Answered: A uniform disk and a uniform square… | bartleby

Related questions

Question

e) U(x) must be a spring or gravity
A uniform disk and a uniform square sheet have the same mass,
and both can rotate around a pivot on their edge as shown.
Which object has a larger period for small angle oscillations?
a) disk
b) square
c) same
d) not enough info

Expert Solution

Step by step

Solved in 4 steps

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

I just need the answer for question #30 please Thank you
Question 6 Shown here is a rod of length = 1.17 m and mass m = 583 g that is pivoted at one end. Centered on the other end of the rod is a solid disk of radius R = 34.1 cm and the same mass as the rod. If this was turned into a physical pendulum with the given pivot, what would be the period of the pendulum?
What is the oscillation period?
The device depicted in the figure below entertains infants while keeping them from wandering. The child bounces in a harness suspended from a door frame by a spring. Jon Jemp a) If the spring stretches 0.247 m while supporting a 9.9 kg child, what is its spring constant? Number N/m b) What is the time for one complete bounce of this child? Number S c) What is the child's maximum velocity if the amplitude of her bounce is 0.18 m. Number
Old stye single records are played at 45 revolution per minute. The period of revolution is a) 45s b) 0.022s c) 1.33s d) 0.75s e) 0.45s
3. The physical pendulum. (a) In class, we derived the formula for the frequency of the physical pendulum W3 Mgl I (1) Show that the expression for the frequency of the simple pendulum is consistent with this. Then derive (1) using the energy method, where the total energy is the sum of the rotational kinetic energy 1/1 (do/dt) 2 and the potential energy of the centre of mass mghem. To obtain the result you will need to use the small angle expression for cosine: cos 01-02/2, for 0 < 1. (b) A thin square plate of side L and mass M is hanging from a pivot that is drilled into one of its corners. The pivot passes perpendicularly through the plate. The plate is then lightly tapped and starts to undergo small oscillations. Using the energy method, determine the period of the oscillation, making the small angle approximation. The moment of inertia for an axis running through the centre of a square plate is ICM ML²/6. =