A thin square flat plate 6 cm is tested for drag in a wind tunnel with air at 100 m/s , and 60 oC flowing across and parallel to the top and bottom surfaces. The observed total drag force is 0.0135 N. Calculate the rate of heat .transfer from this plate

A thin square flat plate 6 cm is tested for drag in a wind tunnel with air at 100 m/s , and 60 oC flowing across and parallel to the top and bottom surfaces. The observed total drag force is 0.0135 N. Calculate the rate of heat .transfer from this plate

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter5: Analysis Of Convection Heat Transfer

Section: Chapter Questions

Problem 5.49P

See similar textbooks

Related questions

Q: Air is flowing over a flat plate 5m long and 2.5 m wide with a velocity of 4/ms at 15⁰c. Calculate…

Q: A parachute of hemi-spherical shape allows a parachute jumper of weight 90kg to descend with a…

A: A drag force is the resistance created when a body moves through a fluid like water or air. A drag…

Q: . 5.20 Suppose you are designing a parachute with a drag coefficient of 0.5. What cross-sectional…

Q: Calculate lift, drag and (T/W ratio) for an aeroplane with velocity 500 m/s, wing area 45 m2 , a…

A: Given data U∞=500 m/sA=45 m2CD=0.05CL=0.9

Q: Force acting on a truck (frontal area of 2.01 m?) in the flow direction as shown is measured…

A: A=2.01 m2F=x+100 N where x=190.6 soF=190.6+100 F=290.6 NP0=1 atm T0=20 °CU=95kmhU=95×518=26.388…

Q: Consider a finite wing with a NACA 1412 airfoil section with a wingspan of 12 ft and a wing area of…

A: Given: Cl =1.5 As = 240 ft^2 b = 12 ft Cdo =.035 e=0.8

Q: A thin flat plate ( 45 cm X 90 cm ) is immersed in a stream of glycerin (P = 1258 kg/m and u = 1.49…

Q: Atmospheric air at 20°C flows at 10 m/s on both sides over a 2-m long by 4-m wide flat plate.…

Q: Qustion. An aircraft is flying in level flight at a speed of 200 km/h through air (density, p = 1.2…

Q: Consider again a semi truck traveling at 55 mph on the freeway. The ambient air is at 1 atm and…

Q: When testing a new car, the car drives with a constant speed v = 140 km/h. The power of car’s engine…

A: Given data: The constant speed is of the car is v = 140 km/h. The power of car's engine is P = 120…

Q: Water at 60° C flows over 2.5 cm square flat plate 90°C at a velocity of 4 m/s. 1- Calculate the…

A: Given: The temperature of water, T = 60°C The side of square plate, s = 2.5 cm The temperature of…

Q: A shuttlecock is launched from the ground with an initial speed of 33.3163 m/s at an angle of 8.1977…

Q: An airplane with a NACA 23012 airfoil cruises at 150 m/s at an altitude of 6000 m. The airfoil has…

A: Given data: Span length of air foil = 36 m Aspect ratio = 10 Speed, u = 150 m/s Altitude, h = 6000 m…

Q: Derive an expression for turbulent boundary layer thickness over a flat plate

A: Given A turbulent flow in a flat plate To find Turbulent boundary layer expression

Q: Consider a flat plate that is L = 3 m long and of unit width immersed in a free stream flow of air…

A: Length of plate = 3 m velocity = 11m/s using flat plate boundary conditions assume density of air =…

Q: Consider a laminar boundary layer flow over a flat plate for which the velocity profile can be…

Q: Assume air at 20°C and atmospheric pressure on a smooth flat plate with a speed free current of 25…

Q: A thin flat plate ( 45 cm X 90 cm ) is immersed in a stream of glycerin (p = 1258 kg/m and u = 1.49…

Q: A new car is introduced and has a drag coefficient of 0.30 and a frontal area of 1.95 sqm and is…

Q: 13) An inflated toy balloon is about 8g, with a cross-sectional area of 0.023 m'. It falls in air…

