A well was constructed to pump water from a confined aquifer. Two observation wells were constructed at distances of 350 m and 800m respectively. At a steady pumping rate of 0.39 m^3/min, the drawdown in the observation wells were respectively equal to 1.6 m and 7.8 m. Diameter of the test well is 0.95 m and thickness of confined aquifer is 16 m. a. Determine the hydraulic conductivity of the soil in m/min. (IN EXPONENTIAL FORM AND IN 2 DECIMAL PLACES) b. Determine the drawdown at the test well in m. (IN 2 DECIMAL PLACES) c. What is the value of the transmissivity of the confined aquifer in m^2/day? (IN 2 DECIMAL PLACES)

A well was constructed to pump water from a confined aquifer. Two observation wells were constructed at distances of 350 m and 800m respectively. At a steady pumping rate of 0.39 m^3/min, the drawdown in the observation wells were respectively equal to 1.6 m and 7.8 m. Diameter of the test well is 0.95 m and thickness of confined aquifer is 16 m. a. Determine the hydraulic conductivity of the soil in m/min. (IN EXPONENTIAL FORM AND IN 2 DECIMAL PLACES) b. Determine the drawdown at the test well in m. (IN 2 DECIMAL PLACES) c. What is the value of the transmissivity of the confined aquifer in m^2/day? (IN 2 DECIMAL PLACES)

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Could you help me answer the following question? Thank you A fully penetrating pumping well extracts groundwater from a confined aquifer with a pumping rate of 750 m3/day. The hydraulic conductivity of the aquifer is 10 m/day and the saturated thickness is 50 m. The drawdown of the aquifer from this pumping well is insignificant at a distance of 1000 m from the pumping well. At what distance from the pumping well is the drawdown 10 cm? Assume the hydraulic gradient is negligible in the local area. Transmissivity T = 1746.76 gal/min/ft Hydraulic conductivity = 11.645 gal/min/ft2 Storativity = 0.809 The drawdown on Jenny’s Well by the end of August. =0.6902 ft. Observation well situated is 69.7 ft away from the pumping well (which is pumping at the rate of 305 gal/min). The aquifer is confined, and the depth has been measured from well logs and is 150 ft. The data for time (t) and drawdown (s) is given below: t (min) s (ft) 0.072 0.003 0.105 0.006 0.155 0.012…
An unconfined aquifer is 100 feet thick was evaluated using a field pumping test. The depth to groundwater is 10 feet. At a distance of 1000 feet, the drawdown was 40 feet, and at a distance of 5000 feet it was 20 feet. Find the permeability of the aquifer assuming that a steady-state of 960 gal/minute during the test in ft/sec.
A site consists of a homogenous dense silty sand layerof 8m thickness which is underlain by an imprevious stiff clau stratum. The initial water table was at 3m depth below the ground level. A pumping test was carrier out by pumping water at the rate of 0.7 m^3/min. Onservation wells were dug into the ground at 25m and 50m distances from the center line of the well. At steady state (i.e., when there was no change in water levels in the observation wells), the water levels in the two wells dropped by 500mm and 150mm, respectively. Determine the hydraulic conductivity of the clay sand layer.
A well penetrates an unconfined aquifer, with undisturbed water level (ho) equal to 21m. After pumping the well at a constant rate of Q = 0.07 m/s, the steady-state drawdown at distances of 45 m and 110 m from the well are 3 m and 1 m. respectively. Assume the void ratio as 0.2. Compute the hydraulic conductivity of the aquifer. 215.0 m/day what is the porosity 0.16 find the darcy velocity in m/day 69.4 m/day
A 400 mm diameter test well penetrates 27 m below the static water table. After 24 hours of pumping at 75 liters/sec, the water level in an observation well at a distance of 100 m from the test well is lowered 0.35 m. The other observation well at a distance of 40 m from the test well has a drawdown of 0.97 m. Compute the transmissibility of the aquifer in m?/day.
4
In a field testing, the hydraulic gradient between two peizometers is 1.11, the area of flow is 4.08 m2 and the hydraulic conductivity of the aquifer material is 0.94 m/day, calculate the discharge in m3/day. Note that discharge cannot be negative
Problem (4) The following results have been reported for field pumping test from a well, where the top permeable layer is unconfined and underlain by an impermeable layer, for a steady state condition: m3 q = 0.68 min h, = 5.6m at r, = 60m h, = 5m at r, = 30m Calculate the hydraulic conductivity (cm/s) of the permeable layer.