A three-phase, 60-Hz, 500-kV transmission line has an inductance of 1.0424 mH/Km per phase and a capacitance of 0.0105 μF/Km per phase. The line is 350 Km long, and for the purpose of this problem, a lossless line is assumed. Determine the transmission line constant A Select one: O a. 0.181 Ob. 0.999 Oc None of these O d. 0.906 Oe. 0.399

A three-phase, 60-Hz, 500-kV transmission line has an inductance of 1.0424 mH/Km per phase and a capacitance of 0.0105 μF/Km per phase. The line is 350 Km long, and for the purpose of this problem, a lossless line is assumed. Determine the transmission line constant A Select one: O a. 0.181 Ob. 0.999 Oc None of these O d. 0.906 Oe. 0.399

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

of Line Load Capacitor A three-phase system is represented as shown above. Line: 42in 42 in Line is selected to be AAC #336.4 with ampacity of 513A Diameter of each conductor is d= 0.666 in or 5.03 mm Distance between conductors D= 42 in The length of the line is 1= 20 km Resistance per unit length is r= 0.63 Ohms/1000 ft (there are 0.3048km in 1000ft) Load: P (kW) = 1600 Power factor = 0.75 Voltage at the load V = 13.8 kV
A 502 transmission line is terminated with a 502 resistor on series with a 2 * 10 H inductor. If the frequency of the operation is 60 10° MHz find the reflection coefficient at the load. * Select one: O a. 0.36e56 О .1 O c.0.45e22 O d. 0.6e 37 Oe. 0
Q) A transmission line of 300 Km long having a resistance of 10.4 OKm ,a capacitance of 0.00835 µFKm' , an inductance of 3.67 mHKm' and a conductance of 0.8 uSKm at a frequency of 796 Hz. The line is terminated by its characteristic impedance. A 2 V generator with an internal resistance of 600 Q is connected to the sending end. Determine the voltage and current at the receiving end.
10. The capacitance per unit length and the characteristic impedance of a lossless transmission line are C and Z0 respectively. The velocity of a travelling wave on the transmission line is (a) ZoC (b) 1/(ZoC) (c) Zo/C (d) C/Zo
A 219-2 lossless air transmission line is connected to a complex load composed of a 579-Nresistor in series with a 0.01-mH inductor, as shown below. At 4 MHz, determine the voltage standing wave ratio, S. Zo L S = Question 2 A 357-2 lossless air transmission line is connected to a complex load composed of a 740-2 resistor in series with a 0.02-mH inductor, as shown below. At 6 MHz, determine lmaz , the location of the voltage maximum nearest to the load. Zo L Imaz m %3D
Phase velocity of voltage wave in a distortion less line having characteristic impedance 0.1 kQ, velocity 0.5*108 m/s then the value of inductance per meter
Transient Analysis on Long Transmission Lines Question A surge of 18 kV travels along a cable towards its junction with the overload line. The surge impedance of the cable is 50 2 and the line has an inductance of 10 mH/km and capacitance of 0.0625µF/km. The surge voltage (in kV) transmitted into the line is:
Q) A source of 10 V and frequency 1000 KHz with internal resistance of 10 2 is connected to the sending end of a transmission line which can be represented by a resistance of 70 Q in series with capacitance of 0.001 µF connected across the line at the receiving end. An inductive load of inductance 0.002 H and resistance 100 Q is connected across the receiving end of the line. Determine the load current.
Blue is the numerical answer, I need a detailed solution.
QUESTION 5 A transmission line that is 20cm long, has a propagation velocity of 200Mm/s, and has a characteristic impedance of 70.7 ohm is connected to a 100 ohm load. What is the input impedance of the transmission line to a sinusoidal signal of 500MHz? Enter the value in ohms (no units) to two significant figures.
A single phase line has two parallel conductors 1.5 meter apart. The diameter of each conductor is 1.15cm calculate the inductive and capacitive reactances of the transmission line if it is operating at a frequency of 55Hz.