A triangular pulse signal x (t) is depicted in the figure below. Sketch each of the following signals derived from x (t): x(f) (a) x(3¢) (d) x(2(t + 2)) (e) x(2(* – 2)) () x(31) + x(3t + 2) (b) ×(3¢ + 2) (c) x(-2t – 1)

Q: ns. MIN MAX PULSE PERIOD 100 us 10 1 1 ON OFE F INT CLOCK POWER ms 10 100 15 100 21 ns MIN SINGLE…

A: Pulse Generator:

Q: The waveform displayed on an oscilloscope is as shown in Figure 3. The 'time/cm' switch is set to 2…

A:

Q: If the clock period is 25 ns, what is the clock period in MHz?

A: Given: Clock period, T=25 ns=25×10-9 s.

Q: Q/ If you put the time base sign on div/10µsec, how many cycles are displayed on the plotter screen?…

A: This question belongs to measurements and instrumentation . It is based on the concept of relation…

Q: ne tir ynu put the time µsec, how many cycles will be splayed on the plotter screen? hen the input…

A:

Q: a 40% duty cycle clock signal is low for 10ns. What will the clock frequency be?

A: In this question We need to determine the clock frequency of the given signal.  We know Frequency f=…

Q: What do these buttons and symbols mean on pulse generator?

A: The given diagram is shown below. We need to tell the meanings of the buttons and symbols.

Q: Suppose a square wave signal has a 86 percent duty cycle and an on-state voltage of 24 volts DC.…

A: We need to find out average value for given waveform .

Q: What is the offset knob and why should it be set to 0 on this pulse generator?

A: The given figure is shown below. It is asked what is the offset knob and also we need to describe…

Q: Please explain the difference between Analog Phase Measurements and Digital Phase Detectors in…

A: According to the question, we need to discuss the difference between Analog Phase Measurements and…

Q: What does the square wave button and pulse button mean on generator?

A: The given diagram is shown below. We need to tell what is the meaning of square wave button and…

Q: What is the average value of the output of the half-wave rectified waveform shown? ^^^ s 100 V-

A: Calculation of average value of the output of the half wave rectifier waveform given: From the…

Amplitude modulation

A radio signal can carry information in the form of sound or image for broadcasting or communication. For it to be sent to a greater distance, the signal must be changed or modulated in some way. One of the easiest way is to change the amplitude of the signal with variations of the video or the audio signal. This is called Amplitude Modulaton. In this modulation information of message is carried in amplitude of carrier signal.