A2-wire d.c. distributor AB is 300 meter long. The end A is fed 205 V and end B at 200 V. The distributor is uniformly loaded at 0.15 A / metre length and has concentrated loads of 50 A, 60 A and 40 A at points distant 75, 175, 225 m respectively from the end A. The resistance of each conductor is 0.15 ohm per kilometre. Calculate: (i) the point of minimum potential. (ii) currents fed at ends A and B.

Q: A 33 kV, 50 Hz. 3-phase underground cable, 6 km long uses three single core cables. Each of the…

A: We have been given an 33 KV 50 Hz 3-phase underground cable as,   Length (l) = 6 Km = 6000 m Line…

Q: maximum A certain transformer has a 5% impedance and a Leakage flux density of 10 kilotines per sq…

A: Under short circuit conditions, the transformer will draw a large current, causing a large magnetic…

Q: Discuss the circumstances where parallel operation of transformers may be a) considered beneficial.

A: Electrical machines can be either generator ,transformers or motors. They can be either AC machines…

Q: Figure B2 shows an HVDC system connecting the 400 kV electricity networks of two countries (System A…

A: HVDC System Analysis problem step-by-step and solve each part like this one. Part (i) - Transformer…

Q: (1) (iii) Write the expressions of the line-to-neutral voltages Vas, Von Ven and then determine the…

A: In the given question to solve the current for part b primary side, line and phase currents are…

Q: (b) A single phase transformer has the parameters shown on Table Q3 and is connected to a 230 V and…

A: 1) During open circuit, minimum current flows through the transformer. So we neglect the winding and…

Q: a) Discuss why a starldelta or delta/star configuration of a three-phase transformer is optimal for…

A:

Q: The single line diagram of a power system is shown in Figure Q2.1 including generator and…

A: Given length of line =50 km MVA base = 100 MVA For line , base voltage =11 kV

Q: onsider a three winding transformer with the following particulars: = 50-40° A. Assume that V₂ is 1=…

A: Solution- THREE WINDING TRANSFORMER       Given, Z1=Z2=Z3 = 0.02+j0.08 ohmV2 = 400 VI2 = 60∠-30° AI3…

Q: What is practical application of PWM?

A: PWM stands for pulse width modulation.  In this the signal is varied by varying the width of the…

Q: In a step-up transformer, the turn ratio is 1: 20. The resistance of 100 2 connected across the…

A: Given information is shown below:To find:

Distribution System

The final stage in the delivery of the electric power is the electric power distribution system. From the transmission system to the individual customers it carries electricity. The distribution system is connected with the transmission system and is used to lower the voltage of the transmission to medium voltage in the range of 2 kV to 35 kV with the help of transformers. This medium voltage to the distribution transformers located near the customer's premises is carried by the primary distribution system lines. These distribution transformers in turn lower the voltage to utilization voltage used in lightings, household appliances, industrial equipments etc. Through secondary distribution lines often several customers are supplied from one transformer. It is through service drops, the commercial and residential customers are connected to the secondary distribution system lines. Customers who demand a larger amount of power can be connected directly to the primary distribution system level or the sub-transmission level.