а. Find the equivalent resistance REg for the resistor combination circuit provided in figure 4. 202 ww 50 ww 18 2 202 22 Figure 4 A heater coil is made using a material of cross section 2.60x10-m2 and a resistivity of 5.00x100-m and voltage of 75 V is applied across the length of the wire. For this heater determine the following: b. i. If the coil dissipates 5000 W, what is its length? ii. If applying a voltage of 100 V produces the same power dissipation, determine the length of the wire. w

Q: Look at the diagram and answer the following questions

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: Can you show the circuit for this or the diagram?

A:

Q: Does the NEC procide the minium or the maximum standard?

A: In order to protect humans and properties from the hazards while using electricity, some minimum…

Q: The voltage drop across a resistor is 6.0V when a current of 3.0A flows across the resistor. The…

A: Given  Voltage drop across the resistor V=6 v The current in the resistor is I=3 A

Q: 39. Given the circuit below, use the Superposition Theorem to calculate the amount of current going…

A:

Q: If the cable in Figure ran for the whole of its length, grouped with others of the same size in a…

A: Ambient temperature – The standard or reference temperature for the installation of cables is…

Q: what are two common types of variables resistors

A: The two common types of variables resistors are

Q: Spacing between receptacles in a kitchen area that is NOT countertop space is? No more than 6…

A: Countertop - The best kitchen countertop material, as previous posters said, depends on what you…

Q: for this Lab you will be laying out and installing an emergency service panel. Emergency service…

A: (1)  General Emergency Power Systems provide automatic backup power in the event of normal power…

Q: What assumptions can you make regarding the following receptacle wiring? Check all that apply.

A: A split pair is a wiring fault in which two twisted pair wires are linked instead with two wires…

Q: B1 Battery B2 Battery + A НОНІ Switch B WHOI C 3.30 C 3 VOLTS BAX m 10: KIT NO.

A:

Q: How do you do this same question, but instead with two OR gates?

A: Given Data:A function  is given.Required:Here we need to implement the given function using a…

Q: Determine the current, voltage and power

A:

Q: What should I enter in the box for final answer? It is asking for maximum amount of noise not…

A: Given:Solution of a problem, The maximum amount of noise, the circuit can tolerate is the noise…

Q: What is the minimum sized IMC conduit we should use for the above wire run if it is over 24 inches…

A: 1/2".     To determine the minimum size of Intermediate Metal Conduit (IMC) required for a wire run,…

Q: using the base of 2 to answer following subtraction:  1000 base 2 -101 base 2 ________________

A: According to the given question, it is required to determine the binary subtraction of the two given…

Q: Use your understanding of equivalent resistance to complete the following statements: Two 6-…

A: In this question , we will solve problems related to parallel resistances....

Thermocouple

A thermocouple is a temperature measurement device. It includes diverse metal wires which are joined collectively to form a joint. At the same time as the junction is hot or cold, a small voltage is generated inside the measuring thermocouple electrical circuit, which corresponds to the temperature.