Answered: A water pipe having a 2.47 cm inside… | bartleby

Related questions

Question

A water pipe having a 2.47 cm inside diameter
carries water into the basement of a house at a
speed of 0.766 m/s and a pressure of 203 kPa. If the
pipe tapers to 1.00 cm and rises to the second floor
6.29 m above the input point, what are the (a) speed
and (b) water pressure at the second floor?
(a) Number
i
Units
(b) Number
i
Units
<>
<>

Expert Solution

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

A water pipe has a 3.0 cm inside diameter and carries water into the basement of a house. At the basement, the water speed is 1.20 ms−1 and the pressure exerted is 190 kPa. The pipe then tapers to 1.5 cm inside diameter as it rises to the second floor, which is 8.5 m above the input point. Calculate: a) the speed of the water on the second floor.b) the water pressure on the second floor
The drawing shows an intravenous feeding. With the distance shown, nutrient solution (p = 1040 kg/m³) can just barely enter the blood in the vein. What is the gauge pressure of the venous blood? Express your answer in millimeters of mercury. Number i Units Atmospheric pressure > en 0.610 m
A 2.0 cm diameter pipe carries water into a house with a pressure of 4.00 x 10^5 Pa and with an inflow speed of 1.5 m / s. A second tube of 1.0 cm in diameter and that it is connected to the main pipe carries water to a bath that is in a second floor at 5.0 m high. Find (a) the speed of the water flow (b) the pressure and (c) the ratio of volume flow (in liters per second), in the bath
A sealed tank containing seawater to a height of 12.0 m also contains air above the water at a gauge pressure of 3.05 atm. Water flows out from the bottom through a small hole. Calculate the speed with which the water comes out of the tank. Express your answer in meters per second.
A sump pump (used to drain water from the basement of houses built below the water table) is draining a flooded basement at the rate of 0.75 L/s, with an output pressure of 1.5×10^5 Pa. (a) The water enters a hose with a 2.8 cm inside diameter and rises 2.2 m above the pump. What is its pressure at this point? (b) The hose goes over the foundation wall, losing 0.55 m in height, and widens to 6.6 cm in diameter. What is the pressure now? You may neglect frictional losses in both parts of the problem.
A water pipe having a 2.92 cm inside diameter carries water into the basement of a house at a speed of 0.936 m/s and a pressure of 185 kPa. If the pipe tapers to 1.57 cm and rises to the second floor 6.94 m above the input point, what are the (a) speed and (b) water pressure at the second floor?