A thermal cycle has an efficiency equal to 45.0 % of that a Carnot engine that operates between the temperature extremes of the thermal cycle, a low of -70.0 degrees C and a high of 60.0 degrees C. If 9,000.0 J of energy flow into the system at the high temperature in one cycle, how much work is done in the cycle? Tab Your Answer: H Answer Type here to search DIAGG UGLE (O 260LED 4 Jill 3 4 units O 5 99+ O 5099 8 C83°F Mostly sunny la 11:13 8/8/2

A thermal cycle has an efficiency equal to 45.0 % of that a Carnot engine that operates between the temperature extremes of the thermal cycle, a low of -70.0 degrees C and a high of 60.0 degrees C. If 9,000.0 J of energy flow into the system at the high temperature in one cycle, how much work is done in the cycle? Tab Your Answer: H Answer Type here to search DIAGG UGLE (O 260LED 4 Jill 3 4 units O 5 99+ O 5099 8 C83°F Mostly sunny la 11:13 8/8/2

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

A power cycle operating at steady state receives energy by heat transfer at a rate QH= 500kW at TH = 1000K and rejects heat to a cold reservoir at a rate QL= 100kW at TL= 300K. Which ofthe following choices is true? a] reversible b] irreversible or c] impossible? Show your solution and justification.
. A rigid container (0.066 m3) is filled with an ideal gas (Cv = 2.5R) at 501K and 1.1 bar. Calculate the entropy changes asked in below. When an axial mixer is installed in a container and 15,000 J of work is applied to the gas under the insulation process, what is the entropy change of the gas?
Imagine that a high-efficiency heat engine could be created that operated betweeen the lot and high temperatures of -50.5 degrees celsius and 5550 degrees celsius. What would be the maximum efficiency of such an engine?
What is the entropy change of 15 g of steam at 100°C when it condenses to water at the same temperature? ΔS=ΔS= J/K Submit QuestionQuestion 45-g of water at 14°C is heated until it becomes vapor at 100°C. Calculate the change in entropy of the water in this process. ΔS=ΔS= J/K
Heat engine: efficiency 19% , work 1510J How much heat is given off to the cold reservoir ?? In J
A certain refrigerator has a coefficient of performance of 1.8. If this refrigerator absorbs 2.5x10^4 J of heat from the cold reservoir during each cyle, how much mechanical work is needed to run this refrigerator for each cyle? how much heat does the refrigerator dump into the hot reservoir during each cycle?
A carnot enine removes 1200J of heat from a high temperature source and dumps 450J to the atmosphere at18.0C What is the efficiency of the engine?What is the temperature of thehot reservoir?
During a cycle, a 42% efficient engine draws 5.20 x 10^3 j of energy from hot reservoir. a. how much enegy is released by the engine in the cold reservoir in one cycle? b. how much work does the egine do in onw cycle?
As shown in the figure below, 1.50 moles of H, gas is contained in the left side of a container. The two sides of the container are separated by a valve, and both sides are equal in volume. The right side of the container is initially evacuated. Valve Họ Vacuum (a) The valve is then opened, allowing H, gas to stream into the right side. What is the entropy change of the gas from before the valve opened to after it has filled the entire container? J/K (b) Does the temperature of the gas change? Assume the container is so large that the hydrogen behaves as an ideal gas. The temperature does not change. The temperature increases. The temperature decreases.
Suppose a heat engine design makes a square on a PV diagram, using a monatomic gas. The high pressure is 3P and low pressure is P. The high volume is 3V and low volume is V. What is the efficiency of the heat engine?
The attached files have 3 parts, i am gonna type the last 2 parts as wee: Calculate the change in entropy for the aluminium cup(in J/K) Calculate the total change in entropy for entire system (in J/K)
A heat engine can follow one of two cycles that expand and compress an ideal gas, as shown in the figure. Each cycle takes the same amount of heat to do the work. 3T. |2T To C.