a. 12C requires how many wires? What are they called and what is their purpose? b. How many "slave" devices can be attached to one 12C bus? How many “master” devices? Who typically serves as the “master”? c. What is the maximum data rate? How much data is sent with each transmission?

Q: By referring to the ABS/ESP diagram above answer the following What information is being carried by…

A: According to the information given:- We have to find information is being carried by the CAN bus…

Q: In a basic MIPS datapath, how does the ALU perform a NOT operation? What are the resulting LF bits?

A: MIРS-Dаtараth  is  а  grарhiсаl  MIРS  СРU  simulаtоr.  The  рrоgrаm  is  intended  tо  be  used  аs…

Q: Describe the bus briefly

A: In the given question bus is a communication system in computer architecture that transfers data…

Q: Why is it so important to have a well-defined protocol when working with I/O bus technology?

A: I/O (input/output) bus technology is used in computers to transfer data between the CPU and…

Q: What exactly is a protocol, and why is it vital in the field of I/O bus technology?

A: Origination: A protocol is a collection of instructions and procedures for exchanging data. During…

Q: What are some of the disadvantages that come along with using the bus topology?

A: GIVEN: What are the bus topology's drawbacks? Benefits of Bus Topology: Bus topology is bad for big…

Q: 5. Suppose, you have 6 voice channels, each of 60MBps. You have to use synchronous TDM to multiplex…

A: The solution is given in the next step

Q: What phrase is used to refer to the sum of the rotational delay and seek time?

A: Ans: The phrase that is used to refer to the sum of the rotational delay and seek time is called the…

Q: When it comes to VO bus technology, what exactly is a protocol, and why is it important?

A: Introduction: A protocol is a signal sent from a sender to a receiver. It is a set of guidelines…

Q: Is serial bus data transmission better or worse than parallel bus transmission?

A: Dear Student, The detailed answer to your question along with required explanation is given below -

Q: Who can be considered the father of UML?

A: UML - Unified Modeling Language is the way to representing general-purpose, developmental, modeling…

Q: What exactly is a protocol, and why is it important in the field of I/O bus technology?

A: Protocol: Protocol is signal which is transferred between sender and a receiver. It is a set of…

Q: When comparing serial vs parallel data transmission, what are the benefits and drawbacks of using a…

A: Data transmission is the process of transfer data from one location to another  in a point to point…

Q: The difficulties in reconnection and fault isolation are two of the downsides of the Bus topology,…

A: Introduction:  In a bus topology, multi-point electrical connections can be made via coaxial cable,…

Q: Explain why, in MARIE, the MAR is only 12 bits wide while the AC is 16 bits wide. Hint: Consider the…

A: Here we have given solution for the asked question. You can find the solution in step 2.

Q: What is the data rate for the IEEE-1394 bus standard in the S100 mode? What is the data rate in the…

A: Note: There are multiple questions are given in one question. According to the rule, you will get…

Q: What what is "short stroking," and how does it impact SSDs' cost per gigabyte?

A: brief stroking A method for formatting a hard disc or a hard drive partition is called short…

Q: "Short stroking," and how does it effect the cost per gigabyte of SSDs, is a common term.

A: Answer:

Q: Draw a timing diagram showing the signals required for the master to send the byte 0x2B and the…

A: Timing diagram is given below  We have to send  0x2B for master  We have to send 0x47  for slave…

Q: For the 12C transmission below by the Master, determine the Slave address and whether or not it is a…

A: Answer: 0xEA, Write , ACK

Q: "Short stroking," and how does it effect the cost per gigabyte of SSDs, is a common term

A: Answer:

Q: There are two basic types of bus protocol. what are the two different types of bus protocol? How are…

A:

Q: What is the significance of "bus width" in determining data transfer rates within a computer system?

A: The "bus width" plays a crucial role in determining data transfer rates within a computer system. It…

Q: III. The figure below shows synchronous TDM, the data rate for each input connection is 1 Mbps. If 1…

A:

Q: In what ways does the bus topology fall short, if at all

A: Bus topology  Each computer and network is connected  to a minimum of one cable it carries…

Q: Describe the bus briefly.

A: Answer the above question are as follows

Q: 45. Consider the GPIB interface between a talker and a listener as shown in Figure 13-86(a). From…

A: Given:

Q: What are the disadvantages of the bus topology?

A: GIVEN: What are the disadvantages of the bus topology?

Q: Two columns are needed in a datagram network, but four are needed in a virtual-circuit network. Is…

A: In a datagram network, there must be at least two columns; in a virtual-circuit network, there must…

Q: Megabits per second) has 60GB/s (GigaByte p Megabits per second) has 600GB/s (GigaByte Megabits per…

A: Solution - In the given question, we have to find how many MB/s the USB3 has.

Transmission media

A communication channel that transmits data from a source to a recipient is referred to as "transmission media." Electromagnetic impulses are used to transmit data. Transmission media's primary purpose is to transmit data in the form of bits via a local area network (LAN). In data transport, it is the physical link that connects the transmitter and receiver. Transmission medium is part of layer 1 or physical layer of the ISO/OSI (Open System Interconnection) model.