A vapor compression refrigeration cycle uses refrigerant-134a as its working fluid. The condenser pressure is 800 kPa and the evaporator temperature is -20 C. The compressor has an isentropic efficiency of 80 percent. The mass flow rate is 1.7489 kg/s. In the question that follows, select the answer that is closest to the true value. What is the heat going to the evaporator in units of kW?

A vapor compression refrigeration cycle uses refrigerant-134a as its working fluid. The condenser pressure is 800 kPa and the evaporator temperature is -20 C. The compressor has an isentropic efficiency of 80 percent. The mass flow rate is 1.7489 kg/s. In the question that follows, select the answer that is closest to the true value. What is the heat going to the evaporator in units of kW?

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Refrigerant 22 is the working fluid in a Carnot vapor refrigeration cycle for which the evaporator temperature is -30°C. Saturated vapor enters the condenser at 36°C, and saturated liquid exits at the same temperature. The mass flow rate of refrigerant is 10 kg/min. Determine the quality of refrigerant at inlet of compressor,
The figure below shows a two-stage vapor-compression refrigeration system with ammonia as the working fluid. The system uses a direct-contact heat exchanger to achieve intercooling. The evaporator has a refrigerating capacity of 40 tons and produces -30°F saturated vapor at its exit. In the first compressor stage, the refrigerant is compressed adiabatically to 140 lbf/in.², which is the pressure in the direct contact heat exchanger. Saturated vapor at 140 lbf/in.² enters the second compressor stage and is compressed adiabatically to 250 lbf/in.² Each compressor stage has an isentropic efficiency of 85%. There are no significant pressure drops as the refrigerant passes through the heat exchangers. Saturated liquid enters each expansion valve. Determine: Expansion valve 6- Condenser Direct contact heat exchanger Expansion valve (a) the ratio of mass flow rates, m3/my. (b) the power input to each compressor stage, in horsepower. (c) the coefficient of performance Comp Comp Evaporator
Required information Refrigerant-134a enters the condenser of a steady-flow Carnot refrigerator as a saturated vapor at 65.0 psia, and it leaves with a quality of 0.05. The heat absorption from the refrigerated space takes place at a pressure of 30 psia. Determine the coefficient of performance. (Round the final answer to three decimal places.) The coefficient of performance is
A refrigeration system with a capacity of 15 tons of refrigeration, operates at 150 kPa in the evaporator, while in the condenser it is 1000 kPa. If the R-134a refrigerant is in a saturated state, calculate the theoretical power required to operate the compressor. Compressor Power = Answer kW
An NH; vapor compression refrigeration system has a condensing temperature of 25°C and an evaporating temperature of -10°C. The refrigerating capacity is 7 tons. If the suction vapor was superheated from -10°C to 10 C, Determine: a) refrigerant flow rate; b) Volumetric flow at compressor suction; c) theoretical power required; d) Heat rejected in the condenser; e) Refrigerating Effect; f) COP
Can you also show the T-s and P-h diagrams? A Single Stage Vapor Compression (SSVC) refrigeration system has a cooling capacity of 6 tons. The discharge of the evaporator is at -20°C & 0.1 MPa and the discharge of the condenser is at 30°C & 1.0 MPa. Determine the following: (a) the COP of the system, (b) the Energy Efficiency Ratio in kJ/hr/W, (c) the HP/ton of the system, (d) the Refrigerating Efficiency of the system.
An ammonia refrigerating system has a load of 250 kW and operates at a condensing pressure of 1400 kPa and an evaporating temperature of -20°C. The refrigerant exits at the evaporator with a 5- degree superheat. The vapor enters the compressor suction at 10-degree superheat. The compressed vapor is discharged from the compressor at the condensing pressure and 150°C. The refrigerant exits the condenser as saturated liquid. a. State the enthalpies at each point: Point enthalpy kJ/kg h kJ/kg kJ/kg h2 kJ/kg h3 kJ/kg h4 Answer: kg/sec b. Calculate the mass flow of refrigerant Answer: kW C. Determine the size of the motor drive if the mechanical efficiency of the motor- compressor is 77%. Answer: kW Calculate the total heat rejected in the condenser. d. Determine the refrigerating efficiency of the system. Answer: е.
Determine the cooling capacity and the coefficient of performance of the air conditioning system?
Working fluid is Refrigerant 134a. Vapor-compression refrigeration system has refrigerating capacity = 1650 Btu/hour. Refrigerant enters evaporator at -10F and leaves at 15F. Isentropic compressor efficiency = 74%. Refrigerant condenses at 140F and leaves condenser subcooled at 100F. No large pressure drops through evaporator and condenser. DETERMINE: 1. Pressure of evaporator in lbf/in^2 2. Pressure of condenser in lbf/in^2 3. Mass flow rate in lb/s of refrigerant 134a. 4. Power input in horsepower of compressor. 5. Coefficient of performance.
Refrigerant 22 is the working fluid in a Carnot vapor refrigeration cycle for which the evaporator temperature is -30°C. Saturated vapor enters the condenser at 36°C, and saturated liquid exits at the same temperature. The mass flow rate of refrigerant is 10 kg/min. Determine the quality of refrigerant at inlet of compressor, (A) 0.9430 B 0.6931 C 0.7931 D 0.8931
I need help I missed classes and idk how to do it ! Help