A wind tunnel is considered to be a steady-state operation, the system receives one hundred fifty pound- mass per minute of air at 200 psfg and 240 degrees Fahrenheit. The fluid is discharged from a point five meters above the datum/ reference point at 4,155 psf and 550 degrees Fahrenheit. Assuming that the velocity found at the inlet is 7,005 feet per minute and the Heat supplied is 515 BTU/min. During the process the density decreases by 15 percent and the internal energy is decreased by 1.05 horsepower. Determine the Work done in (a) Horsepower and BTU/s. (b) Considering the given on 3a, if the Work done is doubled, determine the Heat supplied during the process? (c) Considering the given on 3b, if Heat is doubled, what is the work done after 9 minutes?

A wind tunnel is considered to be a steady-state operation, the system receives one hundred fifty pound- mass per minute of air at 200 psfg and 240 degrees Fahrenheit. The fluid is discharged from a point five meters above the datum/ reference point at 4,155 psf and 550 degrees Fahrenheit. Assuming that the velocity found at the inlet is 7,005 feet per minute and the Heat supplied is 515 BTU/min. During the process the density decreases by 15 percent and the internal energy is decreased by 1.05 horsepower. Determine the Work done in (a) Horsepower and BTU/s. (b) Considering the given on 3a, if the Work done is doubled, determine the Heat supplied during the process? (c) Considering the given on 3b, if Heat is doubled, what is the work done after 9 minutes?

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A reciprocating compressor draws in 500 cubic feet per minute of air whose density is 0.079 ft/cu. ft and discharges it with a density of 0.304 lb/cu. ft. At the suction, P, = 15 Psia; at discharge, P2 80 psia. The increase in the specific internal energy is 33.8 BTu/lb and the heat transferred from the air by cooling is 13Btu/lb. Determine the work on the air in BTU/min and in hp. Neglect kinetic energy.
Water is to be pumped from the bottom of a well 20 ft deep and 160ft above the ground with a specific heat of 1 BTU/lbm F is pumped using a 1-hp jet pump. Heat is lost from the whole system at the constant rate of 500 BTU/min. What is the temperature (℉) of the water as it enters the vessel if the flow rate of the water is 5 gal/min?assuming that the well water is at 35℉? kindly show all necessary calculations
Apply the first law of thermodynamics to flow system with two inlets and one outlet. Assume that heat is supplied to the system. Draw the neat sketch and lable inlet and outlet properties
If you had a fixed mass of hot air stored in a rigid container and decided to transfer heat from the air until the pressure dropped to a set value, what would the resulting change in entropy of the system AS air (kJ/K) be and what would the entropy change of the universe AS universe (kJ/K) be? Assume: m = 2 kg V = 2 m³ T₁ = 300 °C P2 = 120 kPa Tsurroundings = 27 °℃
An ideal gas passes a diffuser. At the diffuser inlet, the temperature is T1 = 350.00 K, the pressure P1 = 100.00 kPa, the velocity V1 = 200.00 m/s, and the inlet area A1 = 0.30 m2. At the exit, the velocity is very small. The specific heat of the ideal gas at the constant pressure is cp = 1.0050 kJ/(kg·K). The gas constant is R = 0.2870 kPa·m3/(kg·K). Determine the enthalpy per unit mass at the inlet, h1__________(kJ/kg)
An ideal gas passes a diffuser. At the diffuser inlet, the temperature is T1 = 350.00 K, the pressure P1 = 100.00 kPa, the velocity V1 = 200.00 m/s, and the inlet area A1 = 0.30 m2. At the exit, the velocity is very small. The specific heat of the ideal gas at the constant pressure is cp = 1.0050 kJ/(kg·K). The gas constant is R = 0.2870 kPa·m3/(kg·K). Determine the enthalpy per unit mass at the exit, h2__________(kJ/kg)
An ideal gas passes a diffuser. At the diffuser inlet, the temperature is T1 = 350.00 K, the pressure P1 = 100.00 kPa, the velocity V1 = 200.00 m/s, and the inlet area A1 = 0.30 m2. At the exit, the velocity is very small. The specific heat of the ideal gas at the constant pressure is cp = 1.0050 kJ/(kg·K). The gas constant is R = 0.2870 kPa·m3/(kg·K). Determine the density at the inlet, ρ1 __________(kg/m3)
An ideal gas passes a diffuser. At the diffuser inlet, the temperature is T1 = 350.00 K, the pressure P1 = 100.00 kPa, the velocity V1 = 200.00 m/s, and the inlet area A1 = 0.30 m2. At the exit, the velocity is very small. The specific heat of the ideal gas at the constant pressure is cp = 1.0050 kJ/(kg·K). The gas constant is R = 0.2870 kPa·m3/(kg·K). Determine the temperature at the exit, T2__________(K)
I need help with this problem
A reciprocating compressor draws in 500 cubic feet per minute of air whose density is 0.079 lb/cu.ft and discharges it with a density of 0.304 lb/cu.ft. At the suction, p1= 15 psia; at discharge, p2= 80 psia. The increase in the specific internal energy is 33.8 Btu/lb and the heat transferred from the air by cooling is 13 Btu/lb. Determine the work on the air in Btu/min and in hp. Neglect change in kinetic energy.
Water is to be pumped from the bottom of a well 20 ft deep with a specific heat of 1 BTU/lbm F is pumped using a 1-hp jet pump. Heat is lost from the whole system at the constant rate of 500 BTU/min. What is the temperature (℉) of the water as it enters the storage tank assuming that the well water is at 35℉?
In a cooling tower, it is known that the water inlet temperature is 43 ° C, the water outlet temperature is 21 ° C, and the water flow rate is 600 L / h. Calculate the heat given by the water to the air by taking these values into account. (Cp water = 4.18kj / (kg ° K))