A uniform glass rod having a length L is placed in the smooth hemispherical bowl having a radius r. Determine the angle of inclination 0 for equilibrium.

Q: Determine the reactions at support A of the rigid body shown in the image. Also, indicate on your…

A:

Q: The vertical mast supports the 6.2-kN force F and is constrained by the two fixed cables BC and BD…

A: Given:The force is .The distances are .The system is shown below.To find:The tension in the cable .

Q: Cable AB passes over the small ideal pulley C without a change in its tension. What length of cable…

A:

Q: The uniform block having a mass m rests on the top surface of the halfcylindershown. Show that this…

A: Let us take the base of the cylinder as datum plane for zero gravitational potential energy.

Q: Determine the distance d for placement of the laod P for equilibrium of the smooth bar when it is…

A:

Q: If the mass of the flowerpot is 65 kg, calculate the tension generated in every cable for…

A: Solution:

Q: 1. Plate ABCDEF is a sliding door supported by a frictionless linear bearing at A and a frictionless…

A: The total weight of gate is

Q: Consider the following system in static equilibrium. Force vector Facts at a distance" from the pin…

A: (a) Draw the free-body diagram of bar.

Q: The mass center G of the 1220-kg rear-engine car is located as shown in the figure. Determine the…

A:

Q: Determine the tension in each cable necessary for equilibrium of the massless pipe supporting 800…

A: Uniform load applied on pipe:Total length of the uniform load:And structure is symmetric about XZ…

Chemical and Phase Equilibrium

Phase diagrams or equilibrium phase diagrams are the graphical representations that show the phase transformations of the constituting elements with respect to the pressure, temperature, and compositions. The diagrams show the conditions that limit the different phases, namely solid, liquid, and gas. The diagram can also be utilized to verify the relations between the state variables. Most of the phase diagrams are temperature-pressure phase diagrams, with the variable parameter as the composition. Usually other variables such as solubility and pressure parameters are not indicated in the phase diagram. For a one-component system (unary phase diagram), the phase diagram is generally a function of temperature and pressure as the state variables, or temperature and volume. However, for a binary system (two-phase) having two components, the phase diagram is a function of temperature and composition as the state variables only. Coexisting of the different phases of the constituting elements is indicated in the phase diagram. A ternary phase diagram can be characterized by consisting of three phases in equilibrium.