(a) Write Area-Velocity relation for compressible flows through a supersonic Convergent-Divergent nozzle What is the importance of it? (b) Write Area-density relation for compressible flows through a supersonic Convergent-Divergent nozzle What is the importance of it? (c) Write Area-Mach relation for compressible flows through a supersonic Convergent-Divergent nozzle What is the importance of it? (d) Plot the variation of density, pressure, temperature, velocity and Mach number for compressible flows through a supersonic Convergent-Divergent nozzle

(a) Write Area-Velocity relation for compressible flows through a supersonic Convergent-Divergent nozzle What is the importance of it? (b) Write Area-density relation for compressible flows through a supersonic Convergent-Divergent nozzle What is the importance of it? (c) Write Area-Mach relation for compressible flows through a supersonic Convergent-Divergent nozzle What is the importance of it? (d) Plot the variation of density, pressure, temperature, velocity and Mach number for compressible flows through a supersonic Convergent-Divergent nozzle

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: Estimate the mass flow rate and Mach number at the discharged duct when an air flows through a 6cm…

Q: Air at 800 kPa and 1200 K enters a converging nozzle with negligible velocity (i.e., these are…

Q: An aircraft with nose M1 P1 T1 properties of the upstream unifrom air M2 angle 0 = 15° as shown in…

A: nose angle θ = 15° Mach no M1 = 2.5 Upstream air pressure = P1= 60 kPa Upstream temperature = T1 =…

Q: Give a physical description of the phenomenon of chokingin a converging-nozzle gas fl ow. Could…

A: If a fluid is passing through a nozzle with given upstream pressure and temperature and after…

Q: For a converging-diverging nozzle that is choked what is the ratio of nozzle area divided by the…

Q: (a) The maximum speed achieved by the X-15A-2 rocket-powered research craft was 6630 ft/s at 99,000…

A: (a) Write the given data. v1=6630 ft/sMa2=3.2

Q: Q3. A supersonic flow of air has a pressure of 1 x 105 N/m2 and My a temperature of 350 K. After…

A: given data;⇒pressure(P)=1*105N/m2⇒temperature(T)=350K⇒mack number(M)=3.5

Q: Can the Mach number of a fluid be greater than 1 after a normal shock wave? Explain.

A: Normal shock wave: The normal shock waves for supersonic flow are most likely to occurs in the…

Q: If the exit Mach number in Fig. is 2.2, what is theexit area?(a) 0.10 m2, (b) 0.12 m2, (c) 0.15 m2,…

A: Write the given data.

Q: At some point for air flow in a duct, p is 20 psia, T' is 900°R, and V is 275 ft/s. * Your answer is…

A: According to the given dataT=900Rv=275ft/sWe need to findMach number

Q: Shock waves are treated as discontinuities here, but theyactually have a very small fi nite…

A: The variation of the velocity, temperature, pressure and entropy of the before and after the shock…

Q: When operating at design conditions (smooth exit to sealevelpressure), a rocket engine has a thrust…

A: Write the given data.

Q: Air flows through a constant area combustion chamber that has a diameter of 0.15 m and a length 5 m.…

A: D=.15 mL= 5m P0=1.4 Mpa T0=335 KM1=.55

Q: Air enters a constant-area duct at Mach 3 and stagnation conditions 1,000 K and 1.5 MPa. In the duct…

A: Given That: Mach Number = 3 Temperature = 1000 K Pressure = 1.5 MPa Mach number: The Mach number…

Question

(a) Write Area-Velocity relation for compressible flows through a supersonic Convergent-Divergent nozzle
What is the importance of it?
(b) Write Area-density relation for compressible flows through a supersonic Convergent-Divergent nozzle
What is the importance of it?
(c) Write Area-Mach relation for compressible flows through a supersonic Convergent-Divergent nozzle
What is the importance of it?
(d) Plot the variation of density, pressure, temperature, velocity and Mach number for compressible flows
through a supersonic Convergent-Divergent nozzle
Note: Do NOT derive above relations.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Solution (a)

VIEW

Step 2: Solution (b)

VIEW

Step 3: Solution (c):

VIEW

Solution

VIEW

Step by step

Solved in 4 steps with 5 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

1 atm = 2116 lb/ft2 = 1.01 × 105 N/m2. Consider the isentropic flow through a supersonic wind-tunnel nozzle. Thereservoir properties are T0 = 500 K and p0 = 10 atm. If p = 1 atm at thenozzle exit, calculate the exit temperature and density.
A steady adiabatic flow of perfect gas occurs between sections 1 and 2 of a duct. The Mach numbers at the two sections are equal, but the area at 2 is 4/3 times as large as the area at 1. What is the ratio of stagnation pressures of 2 to 1? is the process is reversible? 0.75 Yes 0.75 No 1.33 Yes 1.33 No
A uniform supersonic flow of air at Mach 3.8, with a stagnation pressure of 5.0 MPa and stagnationtemperature of 1100 K, expands around a 23o convex corner. Determine the downstream Mach
A converging–diverging nozzle with a 4:1 exit-area ratioand p0 = 500 kPa operates in an underexpanded condition as in Fig. The receiver pressureis pa = 10 kPa, which is less than the exit pressure sothat expansion waves form outside the exit. For the givenconditions, what will the Mach number Ma2 and the angleϕ of the edge of the jet be? Assume k = 1.4 as usual.
The weight of the limb is W=15 lbs.The contact of foot with the ground can be modeled as a pin/hinge here. Determine the reaction force of the ground and the reaction at the knee joint and its direction/angle θ. Note: use the thee force member condition to find the angle of FK.Q4.As it’s been shown in the below figure,a person is using an exercise machine. Points A and B correspond to the shoulder and elbow joints, respectively. Relative to the person, the upper arm (AB) is extended toward the left (x-direction) and the lower arm (BC) is extended forward (z-direction). At this instant, the person is holding a handle that is connected by a cable to a suspending weight. The weight applies an upward (in the y-direction) force with magnitude F on the arm at point C. The lengths of the upper arm and lower arm are AB̅̅̅̅= 20cm and BC̅̅̅̅= 25cm, respectively, and the magnitude of the applied force is F = 400 N.Determine the components of reaction developed at the shoulder joint A When the…
4. It is important to remember that the isentropic relations and normal shock relationsare monotonic with Mach number and can be inverted. To illustrate this, consider thefollowing problems, (c) If the temperature jumps from 0 Celsius ahead of a shock to 200 Celsius behinda shock, what is the shock Mach number?(d) If the velocity behind a Mach 5 shock wave is 200 m/s, what is the upstreamvelocity?
An aircraft is flying at 440 km/hr at 3 km on a standard day. What is the aircraft Mach Number?
A normal shock occurs in a stream of oxygen. The oxygen flows at Ma=1.8 and the upstream pressure and temperature are 40 psia and 85 degrees Fahrenheit. a) Calculate the following on the downstream side of the shock: static pressure, stagnation pressure, static temperature, stagnation temperature, static density, and velocity. b)If the Mach number is doubled to 3.6, what will be the resulting values of the parameters listed in part (a)?
Consider steady, isentropic flow of air through a duct with varying area. At section 1, p1 = 60.0 kPa (abs), T1 = 27°C, Vị = 486 m/s. At a downstream section 2, p2 = 78.8 kPa (abs). Determine: a. Mach number, Maz b. sketch geometry of the duct
Consider a typical air flow around a cruising jetliner at 10km altitude. The speed is now 810 km/h, while the ambient conditions are 0.414 kg/m³ , 0.261 atm and -50°C. At the stagnation point, the temperature rises over by 25°C, while the density and pressure changes by more than 30% and 45 % respectively. Classify the following situations as compressible/incompressible flow
I need help on 3a
The velocity ratio(v1/v2)of an isentropic flow through a supersonic wind tunnel is 0.915 ifthe velocity and mach number at the exit are 376.95 m/s and 2.60 respectively find the value of speed of sound at the entrance