a uniform flow of 12m3/s occurs in a long rectangular channel of 5m width and depth of flow of 1.5m. a flat hump is to be built at certain section. assuming the head of loss is equal to the upstream velocity head compute minimum hight of the hump to provide critical flow what will happen A)if the hight of the hump is higher than the computed value and B)if the energy loss is less than the assumed value

Q: A rectangular channel of 2.5 m width is carring a discharge of 4m³/s. considering that acceleration…

A:

Q: In rectangular channel at a section P, it is required that the depth of flow is to be 1.4 m and the…

A: Depth of flow (y)=1.4m Specific energy (E)=2.8m To find Flow condition subcritical, critical, or…

Q: A right-angled triangular channel carries a flow of 16,000 l/s. The Manning's n = 0.020 and the…

A:

Q: A rectangular channel discharges 0.5m/s per metre width. Determine the critical depth and the step…

A: Given data: q=0.5 m3/s/m E1=1 m

Q: Q4:A discharge that passed through a twin culvert as a free surface flow, was recorded at a station…

A: To solve the given problem, we need to follow a systematic approach and apply principles of open…

Q: In an open channel flow, shooting (rapid) flow cannot

A: * Froude number is less than 1 is called tranquil flow.  Since , rapid flow has froude number more…

Q: Uniform flow (15.0 m³/s) occurs in a rectangular channel of width 3.50m at a normal depth of 3.80m.…

A: Given Width 3.5 mNormal depth before gate 3.8 mDepth at gate 0.5 mDischarge 15 m3/sTo find out Depth…

Q: When the channel of triangular cross section shown in the figure below was new, a flowrate of Q…

A: Given data:- The value of flowrate of Q caused the water to reach, L1=1.9 m Use formula:-  Q=AV…

Q: ← Uniform Flow A wide rectangular channel has a longitudinal slope of 1 in 2500 and its manning's…

A: Given- Wide rectangular channel- Slope S= 1 in 2500, n=0.024, Discharge q=1.8 m3/s/m, It is needed…

Q: Water flows within the rectangular channel shown with a flow of 8 m3/s. Given that the specific…

A: Thank you for the question .As per honour code we are allowed answer three subparts at a time so we…

Q: A trapezoidal channel with a 20ft wide bottom and side slopes, m, of 1.75 carries a discharge of…

A: Construct a Specific Energy diagram for this flow area at the discharge specified.Plot flow area…

Q: A circular pipe has a diameter of 1m, bed slope of 1 in 1000, and Manning's roughness coefficient…

A:

Q: Uniform flow occasionally occurs in a 5-m-diameter circular concrete conduit but the depth of flow…

A: Given data- diameter D= 5mn=0.013slope S=0.0005

Q: Uniform flow is taking place in a rectangular concrete channel (n= 0.013) with a bottom width of 3 m…

A:

Q: A rectangular channel has a width of 6 m, carriers a discharge of 24 m³/s with a depth of 3.2 m at…

A:

Q: For fully developed laminar pipe flow in a circular pipe, the velocity profile is given by u(r) = 2…

A: Approach to solving the question:The maximum velocity occurs at the center of the pipe. Average…

Q: Answer fast

A: Approach to solving the question ObservationsArc Labels - Each arc has a label formatted as f,c,…

Sediment transport

Sediment transport or Soil transport is the movement of solid particles, usually due to the combination of gravitational forces acting on the sediment, and the movement of the liquid at which the sediment enters. Soil erosion occurs in natural systems where the particles are sandstones (sand, rocks), mud, or clay; the liquid is air, water, or ice; and the gravitational force that works to move particles to the landing surface. Sediment transportation or soil migration due to the movement of liquids occurs in rivers, lakes, lakes, oceans, and other bodies of water as a result of currents and waves. Transportation is also caused by glaciers as they flow, and to places on earth under the influence of wind. Soil erosion due to gravity alone is possible in most sloping areas, including hills, scarves, cliffs, and the continental shelf — the continental boundary of the slope.