AB AC 325 Ib Find the forces in AB and AC. Answers: AB - 671 AC- 745 Using multiple attemats has impacted your score. 10% score reduction after attempt 2

Q: The mayor of a large downstream city demands an estimate of hours for the spill o get to reach…

A: Engineering, soil science, biology, and chemistry are used by environmental engineers to solve…

Q: Part 3 – Hydraulic Jump and Critical Depth –- C4 Flume Channel width = 7.6_cm Flume Slope =3_% Dist.…

A: The given data is shown below: Channel width=7.6 cmFlume slope=3%Distance between gauges=100…

Q: SITUATION. A square footing is to support a 400 mm x 400 mm column carrying 1400 kN live load and…

A: Given:  Dia of bar = 28 mm  Strength of concrete in column and footing = 28 mpa and 21 mpa…

Q: A motorist driving a 1000-kg car wishes to increase her speed from 20 m/s to 30 m/s in 5 s.…

A: Given,m=1000 kgu= 20 m/sv=30 m/st=5 s

Q: The length of the chord is 325 m long, measured from the P.C. to the P.T. of the curve a common…

A: Given:-azimuth =254.240,270.01o,279.960L=325mazimuth =270.010stationing of PT=6+530To find:-a)total…

Q: The pin support A and roller support B of the bridge truss are supported on concrete abutments. If…

A: Determine the required minimum dimension of the square bearing plates at C and D

Q: All particles of a rotating body have the same although their linear movements vary directly with…

A: (E) Angular velocity  All particles of a rotating body have the same angular velocity  although…

Q: 1. Determine the force in bars BD, CD, and DE of the nacelle truss shown below. Indicate whether…

A:

Q: a) Identify and locate the centroid, ỹ on axis x'- x' for the parts cross-sectional area in Figure…

A: Find centroid Y and moment of inertia about X'X' axis

Q: A cantilevered beam has a distributed load (w) of 5035N/m acting down on it and along its entire…

A: We will be using the method of superposition to solve the given problem. The Deflection at the point…

Q: 49. A man wishes to prepare the future of his ten-year old son. Determine the monthly savings that…

A: Solution: Given: Amount = 120000 Interest = 5.41% Time period = 18-10=8 years

Q: nswer all the questions

A:

Q: An open cylindrical tank, 2 m in diameter and 4 m high contains water to a depth of 3 m. It is…

A:

Q: A glass capillary tube, 2 mm in diameter, is placed on top of a mercury layer. Calculate the height…

A:

Q: A steel [E = 30,900 ksi; a = 6.2 x 10-6/°F] pipe column (1) with a cross-sectional area of A₁1 =…

A:

Q: The rigid beam BC is supported by rods (1) and (2). The cross-sectional area of rod (1) is 7 mm².…

A:

Q: SLI means? STANDARD LIGHT ILLUMINATION SPECIFIC LUMINOUS INDEX SPECIFIC LUMINAIRE INDEX

A:

Q: A weir in a horizontal channel is 12 ft wide and 4 ft high. The upstream water depth is 5.2 ft.…

A: Width of the weir = 12ft Height = 4ft upstream water depth = 5.2 ft Elevation of the water surface…

Q: An unknown metal (530 g) is added into a cylindrical container (inside diameter: 5 cm) containing…

A:

Q: Situation 12: A masonry dam of triangular cross-section, with one end face vertical, has a base of 3…

A: Solution: for unit length: F1=γh22 y1=h3 Therefore; F2y2=F1y1γh2×l=γh22×h3h2=3l2h=3lh=33h=5.2 m

Q: Kitchen Bathroom Living Room Dining Room Library Entry Above is the floor plan for a new house. The…

A: The given floor plan is labeled which is shown below: Given scale: 1 inch: 8 feet

Q: W1 A 幸 10 ft 10 ft Set w1 (k/ft) A (1,2,3,4,5) B (6,7,8,9,0) 3. If the given beam has constant El,…

A:

Q: What is the absolute maximum positive moment in the simply supported beam to the nearest 0.01 k-ft.…

A: Given  P1= 4k  P2= 1.7K  P3= 1K

Q: What is the specific gravity of the glycerine?

A: Given : A container weight           = 3lb Amount of weight into it  = 50lb Amount of glycerine…

Q: Question 13 What is the typical range for the specific gravity of soil solids, Gs? O 3.0 - 4.0 2.6 -…

A: Q13-  The typical range of specific gravity of soil solids.

Q: Determine the moment of inertia of the composite figure about an axis through its centroid and…

A:

Q: Problem IlI. A beam shown in Figure 1 is subjected to loads as shown. 59 kN 38 kN/m B 120 kN.m 68 kN…

A:

Q: Y F1=200# Problem # 3 (7 points): The bent pipe resists forces as shown. Determine the moment of…

A: Consider the following given diagram: The moment at a point is the sum of forces acting…

Q: Problem 1: Design an equalization basin for the following cyclic flow pattern. Provide 10 percent…

A: Solution Time (hr) Flow (m3/s) BOD5 (mg/L) Volume in(m3) Volume out(m3) Accumulation in the…

Q: A wood structure is assembled to support the force applied. All pieces of wood have a width of 5 in.…

A:

Q: A dam is shown. Compute the factor of safety against overturning. Assume weight of masonry to be…

A: Given data  Question-1  Density of concrete = 2400 kg/m3 Top width of dam = 4m  Depth of dam = 24m…

Q: Determine the maximum shearing stress of the beam shown in the above problem (prob. #2) 5 kN 2 m 2.5…

A: depth h = 200 mm width b = 75 mm udl 2.5kN/m point load = 5kN

Q: Determine the XT and YT (using both a and b) a. Using the Top Most, Left Most Reference Line b.…

A: Note:- Hi! Thank you for the question As per the honor code, We’ll answer the first question since…

Q: Determine the largest weight W that can be supported by the two wires shown in figure below. The…

A:

Q: = 2x₁ + x₂-x3 + 2x4 0 X₁-2x₂ + x3 4x4 3 3x₁-x₂2x3 x4 = −3 -x₁ + 2x₂ + x3-2x4 13 =

A:

Q: 18. A 30-sec transit was used to measure a horizontal angle reading was 125 35' the average value by…

A:

Q: ake a cut through JK, C, and CD. The free-body diagram of the section to the right of the cut is…

A: To find force in member CD, CJ, KJ

Q: For the three reservoir system shown, reservoir A supplies water to reservoir B and C at 10 li/s and…

A:

Q: 1.0 ft /s of water flows through 100 ft of 6 in steel pipe at a temperature of 70 degrees F. The…

A: Given, Q=1 ft3/s L=100 ft of 6 in T=70°F rd=20ν=0.739×10-5 Diameter= 6 in=0.5 ft

Q: the DO meter showed a concentration of 8.8 mg/L. m RPD of 9% what is the saturation concentration c

A: Given:- concentration=8.8mg/L Maximum RPD=9% To find:- saturation concentration

Q: 210 kN 40 kN/m 8 m 8 m 4m 21- E = constant

A:

Q: A trapezoidal canal with a base of 2.0 m has its sides sloping at 45* with the horizontal. If water…

A: Given that, for the trapezoidal canal,  base, b = 2 m  side slope, θ=45° depth of flow, y = 1 m The…

Q: A hollow cylinder 80 cm long in diameter, one end closed, is immersed vertically with its closed end…

A: Let us analyse the question in step 2.

Q: 2. A box of 45ON is lying in an inclined plane with angle of 35 degrees. If the applied load to move…

A: Usually, movement can be defined as, Change speed, Change where you are going. It is easy to see…

Q: 2. The following results were obtained from liquid limit and plastic limit tests conducted on the…

A:

Q: Draw the FBD of member ABC 160 mm 90 mm 240 N IS0 mm B. 320 mm D. 125 mm -300

A:

Q: 2. Determine the force in members BC, DC and DB of the truss, and state if the members are in…

A: