A6 m long hollow bar of circular section has 140 mm diameter for a length of 4 m, while it has 120 mm diameter for a length of 2 m. The bore diameter is 80 mm throughout as shown in Fig. 140 80 300 kN - 300 kN 80 120 Find the elongation of the bar, when it is subjected to an axial tensile force of 300 kN. Take modulus of elasticity for the bar material as 200 GPa.

A6 m long hollow bar of circular section has 140 mm diameter for a length of 4 m, while it has 120 mm diameter for a length of 2 m. The bore diameter is 80 mm throughout as shown in Fig. 140 80 300 kN - 300 kN 80 120 Find the elongation of the bar, when it is subjected to an axial tensile force of 300 kN. Take modulus of elasticity for the bar material as 200 GPa.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

The following shaft is composed of two materials, both rigidly bonded. The data is provided in the table: Determine: The maximum torque that can be applied based on the maximum stresses of each material. The total deformation of the shaft with the torque from the previous section. The maximum torque that can be applied if the maximum deformation of the shaft is 2.50 rad.
The rigid bar of negligible weight is supported as shown in the figure. If W=80 kN, compute the temperature change of the assembly that will cause a tensile stress of 50 MPa in the steel rod. Use the following data:
The following structure has a compression allowable stress of 50 MPa. In the laboratory, it was found that the allowable stress in tension is 5 MPa.
A cantilever beam with cross section shown below and span of 3 m is subjected to concentrated load (P) at the free end. If the maximum allowable tensile stress equals to 10 MPa what is the maximum value of the load P can be applied.
I need the answer as soon as possible
Please solve quickly. Resistant material
2. Given a 5 mm diameter steel wire, which is 4 meters long, carries an axial tensile load P. Find the maximum safe value of P if the deformation of the wire is limited to 5.5 mm and the allowable normal stress of the wire is 280 MPa. Use 200 000 MPa for the modulus of elasticity of steel.
A tapered steel bar of length 2m is subjected to an axial load of 20kN. Take modulus of steel as 200GPa. What is the strain produced in the bar? (in 10-5) = 100 mm 2m >= 50 mm 20000 N