A в с D EFG H Hinge Hinge -8 m -6 m- -4 m--4 m-3 m-3 m- -8 m- FIG. P8.33, P8.34

Q: 12.1 Astronauts who landed on the moon during the Apollo 15, 16, and 17 missions brought back a…

A: The given data is shown below: Mass of rocks=139 lbAcceleration due to gravity on moon=5.3 ft/s2

Q: Draw the influence lines for the vertical reaction and the reaction moment at support A and the…

A: The influence line diagram is used majorly while working in the moving load on the bridge. truss or…

Q: Determne the magnitude of the vertical component of the force per meter length acting on the three…

A:

Q: 16.15 Problems for Solution P16.2 Sections 16.1-16.6 for the situations listed. Both reactions and…

A:

Q: Draw influence lines for this figure below

A: Step 1:Step 2: Step 3: Step 4:

Q: Problem 8.26 Draw the influence lines for the shear and bending moment at point E of the beam shown.…

A: Step 1

Q: Draw the influence lines Pls calculate the FIG 8.6

A: Step 1:Step 2:Step 3:Step 4:

Q: Draw the influence

A: Step 1: Step 2:Step 3: Step 4:

Q: 8.20 Draw the influence lines for the vertical reactions at supports B, E, and G of the beam shown…

A: A beam is shown as

Q: Problem 8.32 Draw the influence lines for the shears and bending moments at points B and E of the…

A: Influence line for shear at B and E is shown below:

Influence Lines

The graphs that show the variation of a function at a specific point on a beam or truss due to a unit load placed at any point along the structure are known as influence lines in engineering. Some common functions that are studied with influence lines are shear, moment, and deflection. In designing beams and trusses, it is important to use influence lines in structures where loads would move along their span such as bridges, crane rails, conveyor belts, floor girders, etc. The influence lines help to study where a load will create the maximum effect for any of the functions.