A water storage tank is an upside-down cone, as top is 12 feet and the length of the sloping side is shown in Figure 8.40. If the diameter of the circular 10 feet, how much water will the tank hold? 12 ft 10 ft

Q: What is the circumference of the circle if a chord 8cm long is 3cm away from the center of the…

A: Given: A chord 8 cm long is 3 cm away from the center of the circle. To Find: The circumference of…

Q: The

A:

Q: the minute hand of a clock is 6 ft long. How far does the point of the hand move in one hour

A:

Q: Please see attached image for the question!

A:

Q: Determine the surface area of the geometric figure: 3.2 ft 3 ft 2.4ft 3.2 ft 6 ft

A: Find the area of geometry figure

Q: What is the area of the triangular region created by the coordinates below in square units? (0, 9).…

A:

Q: The sides of the parallelogram are 8cm and 12cm, find the shorter diagonal and the area if the…

A: Given-  The sides of the parallelogram are 8cm and 12cm. To Find- The shorter diagonal and the area…

Q: 156 ft

A:

Q: How far will a wheel with radius 14cm travel in TWO revolutions? Give your answer to the nearest…

A: To find the distance covered by the wheel in two revolutions

Q: The empire state building is 1250 ft tall and approximately 3.0 mi from the brooklyn bridge. From…

A:

Q: if a 25 ft tall casts an 8 ft long shadow, then how tall is a tent that casts a 3ft shadow? sketch…

A:

Q: A right triangle has a hypotenuse of length 11 units and includes a 40° angle. What are the lengths…

A:

Q: If a parabolic reflector of an automobile head light is 12 in. in diameter and 4 in. deep, what is…

A: To determine the area of the reflector of the headlight, lets consider the vertical cross section of…

Cylinders

A cylinder is a three-dimensional solid shape with two parallel and congruent circular bases, joined by a curved surface at a fixed distance. A cylinder has an infinite curvilinear surface.

Cones

A cone is a three-dimensional solid shape having a flat base and a pointed edge at the top. The flat base of the cone tapers smoothly to form the pointed edge known as the apex. The flat base of the cone can either be circular or elliptical. A cone is drawn by joining the apex to all points on the base, using segments, lines, or half-lines, provided that the apex and the base both are in different planes.