a) Write a short code, configuring all the Arduino pins connected to LED as output. b) In the code snippet shown in figure 2, what color will be shown on the LED and for what duration? Note: All the LED pins are switched OFF initially. void loop() { // put your main code here, to run repeatedly: digitalWrite (5, HIGH); delay(500); digitalWrite (5, LOW); delay(500); } Figure 2: c) Modify the code shown in figure 2, so that the LED turns ON as Yellow for 250 ms and then OFF for 750 ms. Hint: Yellow coloured light is a combination of Green and red colour

a) Write a short code, configuring all the Arduino pins connected to LED as output. b) In the code snippet shown in figure 2, what color will be shown on the LED and for what duration? Note: All the LED pins are switched OFF initially. void loop() { // put your main code here, to run repeatedly: digitalWrite (5, HIGH); delay(500); digitalWrite (5, LOW); delay(500); } Figure 2: c) Modify the code shown in figure 2, so that the LED turns ON as Yellow for 250 ms and then OFF for 750 ms. Hint: Yellow coloured light is a combination of Green and red colour

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

(a) Consider the flipflop circuits below: (i) Name the 2 circuits given in the figure. Explain how they are different from each other. a. b. (ii) Choose from the list the input that triggers data to travel to the next flipflop in a counter. A: Input at top NAND gate B: Input at bottom NAND gate C: Clock input clk Q
Q3. Briefly explain CISC and RISC processing unit architectures?
(i) Draw the block diagram for getting controlled AC output voltage from AC input voltage by using AC voltage controller. (ii) Briefly discuss about 120° mode operation of 3 phase inverter.
What does the Arduino instruction pinmode do in the Traffic Light program?
5- Discuss the effect of changing the number of bits on the recovered analog waveform. 6- Discuss the effect of changing the frequency of input analog signal on the reconstructed analog output signal.
4) a) Draw a diagram showing the following circuits 1: Ring, Radial and Spur circuits, label appropriately. b) Sketch a TN-C earthing system. Label appropriately. c) What is ATS? d) List 2 transition types and explain one with a sketch, the stages of operation. e) List 2 modes of operation of an ATS.
2) Convert Hexa-decimal to Octal a. 7E6A(16)=?(8) b. C350(16)=?(8) c. 9E36.7A(16)=?(8) d. EADD.EBEF(16)-?(8)
Cnuu IC. 2- Design (64-1) multiplexer by using (8-1) multiplexers without enable.
Conversion of digital signal to analog signal is a. Modulation b. Demodulation c. Encapsulation d. Bypass
Draw the schematic of a modulo-6 syncrhonous counter (counting sequence is 010, 110, ...). The counter has the following features: Asynchronous Reset is Active High A value D can be loaded into the counter, using the Load signal, which is Active Low.
is a device that selects one of many inputs and links it to a single output. a Display of seven segments Demultiplexer, ob. Generator of parity Multiplexer, Od.
Task: Complete the observation table, write logic expression of the given circuit and attach simulation screen shot using multi-sim. Circuit Diagram A LED 1kOhm Figure 1.2 1) Logic expression for the given logic diagram: 2) Observations: