A thin rod AB of length 1 = 600 mm is connected to a sliding sleeve on a pole. The rod rests on a C-shaped wheel located at a distance horizontal a = 80 mm from the vertical axis of the post. Knowing that us = 0.25 between the sleeve and the post, that the radius of the wheel is negligible, that G= 100 N and 0 = 30°, determine the range of values of P ensuring the balance of the assembly

Q: Regarding the curved post, it is requested to replace the forces shown by an equivalent system…

A: Consider the given figure. Let the reaction forces and moments induced at point O in x, y and z…

Q: Q.1) Draw Free-Body diagrams of each of the three cylinders shown below. Each of the cylinders has a…

A:

Q: For the shown frame and loads P=972 KN and Q=1944 KN, 3 m 3 m- B 1.5 m 1 m 8 m 6 m magnitude of…

A: Given,

Q: A uniform bar AB, 12 ft long, and weighing 6.0 lb, is supported by a fulcrum at point O as shown. If…

A: (i) FBD of the question given: The acceleration due to gravity is g = 32.2 ft/s2. The mass of the…

Q: A sign of weight 2400 N is supported as shown by a ball and socket support at A and two cables BC…

A: To find: The tension in cables and the reaction at O. Given: The weight of the sign board is W=2400…

Q: Since the brace shown must remain in position even when the magnitude of P is very small, a single…

A: given data as per question spring constant = 50 lb/in  magnitude of P = 800 lb considering free body…

Q: Collars A and B are connected by a 525-mm-long wire and can slide freely on frictionless rods. A…

A:

Q: Two smooth cylinders, A (weighing 80 N. and having a diameter of 16 m.) and B (weighing 60 N and…

A:

Q: 100 mm 100 mm 100 mm 540 N D. 225 mm B

A:

Q: Determine the horizontal and vertical reactions at pin A on member AB. Roller E is pinned to the…

A: Given: The mass of body, m = 1500 lb

Q: A semicircular rod is loaded as shown. Determine the internal forces at point J knowing that 0==…

A: Consider the free body diagram as shown below for the member ACB.

Q: The assembly consists of two sections of cast-iron rod connected together using a reducing coupling…

A:

Q: Problem 1 To loosen a frozen valve, a Force F of magnitude 76 lbs to the handle of the valve.…

A:

Q: Two identical cylinders each weighing 300 lbs are placed as shown. If the radius of each cylinder is…

A:

Q: While tapping a hole, a machinist applies the horizontal forces shown, P= 3.4 lb and Q=3.15 lb, to…

A: Force applied on point A is, Force applied on point B is, The angle of the forces are acting at…

Q: The mass of the uniform bar below is 20 kg. 1. Determine the magnitude of the reaction NB acting on…

A:

Q: A 200-mm lever AB and a 240-mm-diameter pulley are welded to the axle BE, which is supported by…

A:

Q: A pulley has a mass 34.2 kg and having a radius of gyration of 1.71 m. is connected to two blocks…

A:

Q: The assembly consists of two sections of cast-iron rod connected together using a reducing coupling…

A: (a) To find: The maximum shear stress developed in each section. Given: The length of AB is lAB=12…

Q: For the shown frame and loads P=756 KN and Q=1512 KN, P-3 m- 3 m 1.5 m 1m magnitude of y-component…

A:

Q: A uniform wheel of 50 cm radius and 1 kN weight rests against a rigid rectangular block of thickness…

A: Data given- R = 50 cm  W = 1 kN

Q: For the given loads w = 28 KN/m and M=70 KN.m is supported as shown by a roller at D and a hinge at…

A: UDL is referred to uniformly distributed load (magnitude of load remains constant over a span of…

Q: Solve Prob. 4.75 when θ = 30° and P = 150 N.

A: Given data: The block resting on an inclined plane The force F, acting on the block = 1.2 kN = 1200…

Q: In the assembly shown, sags of s and 1.5 s resultedwhen the two cylinders were suspended from the…

A:

Q: For the instant of the Proell governor mechanism shown below, the tension in the lower link will be…

A:

Q: A uniform rod is attached to a wall by a hinge at its base. The rod has a mass of 3.5 kg, a length…

A:

Q: 4m 20° B A d 5 kN COND A crane is used to lift a concrete pipe weighing 5 kN into place. For…

A:

Q: A container of weight Wis suspended from ring A. Cable BAC passes through the ring and is attached…

A: Figure is shown in the question , given that  P=Pi  ,  Q=Qk W=300 lb To determine P and Q

Q: 4. A block of weight W is suspended from a 25-in.-long cord and two springs of which the unstretched…

A:

Q: 2. The 30 cm handle is connected rigidly to the 5cm bar at a right angle. Determine the force…

A: The force applied to the handle is, P=100 N Length of the handle is, L=30 cm

Q: In the assembly shown, sags of s and 1.5 s resulted when the two cylinders were suspended from the…

A: Given: spring constant for spring BD→KBD=134 Nm value of s=0.85 because initial length of the…

Q: . Determine the angle ” between the table and the plane face of the hemisphere in its equilibrium…

A: Draw a free-body diagram of a given system with dimensions.

Q: Determine the internal forces at point E

A:

Q: 4 in. 11 in. PROBLEM 3.49 To loosen a frozen valve, a force F of magnitude 70 lb is applied to the…

A:

Q: For the given loads w = 28 KN/m and M-70 KN.m is supported as shown by a roller at D and a hinge at…

A:

Q: Problem 2) Determine the weight of cylinder Cif the weight of cylinder A is 40 newtons.

A:

Q: A rod, formed as a circular arc, is loaded as shown. Determine the internal forces at point J. 160…

A: Given: The loaded arc is shown below:

Q: A freight wagon is at rest on a track at an angle of 25o to the vertical. The gross weight of the…

A:

Q: To the left of point B , the long cable ABDE rests on the rough horizontal surface shown. Knowing…

A: First, draw the free-body diagram: Calculate y-coordinate of point D by using the length of the…

Q: A sign of weight 2400 N is supported as shown by a ball and socket support at A and two cables BC…

A: Given Weight of the board = 2400 N To find Tension in BC Tension in AD Reaction at X Reaction at Y…

Q: The system below is in balance. Knowing that the weight of the bucket ́e of 900 N, determine…

A: Solution: GIven Data: W = 900 N

Free undamped vibrations

Whenever an object/system displaces in either side of its equilibrium position with the help of an external/internal means, then the object/system moves regularly or randomly on both sides of its equilibrium position. This motion is called vibration. Generally, there are three types of vibration: longitudinal vibration, transverse vibration, and torsional vibration.