A uniform beam of length L = 7.10 m and weight 4.05 × 10² N is carried by two workers, Sam and Joe, as shown in the figure below. Determine the force that each person exerts on the beam. Sam Joe F F Sam II = -1.00 m N N Z Z -2.00 m- L

A uniform beam of length L = 7.10 m and weight 4.05 × 10² N is carried by two workers, Sam and Joe, as shown in the figure below. Determine the force that each person exerts on the beam. Sam Joe F F Sam II = -1.00 m N N Z Z -2.00 m- L

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

An 82-kg diver stands at the edge of a light 5.0-m diving board, which is supported by two vertical pillars that are 1.6 m apart, as shown in the figure. 1.6 m 5.0 m A B Find the magnitude and direction of the force exerted by each pillar. Force on A KN Force on B kN (upward or downward?) (upward or downward?)
The figure below shows a claw hammer being used to pull a nail out of a horizontal board where ? = 27.3°. The mass of the hammer is 1.00 kg. A force of 165 N is exerted horizontally as shown, and the nail does not yet move relative to the board. Assume the force the hammer exerts on the nail is parallel to the nail. A hand uses a hammer to pull a nail out of the ground. The head of the hammer is curved and touches the ground at a single point of contact at the center of the head. The nail in the ground makes an acute angle ? clockwise from the vertical. The nail is hooked in the hammer claw 5.00 cm horizontally to the left of the hammer head's point of contact to the ground. The hand pulls the hammer handle horizontally to the right 30.0 cm above the ground with a force vector F.(a) Find the force exerted by the hammer claws on the nail.magnitude kNdirection ° above the horizontal (b) Find the force exerted by the surface on the point of contact with the hammer head.( î + ĵ)…
Three bamboo poles anchored at points B, C, and D on the ground supports the TV antenna placed at their other end at Point A. The TV antenna with a negligible weight is subjected to a wind load equivalent to a force in the component form shown in the figure. Y (-45î + 45K)N (0,8,0) A B (-6,0,2.4) (0,0,0) C D (0,0,-12) (8,0,4) *
A uniform beam of length L = 7.70 m and weight 4.95 x 102 N is carried by two workers, Sam and Joe, as shown in the figure below. Determine the force that each person exerts on the beam. Sam Joe +1.00 m +2.00 m- Fsam = N Fjoe =
2.0 kg 4.0 kg d 2.0 m The wooden beam has a mass of 20 kg. What is the distance d that balances the seesaw? 2.0 m 5.0 kg
A uniform beam of length L = 7.70 m and weight 4.75 ✕ 102 N is carried by two workers, Sam and Joe, as shown in the figure below. Determine the force that each person exerts on the beam.
7
The mass center G of the 1590-kg rear-engine car is located as shown in the figure. Determine the normal force under each tire when the car is in equilibrium. State any assumptions. Answers: -1251 mm-942 mm Normal force under each of the front tires: Nf= Normal force under each of the rear tires: N₁ = i i N N
A vaulter is holding a horizontal 3.00-kg pole, 4.50 m long. His front arm lifts straight up on the pole, 0.750 m from the end, and his back arm pushes straight down on the end of the pole. How much force does his front arm exert on the pole? [?]N
Consider the 120-cm board supporting three loads as shown below. The beam weighs 45 grams. If the system is in equilibrium, a. what is the magnitude of the force exerted by the pin support to the board? b. Find the perpendicular distance, x, of the pin support from the left end of the board. 30cm A В C 259 30g 75g
Statics and Torque 1. The figure shows a pair of forceps used to hold a thin plastic rod firmly. If the thumb and finger each squeeze with a force of Fr= FF= 11.0 M, what force do the forceps jaws exert on the plastic rod? Jaws Rod FT 8.50 cm 2.70 cm 2. A 75-kg adult sits at one end of a 9.0-m-long board. His 25-kg child sits on the other end. (a) Where should the pivot be placed so that the board is balanced, ignoring the board's mass? (b) Find the pivot point if the board is uniform and has a mass of 15 kg. 3. Calculate FA and Fg for the beam shown below. The downward forces represent the weights of machinery on the beam. Assume the beam is uniform and has a mass of 280 kg. FA 4300 N 3100 N 2200 N F 4.0 m-3.0 m 2.0 m 1.0 m 4. Three children are trying to balance on a seesaw, which includes a fulcrum rock acting as a pivot at the center, and a very light board 3.2 m long. Two playmates are already on either end. Boy A has a mass of 45 kg, and boy B a mass of 35 kg. Where should girl…
A 2.00 m long horizontal uniform beam of mass 20.0 kg is supported by a wire as shown in the figure. The wire makes an angle of 20.0 degrees with the beam. Attached to the beam 1.40 m from the wall is a ball with a mass of 40 kg. What is the tension in the string? a)1,000 Nb) 1,090 N c) 2,100 N d) 2,250 N e) 2,680 N