A uniform solid sphere having mass M = 85.0 g and a radius R = 0.70 m rolls on a horizontal surface and then rolls up an incline at an angle of 60.0º as shown below in Figure 2. At the bottom of the incline, the sphere's center of mass has a translational speed of 5.8 m/s. If the frictional losses are negligible, how far does the sphere travel up along the incline?

A uniform solid sphere having mass M = 85.0 g and a radius R = 0.70 m rolls on a horizontal surface and then rolls up an incline at an angle of 60.0º as shown below in Figure 2. At the bottom of the incline, the sphere's center of mass has a translational speed of 5.8 m/s. If the frictional losses are negligible, how far does the sphere travel up along the incline?

Similar questions

A uniform solid ball rolls without slipping down a plane which is inclined at 31° to the horizontal. If the ball has a radius r=0.4m, a mass m=0.1 kg and starts from rest, find: a) the speed of the ball after it travels 2m down the incline. b) at this point, what is the angular momentum of the ball? c) If the coefficient of friction between the ball and the plane is 0.25, what is the maximum angle of inclination that allows the ball to roll without slipping?
A frictionless pulley has the shape of a uniform solid disk of mass 2.90 kg and radius 10 cm. A 1.30 kg stone is attached to a very light wire that is wrapped around the rim of the pulley (the figure (Figure 1)), and the system is released from rest. How far must the stone fall so that the pulley has 3.40 J of kinetic energy? What percent of the total kinetic energy does the pulley have?
A particle with mass 0.025kg is attached to massless cord passing through a hole in the surface. The block is originally revolving at a distance of 0.30m from the hole with an angular speed of 1.75 rad/s. The cord is then pulled from below, shortening the radius of the circle to 0.15m What is the new angular speed? How much work was done in pulling the cord?
A solid cylinder with mass m, radius R, and rotational inertia I (about its center) is released from rest and rolls down a ramp. Friction between the bottom of the cylinder and the ramp causes the cylinder to roll without slipping. The linear acceleration of the cylinder is a. Which TWO of the equations below are correct for this scenario? The equations are in terms of m, I, R, and a, as well as f (the force of static friction between the cylinder and the ramp) and g. (You must pick BOTH of them to get this question correct!) f = ma mg sin θ = ma mg sin θ - f = ma f R = I (a/R) mg sin θ - f = I (a/R) R mg sin θ = IaR
A flywheel is a solid disk that rotates about an axis that is perpendicular to the disk at its center. Rotating flywheels provide a means for storing energy in the form of rotational kinetic energy and are being considered as a possible alternative to batteries in electric cars. The gasoline burned in a 144-mile trip in a typical midsize car produces about 1.05 x 109 J of energy. How fast would a 18.7-kg flywheel with a radius of 0.247 m have to rotate to store this much energy? Give your answer in rev/min.
For each question, use degrees NOT radians. Healthcare professionals, when measuring range of motion (ROM) and isokinetic strength, use degrees - so this assignment will use answers in degrees as well. A person is laying on their stomach doing a hamstring curl. They go from fully extended (0o) to 130o of flexion. What is their angular displacement if the person is on their stomach with their head facing left (feet pointing right)?
A skater spins about a fixed point on the ice. She begins with her arms extended and an initial angular velocity wo. She then pulls her arms in to her body. After her arms are pulled to her body, she spins with an angular velocity final ,wf . Throughout the time she is spinning, no external forces are acting in the horizontal plane. How do the magnitudes of the initial and final angular velocities compare? OA. Wo > Wf OB. WO = wf w0 < wf OE. ооо оо
A 320-N sphere 0.20 m in radius rolls without slipping 6.0 m down a ramp that is inclined at 25° with the horizontal. What is the angular speed of the sphere at the bottom of the slope if it starts from rest? ____rad/s
A large grinding wheel in the shape of a solid cylinder of radius 0.330 m is free to rotate on a frictionless, vertical axle. A constant tangential force of 280 N applied to its edge causes the wheel to have an angular acceleration of 0.946 rad/s2. What is the moment of inertia of the wheel? What is the mass of the wheel? If the wheel starts from rest, what is its angular velocity after 5.40 s have elapsed, assuming the force is acting during that time?
A turntable plays a vinyl with a mass of 0.186 kg and with a diameter of 0.089 meters. The vinyl rotates about an axis through its center with 0.698 J of kinetic energy. What is the speed (in m/s) of a point on the rim? The moment of inertia of the vinyl is I = (1/2)MR2