A two-engine jet transport has a loaded weight of 90000 lb and a forward thrust of 9170lb per engine during takeoff. If the transport requires 4780 ft of level runway starting from rest to become airborne at a speed of 137 knots (1 knot = 1.151 mi/hr), determine the average resistance R to motion over the runway length due to drag (air resistance) and mechanical retardation by the landing gear. Answer R = i Ib

A two-engine jet transport has a loaded weight of 90000 lb and a forward thrust of 9170lb per engine during takeoff. If the transport requires 4780 ft of level runway starting from rest to become airborne at a speed of 137 knots (1 knot = 1.151 mi/hr), determine the average resistance R to motion over the runway length due to drag (air resistance) and mechanical retardation by the landing gear. Answer R = i Ib

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Problem 01: An object is fired vertically upward from the ground, with an initial velocity of 50 m/s. The mass of the object is 10 kgs. Determine the maximum height to which it will travel if atmospheric resistance is neglected; and the maximum height to which it will travel if atmospheric resistance is being considered as FD-105 N. h
The coefficients of friction between the load and the flat-bed trailer shown are 0.35 (static) and 0.30 (kinetic). Knowing that the speed of the rig is 72 km/h , determine the shortest distance in meter in which the rig can be brought to a stop if the load is not to shift.
A 0.6 ton motor is moving on a leveled highway at a speed of 108 km/hr. How large is a retarding force (in Newton) is required ?to stop it in a distance of O.007 km 1654 4886 3860 non of them
Problem Statement Consider isentropic supersonic flow around the sharp expansion corner illustrated in Figure shown below: Mi M2 Figure 1. Isentropic supersonic flow around a sharp expansion corner. The relationship between Mach number before the corner (M₁) and after the corner (M₁), derived by Zucrow and Hoffman (1976), is given by o = bâ [tan-t ཊཌི་ཊྛཱི -1」 བཻ _ tan-iཊཌི་ཤྲཱི -1 j -[tan-t{wę - 1)2} - tan-i{of - 1)4}] where b b = (x + 1) and y is the specific heat ratio of the gas. Use Newton-Raphson Method to solve for M₂ for specified values of y, 6, and M₁. For y = 1.4, solve for M₂ given the following combination of M₁ and 6: 1.0 and 10.0°. Correct up to 1.0x105.
A 900-kg car travelling east at 15.0 m/s collides with a 750-kg car travelling north at 20.0 m/s The cars stick together. Assume that any other unbalanced forces are negligible What is the change in momentum of the colliding bodies? What is the speed of the wreckage just after the collision? In what direction does the wreckage move just after the collision?
A 50 cm high, 30 cm diameter is being transported on a level road. The highest acceleration anticipated is 5 ?/? 2 . Determine the maximum allowable initial water height in the tank if no water is to spill out during acceleration.
Situation 05. In a science experiment, a test object is launched by accelerating it along a 200- meter incline at 1.25 mn/s² starting from rest at the bottom point of the incline (Point Q). The incline is measure 35° from the horizontal, and the instant the object leaves the incline, the gears were turned off. Ignoring air resistance. Compute the maximum height above the ground that the object reaches. b. What is the maximum range of the object beyond Point Q? a.
A ball is thrown with an initial velocity of 100 ft/s upward at 60° with the horizontal. When the range is 5Oft from its original position, compute the normal acceleration of the ball and its radius of curvature.
Ball 1 is launched with an initial vertical velocity v₁ = 179 ft/sec. Ball 2 is launched 3.4 seconds later with an initial vertical velocity v₂. Determine v₂ if the balls are to collide at an altitude of 317 ft. At the instant of collision, is ball 1 ascending or descending? 11, 12 Answer: V₂ = ft/sec
Need within 1hr please, thanks A 0.5 kg block slides on a circular road with a radius of 4 m in the vertical plane. Block speed is 4m/s as it passes point A and 5 m/s passes point B. Angle distance from point A and B is 30 along the radius. Determine normal force exerted on block by the surface at point A and B and the total acceleration at Point B.
To automobiles are 150 k/m apart and traveling toward each other.One automobile is moving at 60km/h and the other is moving at 40km/h mph.In how many hours will they meet?
None