A uniform horizontal beam with a length of 3.00 m and a weight of 40 N is attached to a wall by a pin connection. Its far end is supported by a cable that makes an angle of 60° with the horizontal. If a crate of_(W)_N hanged 1.0 m from the wall, find the tension in the cable, as well as the magnitude and direction of the resultant force exerted by the wall on the beam. (Draw neat free body diagrams) Use the last THREE digits of your ID for the missing weight of the crate (W) N. D 1.5 m 60°

Q: 10 kN 8 kN 15 kN m 2 m 3 m kN - m 80 60 40 20 3 4 -20 -40 -60 -80 %24 2.

A:

Q: Im 2 m 3 m

A:

Q: Figure 28-33 R-12 A-2.7k -30011 Replace Q, with Q, and repeat the measurements listed. V Va

A: Sure, Here's how to find the voltage at point Va:Step 1: Identify Resistors and VoltageThe circuit…

Q: Solidworks MMGS units

A: Find Draw the given object in Solidworks. Unit: MMGS

Q: M 50 10 60 M. 10 10 50

A: Let’s divide the section into three different sections as shown – Calculating area of the different…

Q: What is the name of the highlighted symbol?

A: Dear student, I was the only one who solved this question.

Q: 1. Draw top, front and right side views of the bracket as shown in Fig.

A: Required Front view, Top view and Right hand side view are drawn using third angle method of…

Q: Consider the bracket shown in Fig-3. If: • F1 - 10 lb @ -90° • a- 2 ft • b- 4 ft • c-1 ft then, what…

A:

Q: for question 1, how did you get the area for the triangle? i dont understand how you got (.15-x)*2

A: The total height of the water level:Length of the base of the traingle:

Q: Determine the centroid of the given figure. 120 mm 60 mm 40 mm 80 mm 60 mm O x = 55.45 mm and y =…

A:

Q: Pl6-L Set up the relative velodity equalion between points A and B. -3m

A: