A. In which stage is the branch instruction when its result is applied? 1. IF 2. ID 3. EX 4. MEM 5. WB LO-B Address Instruction memory Read register t Read register Registers Read Write data: register write data 16 Read data 1 Sign-32 +extend IDEX ALU ALU resu EX/MEM Address Data memory Read data MEMWB

Q: When working with the instruction LAHF, the lower eight bits of the EFLAGS register will wind up…

A: According to the information given:- WE have to choose the correct option in order to satisfy the…

Q: 12. The MOD R/M Byte: If the mod R/M byte has the following data in it: mod 11 reg 011 a. What…

A: Answer: Given mod=11 reg=011  r/m=000 Our policy is answer the first three question from the first…

Q: 1. List all the types of addressing modes, explain them with example

A: Kindly Note: As per our guidelines we are supposed to answer only one question. Kindly repost other…

Q: What are the values for MemWrite and MemRead signals for R-type instructions? PC-> Read address Add…

A: The image you sent me shows a block diagram of a computer system. The system consists of the…

Q: -Fully explain the following data path for the brach instruction.

A: Solution is given below :

Q: Given the following procedures, with code segment instruction addresses given on each line in 4 byte…

A: Given data, Given the following procedures, with code segment instruction addresses given on each…

Q: For the following MIPS assembly instructions what is the corresponding C statement? Assume that…

A: After the addi, register $t0 will be the memory address of A[1] which would be not A[1], but…

Q: 9. Write instruction sequence to add Ox0A to Ox222 - 0X22A by a. Direct addressing mode b. Indirect…

A: Below i have given instruction for both the meathod:

Q: Find out the control signal for the following instructions. The complete datapath and control…

A: I have explained the control signals with the help of some example also. ADDI   WHAT IT DOES:…

Q: When a memory operand is utilised, which two extra stages in the instruction execution cycle are…

A: We are asked the two extra stages in the instruction execution cycle, when a memory operand is…

Computer Fundamentals

The computer is termed computation. For calculating or computing something the device that has been used is known as the computer. Or we can say that for performing a fast arithmetic operation the device that has been used is a computer. Storing, processing, and retrieving are the main features of a computer.