A. Determine re.  B. Find Avmid=Vo/Vc C. Calculate Zi

Q: frequency modulation and what is the highest value for

A:

Q: What is Frequency Modulation? Draw the waveforms.

A:

Q: What is the impact of switching frequency and dv/dt, di/dt on losses, harmonics and EMI in a power…

A: Design of power electronics is a challenging and complex task. Major issues are Harmonics, EMI and…

Q: What Is frequency modulation and demodulation? Describe their importance and how they work.

A: Given: Frequency modulation and demodulation

Q: What is equation of the demodulator? advantages and disadvantages of DSB-SC over DSB-AM?

A: Demodulator The process of extracting an original message signal from the modulated wave is known as…

Q: in FM , the maximum allowable frequency deviation is 4kHz and the frequency deviation by noise is…

A: N/S = Frequency deviation by noise / maximum deviation = 156.42/4000 =0.0391 S/N = (N/S)-1=25.57

Q: (a) A carrier and a modulating signals are shown in Figure 2. Sketch and label the modulated output…

A: According to the question,

Q: nethod.

A: Here it is asked to draw the block diagram of Phase demodulator using frequecy discriminator method.…

Q: In a frequency modulation system, maximum frequency deviation allowed is 1000 and modulating…

A: Given, In a frequency modulation system, maximum frequency deviation allowed is 1000 and modulating…

Q: 1. For an AM, amplite carrier amplitude is

A:

Q: The maximum peak frequency deviation divided by the maximum frequency gives the worst-case…

A: Frequency deviation is the worst case modulation index is equal to maximum peak frequency deviation…

Q: A) what name the modulation scheme in the blue curve in A and C B) what is the duty cycle in B C)…

A: solution a ) the modulation scheme in the blue curve in figure A = pulse position modulation (PPM)…

Q: One input to an AM DSBFC modulator is an 800 kHz carrier with an amplitude of 40 vp. The second…

A: We need to analyse the amplitude modulated signal

Q: Find the resonance point and the half-width of the speed versus frequency curve for the damped…

A: When b / m << 2ω0 (half width of speed), we say that the oscillator is lightly damped. For a…

Q: - b) Draw the block diagram of the phase- locked loop (PLL) that can be used to demodulate FM…

A: `

Q: Plz I need the correct answer of this question  1- The optimal value for the VSWR in RF circuits…

A: VSWR stands for Voltage standing wave ratio.

Q: 2 Modulation index for FM is defined as a ratio of modulating signal frequency to maximum frequency…

A: Modulation index (β): Modulation index for Frequency Modulation (FM) is define as the ratio of…

Q: What is the difference between AM-DSB and AM-VSB.

A: In the given questions we need to provide difference between Amplitude modulation based on Double…

Q: kHz, the power of signal is 10 W and the power of noise is 5 W. Determine the channel capacity. Or:…

A:

Q: Impulse noise in FM is due to a. sudden amplitude fluctuations in the modulated signal. b. large…

A: Impulse noise comes into the system due to the sudden change of the voltage amplitude of modulated…

Q: Q2:If the carrier frequency 1000hz and reference voltage =10 V with modulation Index 0.4 and…

A: Brief description : For the above given amplitude modulation system we need to calculate output…

Q: please Determine a) fLS, fLC, and fLE. b) the low cutoff frequency

A:

Q: 12- A DVM measure....... a- peak value. b- RMS value. 1 21 Average value. d- peak to peak value.…

A: DVM (Digital Voltmeter):- The unknown input voltage is converted to a digital value using a digital…

Q: Phase modulation (PM) can be: O a. Only narrowband. O b. Only wideband. Narrowband or wideband O d.…

A: Choose the correct option Phase modulation can be ?

Q: If a positive change in modulation signal level of 200 mV will cause a positive frequency deviation…

A:

Q: I need proper solution for the following( underdstandable writing and well explained) thank you…

A:

Q: hich statement is true? a. In FSK, the modulating signal and the carrier signal are both analog…

A:

Q: Name atleast six types of FM demodulators.

A:

Q: pise Figure for an equivalent noise temperature of 75K. juivalent noise temperature for a noise…

A:

Q: Find the voltage attenuation ratio for a 30 dB attenuator.

A: For an attenuator circuit, the attenuation in decibels (dB) in terms of the input and the output…

Q: Question: What is the importance of Modulator and Demodulator (functions) in FM.

A: In this question we will write function of modulator and demodulator in FM....

Amplitude modulation

A radio signal can carry information in the form of sound or image for broadcasting or communication. For it to be sent to a greater distance, the signal must be changed or modulated in some way. One of the easiest way is to change the amplitude of the signal with variations of the video or the audio signal. This is called Amplitude Modulaton. In this modulation information of message is carried in amplitude of carrier signal.