a. Find the necessary KVL/KCL equations to solve the problem. (2 pts for each equation) b. Compute for 11, 12, and 13 (3 pts for each current) c. Resketch the circuit and label the current with the correct direction and values for each resistor. (2 pts) Note: For every wrong direction of a current, wrong value of current, or missing current for each resistor minus 1 pt. d. Find V₁, V₂, V3, and V4 (1 pt each). e. Find P₁, P2, P3, and P4 (1 pt. each). Given: = 150 R₁ R₂ = 250 7 12 R₁ 81 = 50V &2 = 25V www R3 www E1 13 E2 E3 NE 12 ww R₂ R4

Q: 5.4 State ONE application of the following: 5.4.1 Paper-insulated armoured cable 5.4.2 Steel-cored…

A: Paper-insulated armoured cable Application ; Used in as Extensions  to older circuits.…

Q: Betz limit applies to O a. solar cells O b. heat engines O c. wind turbines O d. generator

A: Belz limit is the maximum efficiency of wind turbine.

Q: A computer has an MIBE of 250ohours. If aen Syrtem give use8 of 100hous use8 One of these…

A:

Q: A FET has lpss=4lp and gmo = 10mS then gm express answer in mS

A: FET: It is a semiconductor transistor known as field effect transistor. It works due to single…

Q: results in poor voltage regulation. Select one: O a. High Power O b. High Power factor O C. Low…

A: As the electrical circuit draws current, voltage drop starts to occur in the elements. Voltage…

Q: Q4. What are the types of Power supply available in the Laboratory? Q5. How many setup for power…

A:

Q: QJ what is the StefresPonse of overdamPed and underdamped Systems whan alerdam fet $1) and…

A:

Q: A2 3:2 VI 220V 1k (V2 A3 For Rectifier Circuit, Determine the reading of each meter and PLave. 1.…

A:

Q: Choose the name of time taken by a meter, to reach 95% of the final value from 10% of final value.…

A:

Q: ...................................................tariff is used when rate per unit of energy…

A: ...................................................tariff is used when rate per unit of energy…

Q: 5 Classification of 10 MWe capacity solar power plant

A: Solar power plants can be classified in many different ways, depending on the criteria used. Here…

Q: The full form of PIPO is

A: Given, PIPO

Q: QUESTIONS: 1. A transformer is rated at 120V primary/23V secondary. What peak to peak secondary…

A:

Q: & Prove That %3D

A: Resonance Resonance is the condition when the voltage across a circuit becomes in phase with the…

Q: B1, (i) A domestic lighting installation having 25, 75 W lamps is operated as follows: 7 lamps 6 Pm…

A: According to the question we have to calculate the value of daily load factor,  monthly load factor,…

Q: Vhich of the following is not a factor which affects solar panel efficiency. O a. Temperature O b.…

A: Given To find which parameter does not effect solar panel efficiency.

Q: 1. Differentiate the following types of PCBs? Single-layer PCB Double-layer PCB Multi-layer PCB…

A: As per Barley guideline for more than three subpart only first three are the be answered please…

Q: Question 5 Express 0.000000001 W as nW O 10 nW O 1 nW O 100 nW 0.01 nW

A: Expression of power is given 0.000000001 W.

Q: "If lab is equal to 290.9852320 and lb is 1682110, Ic should be

A:

Q: How did you know if the battery is charging in TP405

A: Introduction -  The TP4056 is a comprehensive constant current/voltage linear charger for individual…

Q: what are the pros of Electric health recorsds List each one? and Ways that each pro is empasized

A: With advancement in technology, medical field started using this electronic health records alot.…

Q: Betz efficiency applies to O a. wind turbines O b. solar cells O c. parabolic dish O d. heat engines

A: The Betz limit is a theoretical maximum limit on the power production from a wind turbine.  Betz's…

Q: We obtained the following values from measurements of the resistance of 147.2. 147.4, 147.9, 148.1,…

A: Given: Values from measurements of the resistance, 147.2, 147.4, 147.9, 148.1, 147.1, 147.5, 147.6,…

Q: O 0.3 O 0.5 O 0.7 O 0.9 O 1.1 O 1.3 O 1.5 O 1.7

A: Answer: t = 0.5 seconds

Q: he semiconductor used in the Sullivan Wrist Calculator has five circuits, each of which has its own…

A: Given reliability rate component1-0.902-0.953-0.984-0.905-0.99

Q: Other term of Capitalized Cost a) Life Cost b) Project Cost c) Infinite Cost d) Life Cycle Cost

A: capitalized cost is the cost of fixed assets whether they are built or purchased.

Q: 610 510 12V +6V U Ka 510 R3 E 510 IN4007

A: In the circuit the current I1 is flowing through R1 and R3 and current I2 is flowing through R2 and…

Q: Q4 Compare between Vametcan and Vazractca Vure = Vaameoretica V12 tractca)

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: Commercial grade ICs can operate from a temperature range of -55 degree Centigrade to +125 degree…

A: Industrial grade ICs: −40 ° to 85 °C.

Q: Which of the following is the basic step in calculating LOLE? a. Energy Demand b. Expected Energy…

A: To calculate of loss of load expectation following steps should be performed. 1. Determine the…

Q: Hau/ Find the hansler lunchion Vs)NG) fr the Cireuit shown below e- 152 VO 1H 1H VICA

A: In this question,   We need to determine the transfer function of the given circuit.  We are solving…

Q: For the network of figure below, determine the value of IRs Rs www 9192 V₂=16 VA PZmax = 400 mW RL…

A: The solution is given below.

Q: The amplification factor and plate resistance in a triode are 50 and 2 kΩ respectively. With…

A:

Q: What is the voltage reading of poins A and B; B and C; A and D; D and C; F and E? What is the…

A:

Q: Find the resistançe between Aand For the cireuit shownin う4

A: In this question we will find equivalent resistance between point AB....

Q: A synchronous generator has a constant mechanical input power of Po. In the fault followed by the…

A: Given  A1=1.6 A2=0.4

Q: 6) Calculate the total resistance and the current flowing through the circuit when the voltage is…

A:

Q: Germanium Silicon Vo v2 V1 RL 1k 15 mi

A: The given circuit is,

Q: Ht OF answers the quesO 1. Which of the following common enggineering prefixes has the largest power…

A: 1) The values are given below, Pico = 10-12 Milli= 10-3 Kilo = 103 Giga = 109

Q: Measured value: Value of a measurand as indicated by an instrument. It should always be followed by…

A: Need to find true false

Q: Military grade ICs operate from a temperature range of 0 degree Centigrade to +70 degree Centigrade.…

A: We know the various temp.  Range for  various IC Commercial: 0 ° to 70 °C Industrial: −40 ° to 85 °C…

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors.  The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.