A vertical jet of water leaves a nozzle at a speed of 10 m/s and a diameter of 20 m. It suspends a plate having a mass of 1.5 kg, as shown in Figure Q2. The weight of water jet is negligible. (a) Draw an appropriate control volume for the water jet indicating all velocities and force components acting on it. (b) Calculate the anchoring force acting on the water jet. (c) Calculate the mass flow rate of the water jet exiting the nozzle.

Q: 50 cm Water m kg/s 2 50 cm FR. Water If another (identical) elbow is attached to the existing elbow…

A:

Q: neqaned mormation A 90° elbow in a horizontal pipe is used to direct water flow upward at a rate of…

A: Diameter of elbow=10cm = 0.1m Momentum flux correction factor=1.03

Q: The double pulley shown weighs 15 kg and has a centroidal radius of gyration of 160 mm. Cylinder A…

A:

Q: A water tank on a column has a mass of 4000 kg. The supporting column is assumed to be massless and…

A:

Q: A reducing elbow is used to deflect water flow at a rate of 14 kg/s in a horizontal pipe upward 30°…

A: Given data:m=14 kg/s˙A1=113 cm2A2=7 cm2h=30 cm

Q: The tank shown has one curved surface restraining a body of static fluid, with the following…

A: To determine the magnitude of the resultant force on the curved surface.   Given, Width of the tank…

Q: block of mass 25 kg was travelling on a rough horizontal face having a coefficient of kinetic…

A:

Q: A horizontal nozzle of 30 mm diameter discharges a steady jet of water into the atmosphere at a rate…

A: Given- Diameter of nozzle d=30 mm, Discharge Q=15 litres/s, Diameter of inlet of nozzle = 100 mm, It…

Q: How high will liquid rise in the piezometers of shown in the figure if the pressure at M is liquid…

A: Given data in question  Pressure at point M Specific gravity To find out  Height h Note Acceleration…

Q: The system in the figure shows fours applied forces and a 50 kN-m couple, answer the following…

A: Find The line of action of the resultant force is at a perpendicular distance.m from point A

Q: The double pulley shown weighs 15 kg and has a centroidal radius of gyration of 160 mm. Cylinder A…

A:

Q: Calculate the horizontal displacement of the C point in the system shown in the figure

A: Use Virtual Work Method (Unit Load Method) Consider the free body diagram of the given frame as…

Q: A 30m long dam is made to with-stand 750kN of water pressure. The maximum height of the water it can…

A: Step 1:Step 2:Step 3:

Q: 4. A 60-cm-wide belt moves as shown in the figure. Calculate the horsepower requirement assuming a…

A:

Q: Show Attempt History Current Attempt in Progress (Buoyancy, force on plane surface) A cube, 4.3 ft…

A:

Q: As you have seen in lectures (and in Lab 3), the height above the pipe centre to which water rises…

A: Given data in question  Discharge 0.025 m3/s Diameter 20 cm and 15 cm Length 5m To find out  Head…

Q: A reservoir contains water has a vertical circular orifice 25.2mm diameter and is first plugged up…

A: Given : H = 2.785m QL = 141 lt/min = 2.35 × 10-3 m3/sec   Cc, Cv, and Cd are the hydraulic…

Q: A figure shows a differential manometer connected at 2 points A and B. At A pressure is 100 kn/m^2.…

A:

Q: Find the amount of force required to hold the tube in the figure below in place. The result of the…

A: Question is based on the bent tube . Discharge through tube and pressure in pipe are given in the…

Q: (Buoyancy, force on plane surface) A cube, 3.6 ft on a side, weighs 2920 lb and floats half-…

A:

Q: For the system shown, the masses of A and B are 55 kg and 135 kg, respectively. The 20° coefficient…

A:

Q: Calculate the resistive force acting on the disk, with the error level not less than h4, according…

A: Given, r(m) P(kN) 0 6.34 0.05 6.28 0.1 6.06 0.15 5.72 0.2 5.1 0.25 4.78 0.3 4.37…

Q: What is the magnitude of the theoretical hydrostatic force in Newtons? b) What is the magnitude of…

A: Hydrostatic force: - It is defined as a force caused by liquid on a submerged body.

Q: The maximum diameter that a capillary tube have to ensure that a capillary rise of at least mm is…

A: Capillary rise = 6 mmSurface tension = 0.08 N/mDensity = 900 kg/m3We are asked to determine the…

Q: Figure (3) shows the arrangement of a set of pulleys, a spring, and a smooth contact position that…

A:

Q: (Buoyancy, force on plane surface) A cube, 4.9 ft on a side, weighs 2900 lb and floats…

A: To Determine :- Hydrostatic force FR Distance from free water surface to Centre of pressure along…

Q: Question- The capillary rise of water is 3cm in a tube. Find the diameter (mm) of tube if surface…

A: Capillary rise h=3 cm=0.03 m, Surface tension s=0.075 N/m, Diameter of the tube = ?

Q: A converging tube discharges water from a reservoir, into the air, at depth of 6 ft below the water…

A: step 1-

Q: Explain with figure a process called oscillating water column. Give one point about the history of…

A: The oscillating water column concept is one of the best concepts to harness the energy from the…

Q: depth

A: Draw the illustration of given data

Q: 3) Figure (3) shows the arrangement of a set of pulleys, a spring, and a smooth contact position…

A:

Electronic Spreadsheet

Tabular listing has many advantages ranging from time management to efficient scheduling of tasks. Electronic spreadsheets allow the user to tabulate and analyze data, using its easy-to-use interface. An electronic spreadsheet is a staple application used among accountants, management staff, and IT professionals. It is used in various sectors worldwide for data management. An electronic spreadsheet is a system and computer software that could be used to do numerical computations automatically. Spreadsheet application programs are often organized as a table with rows and columns. Each row and column intersect to form a cell, which may be used to store data. These data can take the form of a written label, a number, or a formula that combines information from other cells.