A. Water and chloroform has a partition coefficient of 5.00. A 50.00mL sample of a 8M aqueous solution of the solute is extracted with 10.00mL of chloroform. 1. What is the extraction efficiency for this separation? 2. What is the solute's final concentration in each phase? 3. What is the volume of chloroform needed to extract 99.00% of the solute?

A. Water and chloroform has a partition coefficient of 5.00. A 50.00mL sample of a 8M aqueous solution of the solute is extracted with 10.00mL of chloroform. 1. What is the extraction efficiency for this separation? 2. What is the solute's final concentration in each phase? 3. What is the volume of chloroform needed to extract 99.00% of the solute?

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

Crystallization of Benzoic Acid from Water and a Solvent Pair and Melting Point determination of Benzoic Acid Products 1) Consider a homogeneous mixture of X and Y. From the following solubility table determine whether water or methanol would be the better choice for isolating and recrystallizing X from Y. Explain the reasoning behind your decision. Water Methanol High Temp. Low Temp. High Temp. Low Temp. 2.05 Solubility of X (g/mL) Solubility of Y (g/mL) 2.75 1.751 0.151 3.12 0.668 2.23 0.121 2) If one started with 17 mg of crude material and recovered 14 mg, what is the percent recovery.
Select the factor that will decrease the relative supersaturation during a precipitation process? A. Raising the temperature during precipitation. B. Using homogeneous precipitation. C. Keeping the volume of solution large so that concentration of analyte and precipitant are low. D. All of the given choices.
1a. Use the given table to construct a temperature-composition diagram for cyclohexane Toluene mixture. Based on the plot, what is the composition of the distillate obtained by Simple distillation 20 mole percent cyclohexene and 80 mole percent toluene? Show your Work on the plot. 1b. Estimate the composition of the distillate of 20 mole percent of cyclohexane if the Distillation column had three theoretical plates.
Consider 15 mL of an aqueous solution containing 2.0 g of an organic solute. If the distribution coefficient for the solute between ether and water is 20, calculate the percent of the compound that can be recovered with a single extraction with 13.3 mL of ether. to two significant figures.
For solid solutions, check all that applies: V A. For the case of an interstitial solid solution of elements A and B, the atomic diameters do not differ by more than 15%. O B. For the case of an interstitial solid solution of elements A and B, the solute atom is much smaller than the solvent atom. V C. For the case of a substitutional solid solution of elements A and B, a difference in crystal structure of the two elements does not affect solubility. O D. For the case of a substitutional solid solution of elements A and B, high solubility requires that the atomic diameters do not differ by more than 15%.
A student dissolved 20 mg of caffeine in 20 mL of water. The student carried out two extractions using 20 mL of dichloromethane in each one. Caffeine solubility in water: 2.17 g / 100 mL at 25 ° C Caffeine solubility in dichloromethane: 10.0 g / 100 mL at 25 ° C Present the calculations in detail below. A. Determine the distribution coefficient. b. Determine the amount of caffeine obtained in the first extraction. C. Determine the amount of caffeine obtained in the second extraction. 77 D. Determine the total amount of caffeine extracted during the entire process. and E.Determine the percent recovery.
2. The size of a molecule is a factor that can greatly affect solubility of ions. Which molecule is larger, acetone or water? How could this affect the solubility of Nat and CI" ions in each solvent? 3. It is very likely that the acetone partition still contained a fairly good amount of water (and that the water partition contained acetone). Only one of the three concentration units will be affected by the water in the acetone solution. Which one is affected? Explain why, and why the other two concentration units will be unaffected by the amount of water.
a.Give the step-by-step separation techniques you could use for ammonium chloride, calcium carbonate, sand, and water? Explain how would that technique work. b. You have to design a schematic diagram and propose the separation technique/(s) needed for the given mixtures.
II. A Study of Intermolecular Forces of Attraction Anna Divi, a young and ambitious researcher, is planning to put up her very own research laboratory. However, she does not have the funds for this to happen. She then approached Alan Read, CEO of a well-known funding agency, to help her pursue her dream laboratory. Before Alan considers Anna's proposal, Anna must perform an experiment on determining the melting point of solutions. She must have an accurate result with a percent error not greater than 3%. The data on the experiment is given below. Help Anna achieve her goals by performing the necessary calculations below. Table 1. Data on the determination of the melting point of the solution. Parameters Values Theoretical freezing point of solvent, °C 65.8 Freezing point depression constant (ke) 2.49 of solvent, 'C m1 0.250 mass of solute, g mass of solvent, g 2.100 molar mass of solute, g 148.21 mol
Effect of Particle Size on the Rate of Dissolving Time required for all NaCl to dissolve Sample Results after 2 minutes shaking Do you think the size of the crystal makes a difference in how fast the salt dissolves? Explain why the differences you observed and why they happened. Effect of Temperature on the Rate of Dissolving Time required for all NaCl to dissolve Sample Observations Do you think the temperature of the water makes a difference in the rate at which the NaCl dissolves? Explain why the differences you observed and why they happened. Page 3 of 6
A chemical solute has a partition coefficient of 11.2 between hexane and water. If the equilibrium concentration of solute in hexane is 0.00815 M, the equilibrium concentration of the solute in water is: a)7.59 x 10-4 M b) 0.0913 M c)0.00815 M d)1.37 x 103 e)None of These
The volume of water needed to dissolve 0.0743 grams of barium sulfite is Assume no volume change upon addition of the solid. L.