A toy aeroplane of mass m = 1,80 kg is attached to a string of length e = 33.0 m and flys in uniform circular motion in a horizontal plane around the centre of its motion. The plane has an engine which generates thrust that keeps the plane moving at a speed of v = 30.7 km/hr. (a) What is the period of the circular motion? Period = S (b) What is the tension in the string holding the aeroplane in its circular motion? Tension =

A toy aeroplane of mass m = 1,80 kg is attached to a string of length e = 33.0 m and flys in uniform circular motion in a horizontal plane around the centre of its motion. The plane has an engine which generates thrust that keeps the plane moving at a speed of v = 30.7 km/hr. (a) What is the period of the circular motion? Period = S (b) What is the tension in the string holding the aeroplane in its circular motion? Tension =

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

The lift force on an airplane of mass 897 kg with speed v is given by c v2 (N), where c is some constant depending on the air density and wing geometry. The lift force points perpendicular to the wings of the plane, so that if the plane banks by, say 10 degrees, then the lift force turns 10 degrees from the vertical. Now suppose that the pilot of this plane wishes to complete a flat turn of radius 931 m with speed 104 m/s. How much should they bank the plane, in degrees? (Please answer to the fourth decimal place - i.e 14.3225)
Hi, today I had my engineering mechanics 1 test which I completely screwed up. I was quite confident in the uniform circular motion, but I had this problem in my exam which completely confused me. When I read "upward vertical acceleration" my head just start to spin as I couldn't understand what force could cause an upward acceleration. Could you help me with this problem? I bet it is easier than it looks, but still, I am confused about what is asking me and most importantly about the input it is giving me. I don't have my exam paper with me, but on my body diagram, I knew that on the aeroplane were exerted the Force of Contact Fn1 and the Force m1g in the y opposite direction. On the pilot was acting the Force of Contact with the seat of the aeroplane Fn2 and the m2g in the y opposite direction. Here is the problem: During an air show an aircraft comes out of a dive at the bottom of a circular arc at a horizontal speed of 97m/s. In the cockpit the aircraft pilot of mass 58kg…
The cable lifting an elevator is wrapped around a 1.2-m-diameter cylinder that is turned by the elevator's motor. The elevator is moving upward at a speed of 1.9 m/s . It then slows to a stop, while the cylinder turns one complete revolution.How long does it take for the elevator to stop?
A rubber ball is attached to a 1.44-meter string and spun in a horizontal circle. The tension in the string is 2.91 N. It takes 0.644 s for the ball to complete one revolution. Determine the mass (in kg) of the ball.
A ball of mass 1.6 kg and a diameter of 41.1 cm is attached to a string of length 1.1 m. It moves in a circular path at constant speed, 4.5 m above the ground. The string makes a constant angle of 42° with respect to vertical. m (a) What is the speed of the ball? (b) What is the tension in the string?
A circular-motion addict of mass 81.0 kg rides a Ferris wheel around in a vertical circle of radius 12.0 m at a constant speed of 7.10 m/s. (a) What is the period of the motion? What is the magnitude of the normal force on the addict from the seat when both go through (b) the highest point of the circular path and (c) the lowest point? Unit of Part A is s, Part B and C is N.
A puck is sliding around a circular track that is banked at an angle ϕ with respect to the horizontal such that no friction between the puck and the track is required to keep the puck from slipping up or down the track. If the puck is moving at a speed 34.1 m/s and the radius of the track is 401 m, determine ϕ in degrees.
A ball of mass 4.7 kg and a diameter of 68.2 cm is attached to a string of length 1.1 m. It moves in a circular path at constant speed, 3.0 m above the ground. The string makes a constant angle of 17 ° with respect to vertical. L m (a) What is the speed of the ball? (b) What is the tension in the string?
Question 4. A single bead can slide without friction on a vertical hoop of radius r. The hoop rotates about its vertical axis and makes one complete revolution in T seconds. The position of the bead is described by the angle 0. At what 0 > 0 can the bead stay stationary while the hoop rotates? r
A small object of mass 0.500 kg is attached by a 0.840 m-long cord to a pin set into the surface of a frictionless table top. The object moves in a circle on the horizontal surface with a speed of 8.80 m/s. What is the magnitude of the radial acceleration of the object?