAl=allowable stress for aluminum=120 MPa σsteel=…

Q: 3. Work problem 2.9-2 from the textbook, which is as follows. The prismatic bar in the figure is…

A:

Q: For the rigid bar (AB) and rod (BC) system, the normal stress in rod BC can't exceed 30 ksi. The…

A:

Q: Flat steel A is welded to the wall as shown in the figure. The profile of the flat steel is…

A: Based on the image you sent, I can't access the specific data points to solve for the median grain…

Q: The steel tie-bar shown in the figure has been designed to carry a tension force of 103 kN when…

A: The maximum bearing stress at A: 110.0 MPa.

Q: Compute the shear stress in the pins connecting the rods shown in Figure  below when a load of F =…

A: Given data  load of F = 1500 lb is carried. The pins have a diameter  = 0.75 in. The angle u = 40o

Q: An aluminum alloy cylindrical roller with diameter 1.25 in and length 2 in rolls on the inside of a…

A:

Q: + The forces are given in figure and applied as shown. 3 F,-100 KN Fq= 50KN and F3= 30 KN. The…

A: The main difference between twisting moment and bending moment is that their directions of moment.…

Q: The round bar in the figure is made of steel (E-207 GPa). The load F has a magnitude of 100 N. You…

A: Young modulus of the material,(E)=207 GPa. Applied force (F)=100 N. Diameter of the shaft,(d)=20 mm.…

Stress transformation

The term stress indicates the measure of internal forces that develop due to an external force's application on an object. When a specific external force is applied to an object, internal stress generates in the material. The value of stress can obtain by taking the ratio of the externally applied force and cross-sectional area of the object. There are different types of stress depending on the type of external force.