A. WHICH OF THE FOLLOWING TYPE OF TRANSFORMER IS REQUIRED TO CREATE A 180 DEGREE PHASE DIFFERENCE BETWEEN PHASE INPUT TO A RECTIFIER? a) None of these b) Center-taped secondary c) Multiple Split Transformer d) Ordinary Single Phase Step up Transformer e) Ordinary Single Phase Step down Transformer

A. WHICH OF THE FOLLOWING TYPE OF TRANSFORMER IS REQUIRED TO CREATE A 180 DEGREE PHASE DIFFERENCE BETWEEN PHASE INPUT TO A RECTIFIER? a) None of these b) Center-taped secondary c) Multiple Split Transformer d) Ordinary Single Phase Step up Transformer e) Ordinary Single Phase Step down Transformer

Electric Motor Control

10th Edition

ISBN:9781133702818

Author:Herman

Publisher:Herman

Chapter4: Symbols

Section: Chapter Questions

Problem 7SQ: The symbol shown is a(n) a. iron core transformer. b. auto transformer. c. current transformer. d....

See similar textbooks

Related questions

Q: 6. A single-phase, 225-kVA, 460/120-V transformer has 6% impedance and 96% efficiency. Find its…

A: In this question we need to find series R and X of the given transformer

Q: he ratings of a single-phase three-winding transformer are as follows: *primary winding: 300 MVA,…

A: Base MVA=300 MVARated primary side voltage=14 kV→terminal 1Rated secondary winding voltage= 200…

Q: Explain the faults in transformer. Explain the construction and working principle of Buchhloz Relay

A: Currents caused by a failure on a transformer winding depend on the source, neutral grounding…

Q: Transformer 1) Enumerate the way/s by which the voltage of the large coil may be: a) increased (AC…

A: The voltage in a coil is given by V= -L(di/dt). So for an ac source the voltage of a coil is…

Q: A three-phase uncontrolled bridge rectifier delivers power to a resistive load of 10N. The output…

A: Given Resistance R=10 Ω Output voltage V=400 V The rating of the source side of a three-phase…

Q: 3. Why the copper loss in the primary can be neglected, in the open circuit test?

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: 16. If a 0.6 accuracy class current transformer has a phase angle ß of + 10' at 100% rated current,…

A: Solution 1chevron_right close Value of 'β=10' Step 2 Ratio correction factor ,…

Q: With base MVA of 150 and base voltage of 33. If the reactance of the transformer is 0.23 pu. The…

A: Base MVA S= 150MVA Base voltage VB = 33kV Reactance per unit = 0.23 Reactance?

Q: current supplies hysteresis loss, in a practical transformer? a. None of these b. IM c. IC d. I0

Q: 7. The primary and secondary induced e.m.fs. El and E2 in a two-winding transformer are…

Q: Explain transient analysis of transformer

A: Transient Analysis in Transformer: -> Sudden variations in electrical quantities under the…

Q: Determine the peak-to-peak ripple and dc output voltages. The transformer has a 36 Vrms secondary…

A: Given, RMS voltage at the secondary side of the transformer, Vs=36 V Supply frequency, f=60 Hz…

Q: 1. Verify (KCL and (KVL). 2. Comment on results. 3. Find I1, I2, I3. 3 V 10ar b -20 V g h 2202 4V…

A: The circuit diagram,

Q: List and describe the types of losses that occur in a transformer

A: Transformer is a static device . Hence there will not be friction or windage losses . The only…

Q: Single phase half wave AC-AC converter has a resistance of R = 50 ohms. Input voltage is given as…

A: Given in the question: Load resistance: RL = 50 Ohms Input voltage, V = 230V Firing angle, α=600…

Q: Voltage control method connected across the load, to supply part of VAR required is O Shunt…

A: In this question we will define which voltage control method supply var connected across load...

Q: Two transformers A and B have the following data Transformer A: 6600/440 V, (250 KVA ) requires (…

Q: A three-phase uncontrolled bridge rectifier delivers power to a resistive load of 102. The output…

A: First find the output side average current by given condition then find the source side current

Q: Determine the regulation of a transformer in which the percentage resistance drop is 1% and the…

Q: What is the relationship between primary induced emf( E1) and applied voltage (V1) of a Transformer?…

A: The relationship between primary induced emf( E1) and applied voltage (V1)

Q: In the single-phase, three- winding, transformer, the primary current is equal to lo at the…

A: In this question we need to choose a correct option

Q: 7. The primary of a single-phase transformer takes 1 A at power factor of 0.4 when connected to a…

A: In the question, Primary current Ip = 1A at 0.4PF logging with secondary side open. Secondary side…

Q: Draw the scheme of a single-phase transformer with two secondary windings and mark the main symbols…

A: Transformer: A transformer is a electrical equipment whose main purpose is to transfer electrical…

Q: An isolating transformer is a (..........................)ratio transformer with several important…

Q: Q2/ Fill in the blanks: 1- The two windings of a transformer is ........ linked. 2- If a transformer…

A: In this question we will write transformer related questions.....