Q: An airplane is cruising at a velocity of 950 km/h in air whose density is 0.526 kg/m3. The airplane…

A: step-1 given data velocity (v) = 950 km/hdensity of air = 0.526 kg/m3area of wing (A) = 90…

Q: 5.8 Calculate the drag coefficient and drag force on a cylindrical shape flag post of the ship…

Q: During a winter day, wind at 55 km/h, 5°C, and 1 atm is blowing parallel to a 4-m-high and 10-m-long…

A: Given data velocity of wind 55 km/hr = 15.27 m/sec height of the wall h = 4m length of the wall L =…

Q: Q.5. For the velocity profile in laminar boundary layer: 13 3 2 2 Find the thickness of boundary…

Q: The air flows past a 1m diameter disk oriented normal to upstream flow at 6.8m/s. The pressure…

Q: Q1/ Boeing 737 - 60 flies at altitude 15000m above sea level with speed 85 m/s and total drag…

A: Given data: - The speed of the Boeing 737 - 60 is v = 85 m/s. The density of air at this condition…

Q: During a winter day, wind at 58 km/h, 5°C, and 1 atm is blowing parallel to a 3.5-m-high and…

A: Given : The velocity of the wind = 58 km/hr The temperature of the air T = 5°C The pressure of the…

Q: n air at 25°C and latm. Use drag coefficient Cp = 0.4 and Whitak e spheres fall at their terminal…

A: we know thatRe=ρuDμ=uDνwhere,Re=Reynolds number ρ= density D= diameter…

Q: In the vertical wind tunnel used in paratrooper training, find the wind tunnel free speed required…

Q: Air equivalent to one of a standard height of 4000 m flows at 450 mi/h over a wing with a thickness…

A: Given, Velocity = V = 450 mi/h = 201.17 m/s Altitude = h = 4000 m Thickness = t = 18 cm = 0.18 m…

Q: A ship is 125 m long and has a wetted area of 3500 m2.Its propellers can deliver a maximum power of…

A: Given data: The length of the ship, L = 125 m. The wetted area, A = 3500 m2. The delivered power, P…

Q: Water at 60° C flows over 2.5 cm square flat plate 90°C at a velocity of 4 m/s. 1- Calculate the…

A: NOTE:- Here properties of water and air is not mentioned so, I took these at Tavg. i.e. at 75oC…

Q: - Use FoilSim to investigate how an aircraft wing produces lift and drag by changing the values of…

A: An airfoil produces lift by applying a downward constrain on the air because it flows past.…

Q: A shuttlecock is launched from the ground with an initial speed of 36.9838 m/s at an angle of 9.9728…

A: given information: The initial speed of shuttle cock (u) = 36.9838 m/s angle made by initial…

Q: Example 5 The total mass, wing area, cruising speed, and air resistance power of a small aircraft…

A: Givenm=1800kgA=42m2V=280 km/hr =280×1033600=77.78m/sPa=190kWH=4000m

Q: Use FoilSim to investigate how an aircraft wing produces lift and drag by changing the values of…

A: Given Foilsim To find Lift and drag conditions

Q: Two baseballs of diameter 7.35 cm are connected to a rod7 mm in diameter and 56 cm long, as in Fig.…

A: Given data: The diameter of baseball, db = 7.35 cm. The diameter of the rod, dr = 7 mm. The total…

Q: Calculate lift, drag and (T/W) for an aeroplane with velocity 500 m/s, wing area 45 m2 , a drag…

A: Given, V = 500 m/s A = 45 m2 CD = 0.05 CL = 0.9

Q: A tiny particle of mass 4 x 10°4 kg (so fdrag = bv) has a drag coefficient, b = 3.3 x 10² kg/sec.…

A: Given data mass of particle (m) = 4*10-4 kg drag coefficient (b) = 3.3*10-2 kg /sec To determine…

Q: The rectangular wing of a smal airplane has a chord length of 1.8 m and a wingspan of 10 m. When its…

Q: Q1: Find the boundary layer thickness (8) equation, the shear stress (to) and the coefficient of…

Q: A flat sign board is circular and 6 m in diameter. Weight of air is 12.57 N/m³. There is a drag…

Q: The airfoil section of the wing of the British Spitfire of World War II fame is an NACA 2213 at the…

Concept explainers

Buckling of columns

The column is described as a vertical member of the structure that carries an axial compressive load, and buckling is a lateral deformation of the column under the application of load.

