A transmission tower is held by three guy wires anchored by bolts at B, C, and D, as shown in Fig. P1.2. If the tension in wire AB is 525 lb, determine the components of the force exerted by the wire on the bolt at B.

Q: Determine the external reactions at A and F for the roof truss loaded as shown (positive answers are…

A: To Determine Ax, Ay and Fy

Q: A transmission tower is held by three guy wires attached to a pin at A and anchored by bolts at B,…

A: Given  TAB= 110 lb

Q: s. Determine the tension in each wire.

A:

Q: 0.15 m 0.4m 0.2 m 03 m 0.5 m 0.25 m 0.2 m

A: The position vectors and unit vector are as follows: rCD=(-0.2i-0.3j+0.25k) munit…

Q: 4- Determine the moment of the force F about the door hinge at A. 7 ft 4 ft F = 80 lb 1.0 ft 450 1.5…

A:

Q: For the pulley system shown in the figure below, which of the following statements are true? P. DA B…

A:

Q: 5.0 The truss figure shown is pinned to the wall at point F, and supported by a roller at point C.…

A: Load act at point A= 80 kNLoad act at point B= 60 kN

Q: 1. For the truss shown below, support A is a roller and support B is pinned. The two 2.6-kip loads…

A:

Q: Answer fast and draw diagram

A: Step 1: Reactions at SupportsThe total uniform load on the top horizontal beam:…

Q: The idealize model for suspension bridge is shown in the figure. The truss are pin connected at a,…

A: We have to determine the design diameter of the cable if the allowable tensile stress is 150 MPa and…

Q: 10k IB 5' 5' in

A: Solution:- Support reactions at A and B, Ra+Rb=2×10+10 =30 k Taking moment about B,…

Q: If the couple moment acting on the pipe has a magnitude of 400 N.m, determine the magnitude F of the…

A:

Q: A column bracket having the general features shown in Fig. 11.24 is to be designed to carry the end…

A: Solution:

Q: Determine the components of the reactions for the beams. Please show all work

A: To determine the reactions at the supports of the beam, we need to consider the uniformly varying…

Q: 4

A: Answer:- Solid circular cross section is C=(1/2)xd=10mm I=(π/4)xC4 =(π/4)x104= 7.854 x 10-9mm4 E=…

Cables

Cables are collections of wires, alternatively referred to as a cord, connector, or plug. They are one or more wires covered in a plastic covering that allows for the transmission of power or data between devices. The earliest use of recognizable electrical cable was the early commercialized telegraph lines. These were iron-made and tedious to produce and install cabling.