a) The reactions at A and B, b) The displacement, v(x), and slope v'(x) You do not have to draw a shear and moment diagram.

Q: Determine the bending moment M in the beam at the point located L=4.75 m to the left of point C. The…

A:

Q: cantilever beam is under a concentrate load P (N), the beam has a length of L (m).   Write a…

A:

Q: the bar supported by a pin at a and a cable at b carries a load of 260 nat c. neglecting the weight…

A: We can answer up to 3 sub-parts so we will answer first 3 sub-parts. Please resubmit the question by…

Q: 2a q C 1 M=2qa² a B q=30kN/m A 1m 0.5m D P=20kN 1.5m E q=30kN/m 1m B

A: “Since you have posted multiple questions, we will provide the solution only to the first question…

Q: X B 1.2 What is the value of moment reaction M₂? P = 10 kN L=2.5 m

A:

Q: For the beam and loading shown, use the double-integration method to determine (a) the equation of…

A: Drae FBD

Q: 5. The rigid beam is supported by a pin at Cand a steel wire AB (Esteel = 200 GPa). a) If the wire…

A:

Q: Draw the free body diagram. 80 mg 60 20 650 mm 200 925 mm mm By

A: Solution:   The free body diagram of the inclined beam is shown below:

Q: 2) Solve the following problem: The beam AB is subjected to the uniformly distributed load shown in…

A: Given: The bending moment at D, MD = 3.5 kips The bending moment at E, ME = 4.5 kips

Q: Question 1 continued 4 of 5 b) Fig. 2 shows the shear force (KN) and bending moment (KNm) diagrams…

A: The shear force diagram of the loading on the beam is shown below.

Q: Fig. 1 shows a beam structure. It exhibits a cross section as per Fig. 2. 30 N/m 40 N A I = { [ I +…

A: Step 1: Step 2: Step 3: Step 4:

Q: For the steel beam used to the support the loads shown below: a) Draw normal and shear force diagram…

A:

Q: Problem 1. Use the differential equation method (either second, third or fourth order) to find a)…

A: given; lets take reaction force at A=RAlets take reaction force at B=RB

Bending Moment

In general, we can define the bending moment as the reaction induced when a certain amount of load or force is applied to an element which makes it bend.