Question

None

10 نقاط
A thin square flat plate 6 cm is
tested for drag in a wind tunnel
with air at 100 m/s , and 60 oC
flowing across and parallel to the
top and bottom surfaces. The
observed total drag force is 0.0135
N. Calculate the rate of heat
.transfer from this plate

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

In the vertical wind tunnel used in paratrooper training, find the wind tunnel free speed required to keep a 75 kg person suspended in the air in a horizontal position. The height of this person is 1.7m and the width is 38cm and the front drag coefficient is around 1. Atmospheric pressure and temperature inside the tunnel are Patm = 85kPa and T = 25C, respectively.
How do we use the Buckingham pi theorem to prove that drag coefficient is dimensionless?
1. Zero Lift Drag Coefficient" is a sum of: \C poum |Cp CDOF DoL 1 M
QI/ If the velocity profile of the boundary layer is :O find the thickness of boundary layer, the shear stress at trailing edge and the drag force on one side of plate 2 m long, if it is immersed in water flowing with velocity of 0.4 m/s (p 998 D = 1.007*10-6 m2/s %3D
The drag coefficient for a car with a frontal area of 26 ft? is being measured in an 8 ft x 8 ft wind tunnel. The density of air under the test conditions is 2.4 x 10 3 slugs/ft, When the air flow rate is, 500,000 ft/min, the drag force on the car was measured to be 170 lb. The drag coefficient under the test conditions is most nearly O 0.30 O 0.32 O 0.28 O 0.34
Based strictly on your understanding of the flat-plate theoryplus adverse and favorable pressure gradients, explainthe direction (left or right) for which airflow past theslender airfoil shape in Fig will have lower total(friction 1 pressure) drag.
A circular cylinder of radius 10 cm length 100 cm is rotated clockwise by 10 rad/s . The amountof lift generated is 6 N when air flow approaches the cylinder at V=? ( pi number=3 Air density=1kg/m3 )ANSWER:10 m/s
Q/ Prove that the drag force expression for the boundary layer with the velocity profile -Sin ) is given by the: EoD= 0,6588U?L %3D
a stone is thrown from top of 35m tall bilding. The stone is thrown with an initail speed of 15 m/s at an angle 53 degrees above the horizintal. If air resistance is negligible, what is the angle at which the stone will hit the ground?
Consider the equation v (t) = " (1 – e-le/m)t) For the free-falling bungee jumper with linear drag, assume a first jumper is 73.5 kg and has a drag coefficient of 12.5 kg/s. If a second jumper has a drag coefficient of 14.5 kg/s and a mass of 85 kg, how long will it take him to reach the same velocity jumper 1 reached in 8 s? (Round the final answer to three decimal places.)
Two baseballs of diameter 7.35 cm are connected to a rod7 mm in diameter and 56 cm long, as in Fig. . Whatpower, in W, is required to keep the system spinning at 400r/min? Include the drag of the rod, and assume sea-levelstandard air.
A cloud of coal particles is traveling through a system. The cloud diameter estimated to be 0.027 m and the individual particles are 50 um in diameter with the density of 1300 kg/m'. The total cloud is moving such that its drag coefficient is constant at 0.44. The individual particles in the cloud move much slower, such that the drag coefficient given by stock's law. The system has atmospheric air transporting and the cloud density is 190 kg/m3. Determine the ratio of internal velocity to cloud velocity. Atmospheric air density 1.2 kg/m'.