a. Complete the following timing diagram for the following circuit. The circuit works with falling edge. All of flip flops are JK-MS-FF. b. By use of timing diagram specify the count routine of the circuit. (Consider the main out-pout of each flip flop) fo J A J B J C J D K K K K clk clk A В C D

Q: The frequency is known as ohms but many times, it is referred to as cycles. Select one: TRUE FALSE

A: To discuss whether the given statement is correct or not. Statement: The frequency is known as ohms…

Q: Explain the environmental impacts of Geothermal power plant

A:

Q: a) Explain the importance of thermal management of electronics devices.

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Q: Select the false comment about the Alternating Current and Direct Current.   A Direct current is…

A: In this question we will find false statement about dc and ac currents...

Q: Determine the ((I) rms value 1) {(x) average value of the following waveforms:

A: Since you have posted the multiple questions so we are supposed to answer first.According to…

Q: 4) Listen Regarding a Sine wave of an A.C. voltage (pictured below for reference), changing the…

A: Option c only correct Since charging voltage level per division will only effect the village values…

Q: An incandescent light bulb uses a cold filament of tungsten that is 580 mm. long with a diameter of…

A: In this question,  Resistance at To = 20° is 10 ohm Find the temperature if coefficient = 0.0045…

Q: make an introduction of at least 30 lines about PROTOTYPE OF PIEZOELECTRIC BALLAST FOR GENERATING…

A: The development of a prototype utilizing piezoelectric technology within a ballast structure to…

Q: The time constant RC has a unit of

A: In this question,  We need to choose the correct options What is unit of the time constant RC?

Q: A bank of nickel-cadmium cells is used as the emergency lighting supply for a hospital. There are…

A: When batteries or cells are connected in series, their voltages add and their current capacities…

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors.  The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.