Q: VOLTAGE STEP UP THE VOLTAGE + TRANSFORMER ^ V Done

A: Voltage transformer are used to to bring voltage down to an acceptable level used by protective…

Q: Two transformers A and B have the following data Transformer A: 6600/440 V, (250 KVA ) requires (…

A: According to question: The efficiency of transformer is maximum when iron loss (no load loss) is…

Q: transformer. a. Primary number turns = Secondary number turns b. Primary number turns Secondary…

A: according to the question we have to explain about the type of transformer.

Q: three-phase uncontrolled bridge rectifier delivers power to a resistive load of 10.The output…

A: resistive load of 10 output voltage of the rectifier is 400 V DC.

Q: Figure 5 shows the core of a Linear Variable Differential Transformer (LVDT). S, S2 CORE Figure 5…

Q: Q5. For the following center tapped transformer, show the waveform across each half of the secondary…

A: An device which convert alternating signal in to pulsating direct signal. The half wave rectifier…

Q: A three-phase uncontrolled bridge rectifier delivers power to a resistive load of 102. The output…

A: The rating of source side of three phase star-delta transformer=PdT.U.F.…

Q: Primary AC Source Transformer Secondary AC/DC Full-wave Rectifier Capaictor m Non- linear, Load…

A: The given circuit is shown below.

Concept explainers

Three-Phase Transformers

Three-segment transformers are a type of transformer used to transform voltages of electrical systems into three ranges. Two type transformers are shell-type transformer and core type transformer. In brief, it could be described because of the exquisite kinds of configurations.

Transformer

Ever since electricity has been created, people have started using it in its entirety. We see many types of Transformers in the neighborhoods. Some are smaller in size and some are very large. They are used according to their requirements. Many of us have seen the electrical transformer but they do not know what work they are engaged in.

Question

A. WHICH OF THE FOLLOWING TYPE OF TRANSFORMER IS REQUIRED TO CREATE
A 180 DEGREE PHASE DIFFERENCE BETWEEN PHASE INPUT TO A RECTIFIER?
a) None of these
b) Center-taped secondary
c) Multiple Split Transformer
d) Ordinary Single Phase Step up Transformer
e) Ordinary Single Phase Step down Transformer

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The symbol shown is a(n) a. iron core transformer. b. auto transformer. c. current transformer. d. air core transformer.
Why is it important to reduce the moisture within a transformer to acceptable levels during transformer installation?
eeff
Q2/ Fill in the blanks: 1- The two windings of a transformer is linked. ***** 2- If a transformer primary is energized from a square wave voltage source, its output voltage will be.......... 3- The primary winding of a 220/6 V, 50 Hz transformer is energized from 110 V, 60 Hz supply. The secondary output voltage will be ...... V.
6. A single-phase, 225-kVA, 460/120-V transformer has 6% impedance and 96% efficiency. Find its series Rand X in percent and in ohms looking from the HV side source. 7. Determine the rms fanlt currents on both sides of a 100-IVA single nhase
A three-phase uncontrolled bridge rectifier delivers power to a resistive load of 10N. The output voltage of the rectifier is 400 V DC. The rating of source side of three phase delta – star transformer is, (a) 14.875 kVA (b) 16.765 kVA (c) 15.475 kVA (d) 16.025 kVA
None
3. Why the copper loss in the primary can be neglected, in the open circuit test? 4. Why the terms Rm and Xm significant when the transformer is loaded?
Voltage control method connected across the load, to supply part of VAR required is ..... O Shunt capacitor O tap changing transformer O series capacitor O booster transformer
Single phase half wave AC-AC converter has a resistance of R = 50 ohms. Input voltage is given as 230 Vrms. Transformer conversion ratio is 1:1. If T1 thyristor is triggered at 60 degrees; a)Rms output voltage? b)Output power? c)RMS load current and average load current? d)Input power factor? e)Average and RMS thyristor current?
Explain transient analysis of transformer
(5) Primary AC Source Transformer Secondary AC/DC Full-wave Rectifier Capaictor in Non- linear Load Figure 6 Analyse different methods of harmonics mitigation to eliminate the harmonic, which you have identify in above power system circuit. You can use harmonic filters, K or equivalent transformers or oversized neutral method depending upon the harmonic sources.