Answered: A uniform where is cut into luo pieces… | bartleby

Related questions

Question

one
A uniform where be cut into luo pieces such that
piece is Cluice as long as other. The tuus fieces
two
are connected in paralled in lift gap
bridge. When a
of
gap of a metee
cesislamer of 2012 is connected in
pacalled in life good of a metée bridge, the neutral
pt. is obtained at distance of 60 cm fom right
Find resistana of avire before it
was calentatred cut into two pieces.
end of
auf.

Expert Solution

Step by step

Solved in 4 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

PAR DOND 123: Two diametrically opposite points of a metal ring are connected to two terminals of the left gap of a meter bridge. In a right gap a resistance of 15 2 is introduced. If the null point is obtained at a distance of 40 cm from left end, find the resistance of wire bent in the shape of the ring,
A 200 ohms resistor and a 5000 micro farad capacitor is connected in series with a 10V battery. Find time consta d of the capacitor.Also determine initial current through the circuit.
Q 15 please
The current in a conductor varies as follows: during the first 8 seconds there is a linear change from zeroto 4 amperes; during the next 15 seconds the current is constant at 4 amperes; during a third period of 20seconds the current decreases linearly to 3 amperes. Determine the total charge transferred in theelapsed time of 43 seconds and the average current.
If we stretch a copper rod, making it 0.1% longer,a) How much would its resistance vary?b) What behavior do we assume for copper in deformation?
(a) A defibrillator sends a 6.00-A current through the chest of a patient by applying a 10,000-V potential as in the figure below. What is the resistance of the path? (b) The defibrillator paddles make contact with the patient through a conducting gel that greatly reduces the path resistance. Discuss thedifficulties that would ensue if a larger voltage were used to produce the same current through the patient, but with the path having perhaps 50 times the resistance. (Hint: The current must be about the same, so a higher voltage would imply greater power. Use this equation for power: P = I 2R .)
A copper cable is designed to carry a current of 300. A witha power loss of 2.00 W/m. What is the required radius ofthis cable?
Q 18 please
I 는V R A 5 volt battery is connected to a 20 resistor as shown. What will the resulting current be? ww
A) find the equivalent resistance of the circuit and B) the current through the battery simplify the cicruit. show all steps
Q 12 please
Two identical resistors are connected in series across the terminals of a battery with a voltage V anda current I flows through the circuit. If one of the resistors is removed from the circuit and theremaining one connected across the terminals of the battery, how much current would flow throughthe circuit?