A V-notch weir is located or cut at one end of a tank having a horizontal square section 10 m x 10 m. If the initial head on the weir is 1.20 m and it takes 377 seconds to discharge 100 cu.m. of water and using correction factor C = 0.60. Determine: a. Vertex angle of the weir. b. Discharged water after 200 seconds. c. Time when the surface drops at 0.80 m.

Q: Give a fire zone area in davao city Philippines

A: When there is a fire, there may be serious injuries, property destruction, or even fatalities. It…

Q: Why is drainage clogging occur?

A: 1)Damaged Pipes-Another major cause of blocked drains is broken pipes. For water to flow freely, it…

Q: Interpret plumbing supply and DWV system design and detailing information.   please answer this…

A: Plumbing: Supply system: The process of providing water to the desired location for purpose of…

Q: What are the electrical devices and how many its quantity on each room? Garage & garden, bedroom 1 &…

A: Brief concept- In any building, electrical devices are needed for the supply of electricity. This…

Q: how many btu's for 3 x 5 single pane exposed to 60 degress

A: Given:

Q: Define Air-handling equipment.

A: Air-handling equipment is defined as the equipment that is used to regulate the temperature of the…

Q: Define electrical profiling method.

A: The electrical profiling method is defined as it is a DC resistivity survey which proposes to trace…

Q: What escalator installation configurations are generally used?

A: Answer Introduction An escalator is a device that is used for transporting people from one floor to…

Q: The minimum number of plumbing facilities required for an auditorium planned for a total 0f 5,500…

A:

Q: 5. A wheel is used to turn a valve stem on a water valve. The wheel radius is 4 inches and the axle…

A: Note:- Hi! Thank you for the question As per the honor code, We’ll answer the first question since…

Q: help please please badly need it

A: solution -  ⇒        Area = 914.4×13.6                         = 12435.84 mm2…