(a) What is the function of Digital to Analog Converter (DAC)? Mention its types. Write the truth table of 3 bit DAC.

Q: Operational amplifiers or Op-Amp, has long been used. The early usage of this device were mainly for…

A: An Operational Amplifier is an analog Block which  takes input as voltage and produces single ended…

Q: Using a circuit diagram, describe the operation of linear shunt regulators

A:

Q: occurs when the input waveform is changing at a rate th ch the op-amp output can change. (In other…

A: Op amps can give output without any distortion if input signal frequency lies with in the specified…

Q: Construct the closed-loop control block diagram for the temperature control system. Include the…

A: The following is the block diagram of a closed-loop system for temperature control in an electric…

Q: determine the controller gains. Also comment on EMI / EMC of half bridge converter.

A: The controller gains: The regulator gain characterizes the strength of regulator reaction…

Q: 1. Describe some of the characteristics of a practical op-amp. 2. What does a differential amplifier…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Assume that even though the supply voltages are not shown, the op-amp remains in the linear region…

A: Consider that the  Va is voltage at + terminal pf op-amp. Apply voltage division rule.

Q: A 6-bit DAC with ladder structure a) Explain the working principle. b) Draw the circuit diagram. C)…

A: For a 6-bit DAC with ladder structure a) Explain the working principle. b) Draw the circuit diagram.…

Q: Inlet flow rate Flow measurement Outlet Valve pressure , flow rate| Height reference h (height)…

A: Before Getting in to the question Lets discuss feedforward and feedback path feedforward Path:…

Q: c) Design a non-inverting Schmitt trigger circuit with an upper trigger point UTP = 3.1V and lower…

A: Since you have posted multiple different question. we will solve the first question for you. To get…

Q: 1. How does the buck converter achieve very high gain at the DC?

A: There are two different questions and you have not mentioned which question to do. We are supposed…

Q: efine the term transducer? Briefly explain the procedure for the selection of transducer to some…

A: Transducer: An electronic device which converts one form of energy to other form is transducer. It…

Q: The automatic control system for the temperature of a bath of liquid consists of a reference voltage…

A: The reference input could be a knob that allow you to select the desired set point. This signal as…

Q: What is the differential gain of the differnce stage of the instrumentation apmplifier?   What is…

A:

Q: V. out ww R, = 2KO R,= 10KO

A: The solution is given below

Q: State whether the following statement is true or false. “Voltage regulation in an LDO is achieved by…

A: In this question we will write voltage regulation in an LDO(low drop out voltage regulator)...

Q: Explain the difference between feedforward concurrent and feedback control

A: Control will concentrate on events before, during, or once a method. These sorts of controls square…

Q: Write the state-space representation of the system below. Let the output of the mechanical system is…

A: The mechanical system can be redrawn as According to the…

Q: Q4) Specify the correct answer for the following: 1- Open loop control is a system with: A-…

A: 1. A system is said to be open loop if output has no effect on the input .

Q: In a generalised control system with feedback the value of the forward gain is 831, and the gain of…

A: This is a problem of feedback amplifier. The detailed solution is given in the next step

Q: in the feedback control system below a) find the transfer function b) what should be the gain K for…

A:

Q: 3. For the power amplifier circuit in Figure A: d) If the circuit is biased at its center voltage…

A: The given circuit is shown below:

Q: What are the different types of Feedback Amplifiers used in practical applications?

A: Feedback amplifiers are widely used in various practical applications such as audio amplifiers,…

Q: a) Given a non inverting op – amp below, what should be the operating frequency to have a high…

A: (a) Gain(dB)=40 Higher cutoff frequency=20 KHz40=20logAoAo=100For 10% lower gain,A=0.9AoConsidering…

Q: List the characteristics of a good 360-degree feedback system.

A: Important characteristics of effective 360 degree feedback system is given below. ownership of the…

Q: The oscillation frequency ofthe oscillation circuit is usually determined by ( ) A.Magnification…

A: We need to select correct option for oscillation frequency of the oscillation circuit.

Q: 1.What are the basic requirements to achieve a good feedback control system?

A: Few of the basic requirement for the good control system

Q: 15 ps

A:

Q: Determine the range of gain, K that will make the system below stable. Note: This is a closed loop…

A:

Q: A device has an input signal-to-noise ratio of 300 and an output signal-to-noise ratio of 14. What…

A: Signal-to-noise ratio is usually expressed in decibels (dB). The signal-to-noise ratio is a…

Q: Define, in words, sensitivity and describe the goal of feedback control system engineering as it…

A:

Q: Suppose  we  apply  proportional  feedback  control  to  the  system. For  what  range  of  Kp  is…

A: In the control system,  The proportional feedback control to the system is applied.  what range of…

Q: If you had a 1 kHz signal to display, which of these horizontal sensitivity control (time/div)…

A: To select the proper options

Q: control system Consider the total harmonic distortion of a closed loop system is 5%. Distortion…

A:

Q: A- Explain the Colpitts oscillator and determine the way to eliminate the effects of a loading of…

A: In the Colpitts oscillator, the transistor s connected to the tank circuit which consists of the two…

Q: Choose the correct option and explain... In order to connect a LED to one of the pins a)You need to…

A: Answer: a)You need to define that LED as an OUTPUT in the setup function Explanation: a. The setup…

Q: can you calculate the gain of the opamp,input and output voltage. Thank you.. Adaptor Voltage…

A:

Q: Discuss the effect of changing the value of the feedback resistor on the output voltage

A:

Q: Write the state-space representation of the circuit below. vi (t) R1 1.00 L1 1.0H R2 1.00 L2 31.0H…

A:

Q: It was not necessary to use any coupling capacitors for the circuits in the(Linear Op-Amp Circuits)…

A: In general capacitors blocks the DC signal for the filtration of ripples. Purpose of op amp is to…

Q: Explain the feedback and feedforward control systems in detail by drawing process examples.

A: Step-1-> Feedback control system-> By contrasting the target output with the actual output and…

Q: here are two(2) approaches available for the analysis and design of feedback control ystems which…

A: Analysis of mathematical functions , experimental data and physical signals with respect to time is…

Q: 1. Explain in your own words the control process of a dominant ON and dominant OFF. 2. What is the…

A: SOLUTION DOMINANT ON   Such A control process in which Start Button(ON)…

Q: Define feedback mechanism, and provide two examples.

A: Control system: A system that contains input and output, So, for getting a desired response or…

Q: Solve all the needed parameters like currents and voltages on each circuit provided. Avoid identical…

A: